Defining Catastrophic Injury Claims
December 16, 2019 —
Bremer Whyte Brown & O'Meara LLPHow do we define circumstances and injuries that go beyond a typical claim and severely impact a person’s life? How do we characterize the types of claims where an individual’s enjoyment of life is affected in an extraordinary manner? Typically, attorneys refer to these types of cases as “catastrophic injury” claims. These are the type of personal injury claims where the health of an individual has been so seriously impacted that their life has been irreparably altered. Defining these claims legally is somewhat murky and case law has done little to provide attorneys with a specific definition of the term. However, a recent Workers Compensation Appeals Board ruling attempted to list factors in order to establish a catastrophic injury claim. These include:
- An intensity and seriousness of treatment received for an injury;
- The ultimate outcome when a person’s physical injury is permanent and stationary;
- Whether the severity of the physical injury impacts the person’s ability to perform daily activities;
- Whether the physical injury is closely analogous to one of the injuries specified in various statutes, including loss of a limb, paralysis, severe burns, or a severe head injury; and
- If the physical injury is incurable or progressive. Wilson v. State of California CAL Fire (5/10/19) 2019 Cal.Wrk.Comp. LEXIS 29.
Read the court decisionRead the full story...Reprinted courtesy of
Bremer Whyte Brown & O'Meara LLP
Delaware District Court Finds CGL Insurer Owes Condo Builder a Duty to Defend Faulty Workmanship Claims — Based on the Subcontractor Exception to the Your Work Exclusion
October 04, 2021 —
Anthony L. Miscioscia & Laura Rossi - White and WilliamsOn September 7, 2021, in one of the few decisions addressing the scope of coverage for faulty workmanship under Delaware law, the Delaware District Court denied an insurer’s motion seeking a declaration that it neither needed to defend nor indemnify an insured-builder under a commercial general liability policy.
In this declaratory judgment action, Pennsylvania National Mutual Casualty Insurance Company v. Zonko Builders, the insurer argued that the ongoing underlying action failed to properly plead an “occurrence” in a case alleging damages to a condominium caused by faulty workmanship involving subcontractors.* Zonko Builders (Zonko) served as the general contractor, supervising subcontractors. The Condominium Association sued Zonko for damages allegedly resulting from design and construction deficiencies. The motion was opposed by the Condominium Association, which cross-moved for partial judgment on the pleadings.
In AE-Newark Associates, L.P. v. CNA Insurance Companies, 2001 Del. Super. LEXIS 370 (Del. Super. Ct. Oct. 2, 2001), the Delaware Superior Court found that an insured was entitled to coverage for damages arising from a faulty roof system installed by a subcontractor on behalf of the insured general contractor.
Reprinted courtesy of
Anthony L. Miscioscia, White and Williams and
Laura Rossi, White and Williams
Mr. Miscioscia may be contacted at misciosciaa@whiteandwilliams.com
Ms. Rossi may be contacted at rossil@whiteandwilliams.com
Read the court decisionRead the full story...Reprinted courtesy of
Construction Defect Journal Marks First Anniversary
January 06, 2012 —
CDJ STAFFNovember 2011 marked the first anniversary of the Construction Defect Journal. During the first year our staff and contributors in the insurance and legal communities have compiled several hundred articles of interest to the construction defect and claims community.
Each of these articles are maintained in the CDJ archives, and are accessible at http://www.constructiondefectjournal.com/archives.html. Each story in the archives is listed in the order it was posted to the archives. Each story in the archives opens up in its own page, so you can easily locate topics and articles of interest.
If you’re new to Construction Defect Journal, or just want peruse past articles, please take a moment to visit the CDJ Archives page. Also please feel encouraged to submit your firm’s articles or legal publications of interest to the CD community at http://www.constructiondefectjournal.com/submitStory.html.
Read the court decisionRead the full story...Reprinted courtesy of
Want to Use Drones in Your Construction Project? FAA Has Just Made It Easier.
