Fairfield Connecticut Building Expert Directory

Mass-Timber Furnished Apartments Fare Well in Fire Tests

August 24, 2017 — Nadine M. Post - Engineering News-Record
Advocates for a code change that would allow taller heavy-timber frames are buoyed by the good performance of mass-timber structures in the first U.S. fire tests on full-scale furnished apartments. Read the court decision
Read the full story...
Reprinted courtesy of Nadine M. Post
Ms. Post may be contacted at postn@enr.com

Mediating Contract Claims and Disputes at the ASBCA

December 20, 2021 — Brian Waagner - Construction Executive
The Contract Disputes Act establishes the formal process for resolving nearly all claims and disputes that arise under federal government contracts. It is the source of the requirement that contractors certify claims in excess of $100,000, the contracting officer’s final decision and the deadlines for bringing a dispute to the court of federal claims or an agency board of contract appeals. It is also the source of the federal government’s authority to use mediation and other forms of alternative dispute resolution. Here are six key factors contractors should know about mediating contract claims and disputes at the Armed Services Board of Contract Appeals (ASBCA). 1. The Parties Control the Parameters of ADR Proceedings Many commercial contracts and court rules require mediation of every dispute. There is no settlement meeting, mediation or any other type of mandatory ADR proceedings in cases brought to the ASBCA. The parties control the process, and they may adopt any approach to ADR that they believe will be effective. Mediation is nevertheless voluntary. Without the agreement of both parties, it won’t happen. Reprinted courtesy of Brian Waagner, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

E-Commerce Logistics Test Limits of Tilt-Up Construction

January 28, 2019 — Jeff Rubenstone - Engineering News-Record
While “fulfillment centers” and other e-commerce logistic facilities drive a hot market for the manufacturing sector, traditional construction methods such as tilt-up concrete panels are being pushed to ever-greater heights. At a recent project in Tulsa, Okla., contractor Clayco oversaw installation of tilt-up composite panels that reached 81 ft in height, using an unusual brace and a lot of careful pre-planning. Read the court decision
Read the full story...
Reprinted courtesy of Jeff Rubenstone, ENR
Mr. Rubenstone may be contacted at rubenstonej@enr.com

Maui Wildfire Cleanup Advances to Debris Removal Phase

February 05, 2024 — James Leggate - Engineering News-Record
Contractors hauled the first truckload of debris from homes destroyed by last year’s wildfires in Lahaina, Hawaii, on Jan. 16. The move marked the beginning of the second phase of debris removal efforts coordinated by federal, state and local officials. Reprinted courtesy of James Leggate, Engineering News-Record Mr. Leggate may be contacted at leggatej@enr.com Read the full story... Read the court decision
Read the full story...
Reprinted courtesy of

Recent Florida Legislative Changes Shorten Both Statute of Limitation ("SOL") and Statute of Repose ("SOR") for Construction Defect Claims

March 19, 2024 — Holly A. Rice - Saxe Doernberger & Vita, P.C.
The Florida Legislature and Governor DeSantis passed Senate Bill 360, effective April 13, 2023, which imposes significant changes to Florida’s statute of limitation (“SOL”) and statute of repose (“SOR”) periods prescribed in Florida Statute § 95.11. In short, the SOL and SOR periods will commence earlier and run earlier, which in effect shortens the time to bring a construction defect claim on both ends of the timeline.1 These changes will have positive impacts for general contractors who may save on insurance premiums with shorter completed operations tails. In other words, the timeframe within which contractors are at risk of being sued for construction-related errors is significantly reduced under the new version of the statute. Owners and developers, on the other hand, may feel that the increased pressure of uncovered construction defects necessitates the filing of lawsuits sooner than they might have otherwise filed. Collectively, all parties involved will certainly have to consider when and how to place their carriers on notice of claims or potential claims and, coupled with Florida’s sweeping changes to fee shifting statutes, insured parties may see more coverage denials which, in turn, could lead to more coverage actions.2 Read the court decision
Read the full story...
Reprinted courtesy of Holly A. Rice, Saxe Doernberger & Vita, P.C.
Ms. Rice may be contacted at HRice@sdvlaw.com

