Newark Trial Team Secures Affirmance of ‘No Cause’ Verdict for Nationwide Housing Manager & Developer
January 07, 2025 —
Lewis Brisbois NewsroomNewark, N.J. (December 30, 2024) - Newark Partner Afsha Noran and Managing Partner Colin Hackett recently obtained a ruling by a New Jersey Appellate Division panel affirming a unanimous "no cause" defense verdict obtained on behalf of a nationwide housing developer and manager.
In this case, the plaintiff and her two minor children brought suit against the firm's client. They appealed a unanimous no-cause jury verdict rendered in May 2023 that found the defendants not liable for mold exposure in their apartment. The plaintiffs argued that several trial errors, including improper jury instructions, a confusing verdict sheet, and prejudicial remarks by defense counsel led to an unjust result. However, the appellate court affirmed the trial court's decision, concluding that there was no miscarriage of justice and that the trial court properly exercised its discretion in handling the case.
Read the court decisionRead the full story...Reprinted courtesy of
Lewis Brisbois
10 Safety Tips for General Contractors
October 09, 2018 —
Eric Weisbrot – JW Surety BondsThe construction industry continues to grow each year, paving the way for general contractors to make a profitable, sustainable living when the job is done right. However, to do so effectively, safety standards need to be met with consistency and focus on each worksite. General
contractors who are licensed and bonded must take proactive steps to avoid potentially fatal injuries among their subcontractors and employees, even though this may be easier said than done. To create and maintain a safe worksite each and every time, general contractors should consider how to implement the following best practices and safety tips on the job.
1 – Know the Risks
The most crucial step toward maintaining a safe construction site is to first be aware of the risks involved. Each year, thousands of
construction workers experience injuries on the job, and some ultimately lose their life because of safety missteps at work. As a general contractor, it is your responsibility to know that construction risks run rampant given the nature of the work. Being tuned into the potential for falls, slips, and other common safety-related incidents is a necessary part of operating a safe worksite for you and your employees.
2 – Require Protective Gear
An often overlooked safety precaution on construction sites is the use of up-to-date and well-maintained protective gear. For many subcontractors and employees, it is easy to skip this necessary step in safeguarding themselves from potential safety issues. However, general contractors can take steps to make protective gear a requirement on the job. This may include mandating hardhats and steel-toed shoes, gloves, and eyewear when appropriate. All visitors and workers on a construction site should follow protective gear instructions to avoid unnecessary safety risks.
3 – Educate on Ladder Safety
According to the Bureau of Labor Statistics, ladder injuries account for a significant number of construction worker incidents each year, making up more than 200,000 accidents on average. Ladders have continuously ranked high on OSHA’s list of violations at construction sites because the prevalence of injuries is so high. General contractors can help thwart ladder-related injuries among workers by promoting ladder safety training, including reminders about the right ladder to use for each task. Workers should also be well aware of the importance of inspection before use, and they should always follow the three points of contact rule when going up or down a ladder.
4 – Recognize Equipment Pitfalls
Many construction workers experience injuries relating to equipment used on the job. This could be tied to getting on or off equipment, or loading and unloading materials from machinery. In any case, general contractors can encourage simple tactics to improve equipment safety measures. Paying close attention to secure footing while getting on or off a machine, having more than one person assist with loading and unloading, and ensuring everyone feels comfortable asking for help with these tasks reduces safety risks.
5 – Document Potential Hazards
A general contractor’s main responsibility is to manage the construction site efficiently from start to finish. Part of this duty is recognizing the possible issues on a worksite that may lead to accidents or injuries if not addressed at the beginning of a project. It is necessary to take the time to identify safety risks such as unstable working surfaces, dangerous trenches, or weather-related concerns that may impact the safety of subcontractors, suppliers, or other site visitors. Potential hazards should be documented and shared with site workers, and they should be updated as the project progresses.
6 – Maintain Equipment and Tools
Poorly maintained equipment and tools also cause issues on construction sites. The Infrastructure Health and Safety Association suggests that general contractors
remind workers to inspect tools, machines, handheld equipment, and vehicles before each use to ensure they are properly maintained. Additionally, understanding the maintenance standards for certain tools or equipment and following those guidelines is crucial to reducing injury on the job.
7 – Minimize Crowds
Crowded work areas can be a serious safety issue for general contractors, subcontractors, and vendors and suppliers on site. It is common for crowds to gather during the use of heavy equipment or when a significant task is being completed. However, general contractors should discourage crowd-forming for spectating purposes. This can be done by limiting the number of people allowed to be in an area when certain activities are taking place, and enforcing these rules at every possible opportunity.
8 – Hire Licensed Subcontractors
General contractors may have full- or part-time employees as part of their business model, or there may be a heavy presence of subcontractors not directly tied to the main business. In either case, it is essential to have faith in the capabilities of workers, including their willingness and commitment to follow safety standards. General contractors can help ensure each worker is more likely to take safety seriously when they hire licensed contractors who follow through with
licensing requirements as mandated by the state or city.
9 – Focus on Training
Even after vetting subcontractors and employees based on their licensing status, general contractors also need to ensure training and education are a priority. Several online and in-person courses focus on construction safety training which workers should be encouraged to attend. Safety
education programs from OSHA and other reputable sources are crucial to decreasing accidents on the job.
10 – Be Present
Finally, general contractors can only have an impact on the safety of the job site when they are purposefully present. It is common for some GCs to stop by a project when they are needed or to check on progress periodically. However, new safety hazards, lacking worker training, and other risks are not easily fixed when the general contractor is not consistently on site. Reducing the potential for falls, slips, trips, and fatalities on the job requires communication with workers, and that takes place most effectively when general contractors are in person.
