Fairfield Connecticut Building Expert Directory

Is Equipment Installed as Part of Building Renovations a “Product” or “Construction”?

April 10, 2019 — Joshua Lane - Ahlers Cressman & Sleight PLLC
A statute of repose terminates the right to file a claim after a specified time even if the injury has not yet occurred.[1] The construction statute of repose bars claims arising from construction, design, or engineering of any improvement upon real property that has not accrued within six years after substantial completion.[2] But what constitutes an “improvement upon real property” necessitating application of the six-year bar, and when does the bar NOT apply? The Washington Court of Appeals recently addressed these questions in Puente v. Resources Conservation Co., Int’l.[3] There, the personal representative of the estate of Javier Puente sued several parties after Mr. Puente, an employee of a manufacturer, suffered fatal boric acid burns in 2012 while performing maintenance on a pump system installed at the manufacturer’s facility in 2002. The estate alleged claims of negligence and liability under the Washington Product Liability Act (WPLA).[4] The trial court granted summary judgment to defendants, concluding that the installed pump system constituted a statutory “improvement upon real property” and the six-year statute of repose applied. The estate appealed. Read the court decision
Read the full story...
Reprinted courtesy of Joshua Lane, Ahlers Cressman & Sleight PLLC
Mr. Lane may be contacted at joshua.lane@acslawyers.com

Building Permits Up in USA Is a Good Sign

November 27, 2013 — CDJ STAFF
The number of building permits for houses issued throughout the country hasn’t been higher since June 2008, a sign that the home building industry continues to recover, even in the face of higher interest rates. “These reports are unequivocally in line with our view that the housing recovery remains will on track, as the lack of supply will continue to support both construction activity and house prices,” according to Harm Bandholz, the chief U.S. economist for UniCredit Research. Building permits were up 13.9% over last year and beat projections of 930,000 permits on an annual rate. The current annual rate for building permits is 1.03 million. Permits for multifamily homes were up 20.1% in September and 15.3% in October. Single-family homes were up 0.8% in October, but had fallen 1.9% the month before. Read the court decision
Read the full story...
Reprinted courtesy of

Product Liability Alert: Evidence of Apportionment of Fault Admissible in Strict Products Liability Action

March 26, 2014 — R. Bryan Martin and Kristian B. Moriarty - Haight Brown & Bonesteel LLP
In Romine v. Johnson Controls, Inc. (No. B239761, filed March 17, 2014), the California Court of Appeal for the Second District held that a trial court must permit a defendant, in a products liability action, to present evidence of apportionment of fault among settling and non-settling entities. The case involved an automobile collision in which the plaintiff was struck from behind, causing the driver’s seat to recline and propel plaintiff into the back seat where she struck her head. Plaintiff was left quadriplegic as a result. Plaintiff brought suit against the driver who caused the accident, the Nissan entities who manufactured the car plaintiff was driving, Johnson Controls, Inc. (“Johnson”), Ikeda Engineering Corporation (“Ikeda”), Vintec Co. (“Vintec”), and Autoliv ASP, Inc., who designed and manufactured the driver’s seat of the vehicle plaintiff was driving, and against Faurecia Automotive Seating, Inc. who manufactured the recliner mechanism of plaintiff’s vehicle’s front seat. Ikeda participated in the design of the driver’s seat and Vintec manufactured the driver’s seat. Johnson manufactured the seat belt for the driver’s seat of plaintiff’s vehicle in accordance with Nissan’s design. Prior to trial, plaintiff settled with the defendant driver, the Nissan defendants, the Autoliv defendants, and Faurecia Automotive Seating, Inc. Plaintiff elected to proceed to trial solely on a cause of action for strict products liability against Ikeda and Vintec. Pursuant to a stipulation, Johnson agreed it would be legally responsible for damages awarded to plaintiff at trial based upon the actions of Vintec or Ikeda. At trial, the court precluded Vintec and Ikeda from offering evidence that: (1) plaintiff would not have been injured if her vehicle’s seat belt was designed in a different manner by Nissan; (2) Nissan chose the manufacturer of the recliner mechanism and required defendants to use that manufacturer and that part in the seat; and (3) The other defendants had already reached settlements with plaintiff. Reprinted courtesy of R. Bryan Martin, Haight Brown & Bonesteel LLP and Kristian B. Moriarty, Haight Brown & Bonesteel LLP Mr. Martin may be contacted at bmartin@hbblaw.com; Ms. Moriarty may be contacted at kmoriarty@hbblaw.com Read the court decision
Read the full story...
Reprinted courtesy of

One World Trade Center Tallest Building in US

November 13, 2013 — CDJ STAFF
It’s official! The tallest building in the United States is in New York. For forty years, the tallest building in the United States has been the Willis Tower in Chicago (better known by its former name, the Sears Tower). Now, the Council on Tall Buildings and Urban Habitat has decreed that One World Trade Center edges it out with its 1,776 feet of height, surpassing the Willis by 325 feet. There is a caveat. The antennas on the top of the Willis building aren’t counted in. The mast on the top of One World Trade Center is, and it adds 441 feet to the height of the building. If the mast weren’t counted, One World Trade Center would be 116 feet shorter than the building in Chicago. Read the court decision
Read the full story...
Reprinted courtesy of