March 01, 2017 —
Masaki J. Yamada – Ahlers & Cressman PLLCThe new Part 107 FAA Rules took effect on Monday, August 29, 2016. Unlike the previous requirements for flying a drone commercially, the new rules are much more simplistic and permissive of a broad amount of commercial drone usage.
The following is the basic knowledge you need to legally use a drone on your future projects. To fly a drone commercially, there are now four major requirements:
- You must be at least sixteen years old;
- You must register your drone online;
- You must pass an aviation knowledge test administered at an FAA-approved testing center; and
- You must pass review by the Transportation Security Administration.
Read the court decisionRead the full story...Reprinted courtesy of
Masaki J. Yamada, Ahlers & Cressman PLLCMr. Yamada may be contacted at
myamada@ac-lawyers.com
Commerce City Enacts Reform to Increase For-Sale Multifamily Housing
August 19, 2015 —
David M. McLain – Colorado Construction LigitationMany cities in Denver’s metropolitan areas are experiencing tremendous growth. For more than a year, Colorado has been reported to be in a building boom. However even with the noticeable expansion, some areas still suffer from a lack of housing options specific to multifamily developments. Sean Ford, Mayor of Commerce City, stated that “[the city] has not approved a new condominium or multi-family project since 2008.”[1] Those of us in the construction industry attribute this shortage, at least in part, to construction defect litigation, which is often drawn-out, complicated, and very costly to builders.
Predicting that light rail service will intensify the need for owner-occupied units among Commerce City residents, the city council enacted legislation to address this scarcity. Ordinance No. 2060 which took effect August 1, 2015 provides “reasonable steps to encourage prompt and voluntary correction of construction defects … in order to enhance the health and safety of residents of Commerce City.”
The ordinance requires a homeowner who discovers a defect to provide written notice via certified mail or personal delivery to the responsible builder, contractor, engineer, or design professional. The notice may include requests for relevant construction documentation, maintenance recommendations, and warranty information. The builder must acknowledge receipt of notice and provide requested documents within 14 days.
Read the court decisionRead the full story...Reprinted courtesy of
David M. McLain, Higgins, Hopkins, McLain & Roswell, LLCMr. McLain may be contacted at
mclain@hhmrlaw.com
Amazon Urged to Review Emergency Plans in Wake of Deadly Tornado
June 20, 2022 —
Spencer Soper - BloombergAmazon.com Inc. should better prepare workers for extreme weather events, according to federal regulators who investigated a deadly tornado strike on a company warehouse in Edwardsville, Illinois.
The storm ripped through the facility in December, killing six workers and injuring several others, prompting the Occupational Safety and Health Administration to launch a probe. At the time, Amazon said the facility complied with all construction regulations and that proper safety procedures were followed when the tornado struck. But several workers told Bloomberg that training for such events was minimal and mostly entailed pointing out emergency exits and assembly points.
An OSHA report released on Tuesday echoed those concerns. The agency said a bullhorn that was supposed to be used to tell workers to take cover was locked up in a cage and inaccessible. In interviews with investigators, some employees couldn’t recall ever participating in emergency drills and said they mistakenly took shelter in a bathroom on the south side of the building rather than in designated restrooms on the north side.
Read the court decisionRead the full story...Reprinted courtesy of
Spencer Soper, Bloomberg
7 Areas where Technology is Shifting the Construction Business
November 21, 2018 —
Eric Weisbrot – JW Surety BondsThe digital transformation of the last two decades has taken hold of the business environment in a powerful way. Companies in nearly all sectors are experiencing a significant shift in the way business is done, with a heavy focus on improved productivity, increase profitability, and enhanced product and service offerings. The construction industry has been historically slow to update its processes and business models in-line with other industries, but technology is currently making its long-awaited appearance in the sector. Construction professionals can embrace these new solutions to run more efficient businesses and keep a closer eye on profitability by reducing
common costs over time.
