Seattle Washington Building Expert Directory

Common Construction Contract Provisions: No-Damages-for-Delay Clause

March 16, 2017 — David Cook & Chadd Reynolds - Autry, Hanrahan, Hall & Cook, LLP Blog
In continuing our series on common contract provisions found in construction contracts, this post highlights no-damages-for-delay clauses. Parties to a contract – particularly a construction contract – may agree that the performance of the contract must occur within a set amount of time. When a party is delayed in performing a contract, it may incur additional costs due to the delay. In most circumstances, unless the parties agree otherwise, the delayed party would be entitled to an extension of time to perform the contract. But it may also seek to recover the additional costs resulting from the delay. A no-damages-for-delay clause attempts to prevent the delayed party from recovering those additional costs. In construction contracts, an upstream party, such as an owner or prime contractor, typically relies on a no-damages-for-delay clause when presented with a delay claim by a downstream party, such as a subcontractor. Reprinted courtesy of David Cook, Autry, Hanrahan, Hall & Cook, LLP and Chadd Reynolds, Autry, Hanrahan, Hall & Cook, LLP Mr. Cook may be contacted at cook@ahclaw.com Mr. Reynolds may be contacted at reynolds@ahclaw.com Read the court decision
Read the full story...
Reprinted courtesy of

Engineer at Flint Negligence Trial Details Government Water Errors

April 04, 2022 — Richard Korman & Jeff Yoders - Engineering News-Record
Warren Green, vice president and chief engineer of Lockwood, Andrews & Newnam, an engineering consultant to Flint, Mich. during its disastrous water crisis of 2014 and 2015, testified in federal court last week that city officials forged ahead to switch its source of drinking water without adequate water softening or testing after one municipal manager assured him that the more extensive testing would be done. Reprinted courtesy of Richard Korman, Engineering News-Record and Jeff Yoders, Engineering News-Record Mr. Korman may be contacted at kormanr@enr.com Mr. Yoders may be contacted at yodersj@enr.com Read the full story... Read the court decision
Read the full story...
Reprinted courtesy of

Affordable Housing, Military Contracts and Mars: 3D Printing Construction Potential Builds

September 05, 2022 — Adam J. Weaver & Lindsey Mitchell - Gravel2Gavel Construction & Real Estate Law Blog
The 3D printing construction market is likely on the cusp of a boom. This unique construction method boasts many advantages in comparison to traditional forms of construction. Projects can be completed more quickly and at a fraction of the cost, given fewer laborers are required and the materials used are much cheaper. Though market growth stalled during the COVID-19 pandemic, industry leaders expect 3D printing construction to experience exponential growth in the coming years. While 3D printing technology has risen in popularity and prominence in the past couple of decades, it is only recently that 3D printing companies have begun making strides in the construction industry. Critical to the construction process is the software that is used to create and model the planned structure. A software program turns a building’s blueprint into code that then dictates the movement of a 3D printer on the construction site. After a concrete-like mix is loaded into the printer, the printer begins to build the walls by laying one cylindrical layer of concrete at a time, in accordance with the blueprint. There is no one-size-fits-all approach in 3D printing construction: some companies print the core structure as well as the roof and floor of the structure, while others print only the core and shell and install those portions separately using traditional methods and materials. Reprinted courtesy of Adam J. Weaver, Pillsbury and Lindsey Mitchell, Pillsbury Mr. Weaver may be contacted at adam.weaver@pillsburylaw.com Read the court decision
Read the full story...
Reprinted courtesy of

Nevada Supreme Court to Decide Fate of Harmon Towers

June 28, 2013 — CDJ STAFF
The Nevada Supreme Court started hearings on Tuesday, June 4 over the fate of Harmon towers. MGM Resorts is hoping to obtain permission from the court to tear down the tower, which they claim could collapse should an earthquake strike Las Vegas. Perini Corp, the builder, wants the building to remain standing in order to support their claim that the building’s flaws are through design and not construction errors. KLAS quoted one of Perini’s lawyers claiming that MGM had pursued a media strategy to prejudice potential jurors against the contractor. “CityCenter hired Cedric and Bunting to place advertisements with the media to win the hearts and minds of the community and to convince the public pretrial that Perini was, quote, ‘scum of the earth.’” If the Supreme Court gives the go-ahead, demolition would begin soon. Still pending, is the $500 lawsuit over the allegations of construction defects. Read the court decision
Read the full story...
Reprinted courtesy of