Microwave Transmission of Space-Based Solar Power: The Focus of New Attention

July 24, 2023 — Robert A. James & William E. Fork - Gravel2Gavel Construction & Real Estate Law Blog
Scientists have long proposed that solar electricity generation in space could be an integral component of the world’s carbon-free future. In the 1970s, a U.S. Navy experiment showed that it might be possible to capture solar power and wirelessly transmit it from outer space using microwave beams. Progress stalled after that early test—the models used were at such a massive scale that creating a real-world system felt like science fiction. Recently, amid growing concerns about power grid security and intensifying legislation around carbon emissions, renewed attention focused on a smaller, more lithe microwave transmission system. This time around, the military is not the only interested party. Scientists around the world are conducting similar research. As investors and governments stand at the edge of a fresh green power opportunity, we look at microwave power transmission and some of the projects in this emerging field. The basic premise of space-based solar power technology is simple enough: photovoltaic panels on a satellite in space convert the sun’s energy to electromagnetic waves at microwave frequencies. The satellite then beams the microwave energy to a receiver on Earth that transforms it into direct current. Until recently, this technique had been performed on the ground over short distances, but nobody had attempted to launch a solar panel into space. The status quo has shifted over the past few years as researchers have begun to send prototypes into orbit. In early 2023, CalTech was the first to report a breakthrough. Its model successfully beamed power from space back to their receiver atop a building in California. Reprinted courtesy of Robert A. James, Pillsbury and William E. Fork, Pillsbury Mr. James may be contacted at rob.james@pillsburylaw.com Mr. Fork may be contacted at william.fork@pillsburylaw.com Read the court decision
Read the full story...
Reprinted courtesy of

The EEOC Is Actively Targeting the Construction Industry

February 27, 2023 — Cameron S. Hill Sr. & Maia Fleischman, Construction Executive
Risks and potential liabilities in the construction industry are not new. Construction participants know the typical hot spots: Projects are delayed. Supply chain issues raise materials costs. Owners and general contractors dispute the effects of changes in the scope of work. Employees can become injured. Be aware that workplace conduct and practices are increasingly a priority and focus for governmental intervention, resulting in increased risk management attention on the construction industry. The Equal Employment Opportunity Commission (EEOC) is watching, and if you are not prepared, you could be liable for hundreds of thousands of dollars related to how your employees interact with each other. We recommend you immediately review your employment policies and procedures in addition to considering an update of your training practices. Reprinted courtesy of Cameron S. Hill Sr. and Maia Fleischman, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Mr. Hill may be contacted at chill@bakerdonelson.com Ms. Fleischman may be contacted at mfleischman@bakerdonelson.com Read the court decision
Read the full story...
Reprinted courtesy of

Building Codes Evolve With High Wind Events

November 14, 2018 — William L. Coulbourne - Construction Executive
Designs for wind loads have been in building codes for a long time. Prior to the creation of the International Building Code, the three primary legacy codes had wind load provisions but they mostly dealt with wind loads on the building frame and had little load information about the building components or the exterior cladding. Since Hurricane Andrew in 1992, building codes include more wind design information that comes from disaster investigations and wind engineering research conducted primarily at the university level. In 2000, the legacy building codes were replaced with the International Building Code (IBC). Residential buildings must comply with the International Residential Code (IRC). Both of these building code documents reference the engineering load standard, ASCE 7 Minimum Design Loads and Other Criteria for Buildings and Other Structures. This load standard has also been in existence for a long time; it now is revised every six years and the building codes revised every three years (IBC and IRC) reference ASCE 7 so the provisions in ASCE 7 become part of the building code requirements. Reprinted courtesy of William L. Coulbourne, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

FAIRFIELD CONNECTICUT BUILDING EXPERT DIRECTORY AND CAPABILITIES