These are the seven major areas where technology is changing construction.
1 - Business Management
One of the most apparent shifts taking place in the construction industry thanks to technology is the advancement of business processes and systems behind the scenes. Construction managers and job site owners have countless
digital tools at their fingertips to help with managing all aspects of the business. This includes more efficient ways to manage material use and equipment inventory, logging subcontractor hours and pay, and maintaining reporting requirements from regulatory perspectives. Many software solutions integrate with older, legacy systems, making this change an easy one for construction businesses across the board.
2 – Jobsite Productivity
Another area of transformation in construction is productivity on each job site. Technology has offered job owners and general contractors more efficient methods to keep track of project timelines as well as subcontractor progress from start to finish. The technology advancements in this arena come in the form of wearable devices that track work performed, as well as mobile devices that help keep the often mundane tasks necessary for a project’s success up to date and completed on time.
3 – Worker Safety
Although wearables are being utilized in several different ways in the construction business, these devices are making a significant difference in the safety of workers. From smart helmets to digitally enhanced eyewear, workers are alerted to potential hazards on the job that they otherwise could not identify. Similarly, augmented and virtual reality solutions are being used to train workers before they arrive at a job, preparing them for safety concerns well in advance. Even though most licensed and
bonded construction workers have appropriate training throughout their careers, the addition of these resources has the ability to further reduce the risks often associated with construction work.
4 – Surveying and Monitoring
Unmanned aerial vehicles, also known as
drones, are being used throughout construction. These digital tools are equipped with cameras to offer a bird’s eye view of a construction site to help with surveying and identifying potential hazards for workers. Drones also help with inspections throughout a project’s progression, offering some reduction in cost and improving efficiencies.
5 – Improved Materials
Technology is also playing a role in the materials used on job sites. The addition of 3D printing has proven beneficial for construction companies, as concrete composites, plastics, and other materials are being printed and used to create structures on-site. This offers a more cost-effective and accurate way to complete a project.
6 – Self-operating Equipment
Some technology firms are making waves in the construction industry because they are currently developing and implementing
autonomous equipment solutions. Heavy machinery, like excavators, bricklayers, and bulldozers, are already being used on construction sites to help ease the burden of the labor shortage in the industry. While these machines are not yet mainstream, the benefits they offer mean they are likely to become a staple in construction in the years to come.
7 – Big Data
Finally, technology is shifting the construction business by way of big data analytics. With the detailed information from new software solutions, wearable tech, and drones, construction site managers have more data than they have ever had. This influx of information offers a way to analyze job site progress, budgets, timelines, and efficiency for companies large and small.
Author:
Eric Weisbrot is the Chief Marketing Officer of
JW Surety Bonds. With years of experience in the surety industry under several different roles within the company, he is also a contributing author to the surety bond blog.
Read the court decisionRead the full story...Reprinted courtesy of
For Smart Home Technology, the Contract Is Key
June 07, 2021 —
James W. McPhillips & Rachel Newell - Gravel2Gavel Construction & Real Estate Law BlogIn our
previous post we discussed the importance of conducting a thorough due diligence and procurement process with smart technology providers. Next up? The contract.
The price of a procured product is always important, but equally important are other contractual terms that reflect the commercial agreement. Ultimately, the contract should answer the fundamental question of “What are you buying?” The product itself is not the only feature being purchased. A customer is also buying certainty, service performance, risk mitigation, flexibility, security, compliance, and other similar “intangible” items of value.
The Price of Certainty
As part of the price, the purchaser of smart technology is also buying certainty. What do we mean by that?
Reprinted courtesy of
James W. McPhillips, Pillsbury and
Rachel Newell, Pillsbury
Mr. McPhillips may be contacted at james.mcphillips@pillsburylaw.com
Ms. Newell may be contacted at rachel.newell@pillsburylaw.com
Read the court decisionRead the full story...Reprinted courtesy of
