Fairfield Connecticut Building Expert Directory

Beam Cracks Cause Closure of San Francisco’s New $2B Transit Center

October 09, 2018 — David Suggs – Bert L. Howe & Associates, Inc.
After two billion dollars and two decades, San Francisco’s newest transportation hub opened on August 11th of this year only to be closed a month later, on September 25th, after a cracked beam was discovered, according to The Real Deal. Later, workers found an additional, though smaller, crack in another beam parallel to the first. The Real Deal described the crack in the first beam: “The Transbay Joint Powers Authority (TJPA) – which built and now operates the center – said the tear was 2.5 feet long and 4.5 inches deep on a 60-foot beam that holds a 5.4-acre rooftop park above a bus deck.” Steel supports are now being installed to reduce the pressure on the beams. While officials have not discovered the cause of the problem, The Real Deal reported several possibilities, including “fabrication problems, installation error, too much weight, or an issue in the initial design.” Read the court decision
Read the full story...
Reprinted courtesy of

ADA Compliance Checklist For Your Business

February 06, 2019 — Danielle Carter - Bremer Whyte Brown & O'Meara LLP
The Americans with Disabilities Act (ADA) protects people with disabilities against discrimination in three important settings: 1. Employment (ADA Title I) 2. Government Services and Public Transportation (ADA Title II) 3. Commercial Facilities and Places of Public Accommodation (ADA Title III) Since business owners typically act as both employers and facility managers, they must pay careful attention to Title I and Title III of the ADA. A business owner’s ADA compliance checklist should include the following: 1. ADA Compliance Audit for Structural Accessibility. The ADA and its accompanying regulations set forth detailed legal standards and requirements for accessible design, which specify, for example, the minimum width of doors to conference rooms, the maximum height of public drinking fountains, and the maximum thickness of hallway carpeting. Many older buildings were built without features that accommodate people with disabilities, such that the ADA may require improvements to be made to existing facilities. Read the court decision
Read the full story...
Reprinted courtesy of Danielle Carter, Bremer Whyte Brown & O'Meara LLP
Ms. Carter may be contacted at info@bremerwhyte.com

BIM Meets Reality on the Construction Site

September 25, 2018 — Aarni Heiskanen - AEC Business
BIM models are mostly used by foremen on construction sites. But what if they could be made available for workers at the press of a button? This question was what the Finnish government-funded KIRA pilot project set out to answer. As a by-product, the project also produced augmented reality (AR) solutions for construction sites. The research project was called ”Digitalization of a construction project based on role and location information” (RoPa). It was conducted by construction company Fira and engineering consultancy Sweco. Read the court decision
Read the full story...
Reprinted courtesy of Aarni Heiskanen, AEC Business
Mr. Heiskanen may be contacted at aec-business@aepartners.fi

When Is a Project Delay Material and Actionable?

January 11, 2022 — Rick Erickson - Snell & Wilmer Real Estate Litigation Blog
Welcome to 2022! This year, the construction industry will undoubtedly reflect on the last two years as unprecedented times plagued by construction project delays. The COVID-19 pandemic contributed to suspension of work and closure of construction projects worldwide in 2020. The end of 2021 brought additional delays caused by an inexplicable clog in the supply chain of construction materials. The combined impact of these events on project milestones and completion deadlines led our clients to ask, with unusual and particular urgency, who is liable for such delays and how do contracting parties lessen the consequences from such unexpected and uncontrollable delays. Granted that project delays are nothing new or unusual. They were common enough before inflation caused shipping complications and pandemic decimated the construction labor force. All delays, whatever the source, variably cause loss to all players on a construction project. But not all delays matter when it comes to claims and remedies available to the contracting parties in dispute resolution, where the determinative focus is on material delays impacting the entire project and on delays the claimant can credibly prove. Most, if not all, jurisdictions interpret actionable delays from the contract documents for the project. The contract is definitely where you should start before pursuing any delay remedies. Delay remedies may be a time extension only, or a time extension plus your additional general conditions. Some delay remedies may be barred by the contract’s express terms and may be enforced adversely by the courts when such contract terms are indisputable. See Quinn Constr. v. Skanska USA Bldg., Inc., 730 F. Supp. 2d 401, 411 (D.C. Pa. 2010) (enforcing the subcontractor’s contractual waiver of claims for delay and disruption damages). On the other hand, delay damages that are expressly allowed by the contract—like overtime necessitated by the delays—are usually actionable and recoverable. Id. However, not only the contract terms, but applicable law, may affect the outcome. Read the court decision
Read the full story...
Reprinted courtesy of Rick Erickson, Snell & Wilmer
Mr. Erickson may be contacted at rerickson@swlaw.com