Living Not So Large: The sprawl of television shows about very small houses

March 12, 2015 — S Jhoanna Robledo – Bloomberg
Vince and Sam are newlywed twentysomethings who’ve been bunking with family for a year. Finally, they’ve saved up enough to buy a palace to call their own. Well, sort of: They want to shrink their footprint and expenses by living in a custom-built, 204-square-foot standalone house in southern New Jersey. It has to have room for gym equipment—they’re fitness buffs—and a study for Sam, who’s in medical school. Even Vince’s adorably headbanded mom isn’t sure how it will all fit. When Vince and Sam first see their new digs under construction, tall and narrow like a top-heavy garage, Vince admits they’re “freaking out on the inside.” So goes a standard episode of Tiny House Nation, the first of a half-dozen miniaturized real estate shows that have recently premiered. “We discovered that for millennials, there was an overriding social trend of extreme downsizing, and we wanted to dig deep into that,” says Gena McCarthy, executive producer of the show, which began airing last year after the Biography Channel morphed into the youth-focused FYI network. Last summer’s first season averaged 257,000 viewers per week, according to Nielsen; this season’s average viewership is up 77 percent, to 465,000. Read the court decision
Read the full story...
Reprinted courtesy of S Jhoanna Robledo, Bloomberg

Proximity Trace Used to Monitor, Maintain Social Distancing on $1.9-Billion KCI Airport Project

September 07, 2020 — Jeff Yoders - Engineering News-Record
In order to maintain social distancing on site, steel erector National Steel City of Plymouth, Mich., is using the Proximity Trace wearable sensor from Triax Technologies on the $1.9-billion Kansas City International Airport (KCI) single-terminal reconstruction project. Jeff Yoders, Engineering News-Record Mr. Yoders may be contacted at yodersj@enr.com Read the full story... Read the court decision
Read the full story...
Reprinted courtesy of

Hold on Just One Second: Texas Clarifies Starting Point for Negligence Statute of Limitations

July 11, 2022 — Lian Skaf - The Subrogation Strategist
In construction or similar ongoing projects, problems often pop up. Sometimes they can pop up again and again. Making things even more complicated, one problem may affect another, seemingly new problem. When these construction problems result in property damage, timelines tend to overlap and determining when a statute of limitation begins to run for a particular claim can be difficult. Especially in states with short statute of limitations for tort claims like Texas, knowing when a statute begins to run is crucial for a subrogation professional. In Hussion St. Bldgs., LLC v. TRW Eng’rs, Inc., No. 14-20-00641-CV, 2022 Tex. App. LEXIS 2193, 2022 WL 1010313, the Court of Appeals of Texas provided clarity on when the two-year statute of limitations for tort claims begins to run. Reversing the judgment from the lower court, the appellate court denied summary judgment to the defendant, holding that, despite there being existing issues with the ongoing construction project, the negligence cause of action for Hussion Street Buildings, LLC (Hussion) did not begin to run more than two years prior to filing suit. Read the court decision
Read the full story...
Reprinted courtesy of Lian Skaf, White and Williams LLP
Mr. Skaf may be contacted at skafl@whiteandwilliams.com

Did New York Zero Tolerance Campaign Improve Jobsite Safety?

December 13, 2021 — Neil Flynn - Construction Executive
Construction work is one of the most dangerous jobs in America, accounting for 19% of all workplace deaths in 2019. In New York City, that number is almost 50% higher, with construction accidents accounting for a quarter of all workplace deaths. One of the most positive developments in this area, despite the presence of COVID-19, has been the recent implementation of the “Zero Tolerance” campaign by the New York City’s Department of Buildings. The goal of the DOB’s latest construction safety campaign was to reduce the number of building site injuries and fatalities by implementing a zero-tolerance standard. While it is too premature to measure the program’s efficiency, a preliminary analysis of the first three months’ results appear to be nothing short of impressive. Reprinted courtesy of Neil Flynn, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of
Mr. Flynn may be contacted at nf@plattalaw.com

SEATTLE WASHINGTON BUILDING EXPERT DIRECTORY AND CAPABILITIES