Town Concerned Over Sinkhole at Condo Complex

September 24, 2013 — CDJ STAFF
Despite the assurances of their engineering firm, the township of Old Bridge, New Jersey has yet to release the performance bond to the construction of Plaza Grande, a condominium complex for residents over 55. One resident summarized the problem for the Suburban, a newspaper for towns in the area. “Our major concern is a sinkhole near Building 4 that has come back several times.” D.R. Horton, the developer on the project, has dug out the sinkhole, then backfilled and compacted it. However , one member of the Old Bridge Township Council said that she noticed that the area was beginning to sink again. The council member, Mary Sohor, said that Horton “should’ve dug a little deeper and did a little more.” D.R. Horton said that the issues do not affect the safety of the residents and attribute them to seasonal wear and tear. Read the court decision
Read the full story...
Reprinted courtesy of

The Difference Between Routine Document Destruction and Spoliation

October 18, 2021 — Steven A. Neeley - Construction Executive
In today’s world, there is a tendency to believe that everything must be preserved forever. The common belief is that documents, emails, text messages, etc. cannot be deleted because doing so may be viewed as spoliation (i.e., intentionally destroying relevant evidence). A party guilty of spoliation can be sanctioned, which can include an adverse inference that the lost information would have helped the other side. But that does not mean that contractors have to preserve every conceivable piece of information or data under all circumstances. There are key differences between routine document destruction (when done before receiving notice of potential claims or litigation) and spoliation. The Armed Services Board of Contract Appeals decision in Appeal of Sungjee Constr. Co., Ltd., ASBCA Nos. 62002 and 62170 (Mar. 23, 2021) provides a good reminder. There, Sungjee challenged its default termination under a construction contract at Osan Air Base in South Korea. Sungjee argued that the government denied it access to the site for 352 days (out of a 450-day performance period) by refusing to issue passes that were needed to access the base. The government argued that it had issued the passes, but it could not produce them to Sungjee in discovery because they had been destroyed as part of a routine document destruction policy. The base security force issued hard copy passes and entered the information in a biometric system. The government was able to produce the biometric system data but not the hard copy passes because they were destroyed each year. Sungjee argued the government was guilty of spoliation and moved for sanctions. It asked the Board to draw an adverse inference that the passes would have shown that the government had not issued proper passes on a timely basis, which delayed Sungjee’s performance. The Board denied Sungjee’s motion for several reasons. Reprinted courtesy of Steven A. Neeley, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of
Mr. Neeley may be contacted at steve.neeley@huschblackwell.com

Construction Defect Dispute Governed by Contract Disputes Act not yet Suited to being a "Suit"

June 25, 2019 — William S. Bennett - Saxe Doernberger & Vita, P.C.
The Southern District of California recently held that a series of demands for a general contractor to investigate and repair several construction defects at a U.S. Army facility did not constitute a “suit” within the meaning of the general contractor’s commercial general liability (“CGL”) policy. In Harper Construction Co., Inc. v. Nat’l Union Fire Ins. Co. of Pittsburgh, Pa., the U.S. Government hired Harper Construction Company (“Harper”) to construct a U.S. Army training facility for the Patriot Missile System in Fort Sill, Oklahoma. No. 18-cv-00471-BAS-NLS (S.D. Cal. Mar. 28, 2019). During the project, Harper hired Harper Mechanical Contractors (“Harper Mechanical”), an independent company, as a subcontractor “to perform demolition, grading, and other work at the Project.” After Harper completed the project, the government informed Harper of property damage at the project, “including, but not limited to, gypsum wallboard cracks and binding doors.” Harper attempted to repair the issues, but the problems continued. The issues were apparently the result of Harper Mechanical’s grading work. Subsequently, the government sent two letters requesting an investigation and asking Harper to “propose a plan to correct the issues.” As Harper undertook an investigation spanning multiple years, the government became increasingly frustrated with the delays. The government threatened to initiate “formal administrative recourse” and to demolish the project, forcing Harper to re-build from the ground up. It also sent Harper another letter requesting Harper submit a formal proposal to correct the issues. Read the court decision
Read the full story...
Reprinted courtesy of William S. Bennett, Saxe Doernberger & Vita, P.C.
Mr. Bennett may be contacted at wsb@sdvlaw.com

Wilke Fleury ranked in Best Lawyers’ Best Law Firms!!

December 03, 2024 — Wilke Fleury LLP
Wilke Fleury is pleased to announce its inclusion in the 2025 edition of ‘Best Law Firms’ ranked by Best Lawyers! Firms included in the 2025 “Best Law Firms” list are recognized for professional excellence with persistently impressive ratings from clients and peers. Achieving a tiered ranking signals a unique combination of quality law practice and breadth of legal expertise. Read the court decision
Read the full story...
Reprinted courtesy of Wilke Fleury LLP

FAIRFIELD CONNECTICUT BUILDING EXPERT DIRECTORY AND CAPABILITIES