Home Construction Thriving in Lubbock

December 30, 2013 — CDJ STAFF
The 2013 numbers for home construction aren’t ready yet, but the January through November numbers for Lubbock, Texas show a 42% increase over the number of construction permits issued for single-family homes in the first 11 months of 2012. The number look even better compared to 2011’s totals, according to KFYO. Read the court decision
Read the full story...
Reprinted courtesy of

White and Williams Ranked in Top Tiers of "Best Law Firms"

November 08, 2021 — White and Williams LLP
White and Williams has achieved national recognition from U.S. News and World Report as a "Best Law Firm" in the practice areas of Insurance Law, Bankruptcy and Creditor Debtor Rights / Insolvency and Reorganization Law and Media Law. Our Boston, Delaware, New Jersey, New York City and Philadelphia offices have also been recognized in their respective metropolitan regions in several practice areas. National Tier 1 Insurance Law National Tier 2 Bankruptcy and Creditor Debtor Rights / Insolvency and Reorganization Law National Tier 3 Media Law Metropolitan Tier 1 Boston Insurance Law Litigation - Insurance Read the court decision
Read the full story...
Reprinted courtesy of White and Williams LLP

Acquisition, Development, and Construction Lending Conditions Ease

May 21, 2014 — Beverley BevenFlorez-CDJ STAFF
According to the National Association of Home Builders’ (NAHB) Eye on Housing, “[b]uilders and developers continue to report easing credit conditions for acquisition, development, and construction (AD&C) loans according to NAHB’s survey on AD&C financing.” Eye on Housing stated that while “commercial banks remain the primary source of credit for AD&C by a wide margin, private individual investors have emerged as a viable alternative, especially for A&D loans.” Read the court decision
Read the full story...
Reprinted courtesy of

ACEC Research Institute Releases New Engineering Industry Forecast

December 13, 2021 — American Council of Engineering Companies
Washington, DC, Dec. 09, 2021 (GLOBE NEWSWIRE) -- Today, the ACEC Research Institute released two new reports on the Engineering and Design Services industry: the 2021 Economic Assessment of the Engineering and Design Services Industry and a new Engineering Business Sentiment report for Q4 2021. The data shows the industry has rebounded from project postponements due to COVID, though firms identify a tight labor market and lack of qualified workers as continued barriers to growth across public and private markets. This is the second annual release of the Engineering and Design Services industry assessment, which tracks the industry's economic contributions, analyzes key economic drivers, and forecasts industry growth. Snapshot of the Engineering and Design Services Industry: 1.5 million direct full- and part-time jobs $97,300 average yearly wages $338 billion in industry sales $198 billion direct economic contribution $105 billion collected in total federal, state & local tax Both reports, the 2021 Economic Assessment of the Engineering and Design Services Industry and the Engineering Business Sentiment report for Q4 2021, are available for download by clicking here. ### The ACEC Research Institute is the research arm of the American Council of Engineering Companies – the business association of the nation's engineering industry. The ACEC Research Institute's mission is to deliver knowledge and business strategies that guide and elevate the engineering industry and to be the leading source of knowledge and thought leadership for creating a more sustainable, safe, secure and technically advanced built environment. For more information, go to www.acecresearchinstitute.org. Read the court decision
Read the full story...
Reprinted courtesy of

FAIRFIELD CONNECTICUT BUILDING EXPERT DIRECTORY AND CAPABILITIES