Eric Weisbrot is the Chief Marketing Officer of JW Surety Bonds. With years of experience in the surety industry under several different roles within the company, he is also a contributing author to the surety bond blog.
Read the court decisionRead the full story...Reprinted courtesy of
Duke Energy Appeals N.C. Order to Excavate Nine Coal Ash Pits
April 17, 2019 —
Mary B. Powers - Engineering News-RecordDuke Energy Progress said April 11 it will appeal the North Carolina Dept. of Environmental Quality’s order issued earlier this month to excavate nine remaining large coal ash pits at six power plants in the state and move ash to lined landfills; the firm claims the new mandate at sites previously deemed low-risk will cost up to $5 billion to implement.
Read the court decisionRead the full story...Reprinted courtesy of
Mary B. Powers, ENRENR may be contacted at
ENR.com@bnpmedia.com
The Best Laid Plans: Contingency in a Construction Contract
September 13, 2021 —
Josh Levy, Katesha Long & Samantha Schacht - Construction ExecutiveThis article is the first of a three-part series on contingencies in construction contracts. This series will explain:
- what a construction contingency is;
- the two primary schools of thought regarding how a construction contingency fund should be used and managed; and
- construction contract drafting considerations for contingency clauses.
Armed with this information, owners and contractors will be better equipped to tackle the inevitable project surprises.
Life is full of surprises, some good and some not too good. Surprises during construction are seldom welcome events. However, experienced owners and contractors know to expect the unexpected and plan accordingly by including contingency funds in their budgets. For them, the question is not whether or not to include a contingency, but how much to set aside and how to structure and manage the fund.
Reprinted courtesy of
Josh Levy, Katesha Long & Samantha Schacht, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved.
Ms. Schacht may be contacted at samantha.schacht@huschblackwell.com
Ms. Long may be contacted at katesha.long@huschblackwell.com
Read the court decisionRead the full story...Reprinted courtesy of
A Glimpse Into Post-Judgment Collections and Perhaps the Near Future?
July 13, 2020 —
Garret Murai - California Construction Law BlogAccording to a recent study conducted by the Harvard University, the University of Chicago, and the University of Illinois, more than 100,000 small businesses (firms with fewer than 500 employees) representing 2% of small businesses in the America have closed their doors permanently due to the coronavirus. The next case, although about events occurring before COVID-19, provides a glimpse of what litigation may look like in the intervening months and years as companies struggle to keep their doors open.
The Wanke Case
Waterproofing company Wanke, Industrial, Commercial, Residential, Inc. sued a former employee, Scott Keck, and his competing company, WP Solutions, Inc., for trade secret misappropriation and obtained a judgment for $1,190,929.
At the time, general contractor AV Builder Corp. had hired WP Solutions as a waterproofing subcontractor on fire residential and commercial projects. In the face of the judgment obtained by Wanke, Keck declared bankruptcy and dissolved WP Solutions.
Read the court decisionRead the full story...Reprinted courtesy of
Garret Murai, Nomos LLPMr. Murai may be contacted at
gmurai@nomosllp.com
Feds Outline Workforce Rules for $39B in Chip Plant Funding
April 10, 2023 —
James Leggate - Engineering News-RecordSemiconductor chip producers must pay their construction workforce prevailing wages and will be “strongly encouraged” to use project labor agreements if they want a piece of the $39 billion available in federal funding to support fabrication plant construction, expansion or modernization projects, U.S. Commerce Secretary Gina Raimondo says.
Reprinted courtesy of
James Leggate, Engineering News-Record
Mr. Leggate may be contacted at leggatej@enr.com
Read the full story... Read the court decisionRead the full story...Reprinted courtesy of
Contract Terms Can Impact the Accrual Date For Florida’s Statute of Repose
October 19, 2017 —
William L. Doerler - White and Williams LLPWhen the validity of a construction defect claim depends on whether the claim is barred by the applicable state’s statute of repose, it is important to review the statute to identify when claims subject to the statute of repose accrue. In Busch v. Lennar Homes, LLC, 219 So.3d 93 (Fla. Ct. App. (5th Dist.) 2017), the Court of Appeals of Florida clarified the accrual date for the statute of repose in cases where the accrual date depends on a construction contract’s completion date. Pursuant to Busch, the date of full performance under the contract, not the building’s purchase closing date, is the date on which claims accrue.
In Busch, Timothy Busch (Busch), pursuant to a Purchase and Sale Agreement, contracted to have Lennar Homes build him a house. Nearly ten years after closing on the home, Busch served Lennar Homes with a notice of construction defects, as required by Florida’s right-to-repair act. Shortly thereafter, but more than 10 years after the home’s closing date, Busch filed suit against Lennar Homes, alleging that there were multiple construction defects associated with the home. Lennar Homes, relying on Florida’s statute of repose, Fla. Stat. § 95.11(3)(c), filed a motion to dismiss Busch’s complaint.
Read the court decisionRead the full story...Reprinted courtesy of
William L. Doerler, White and Williams LLPMr. Doerler may be contacted at
doerlerw@whiteandwilliams.com
Confidence Among U.S. Homebuilders Little Changed in January
January 28, 2015 —
Bloomberg News(Bloomberg) -- Confidence among U.S. homebuilders hovered in January close to a nine-year high, indicating the residential real estate market is poised to expand this year.
While the National Association of Home Builders/Wells Fargo builder sentiment gauge fell to 57 this month from 58 in December, readings greater than 50 mean more respondents report good market conditions, according to figures issued from the Washington-based group Tuesday. The median forecast in a Bloomberg survey called for 58.
Read the court decisionRead the full story...Reprinted courtesy of
Bloomberg News
