10 Safety Tips for General Contractors
October 09, 2018 —
Eric Weisbrot – JW Surety BondsThe construction industry continues to grow each year, paving the way for general contractors to make a profitable, sustainable living when the job is done right. However, to do so effectively, safety standards need to be met with consistency and focus on each worksite. General
contractors who are licensed and bonded must take proactive steps to avoid potentially fatal injuries among their subcontractors and employees, even though this may be easier said than done. To create and maintain a safe worksite each and every time, general contractors should consider how to implement the following best practices and safety tips on the job.
1 – Know the Risks
The most crucial step toward maintaining a safe construction site is to first be aware of the risks involved. Each year, thousands of
construction workers experience injuries on the job, and some ultimately lose their life because of safety missteps at work. As a general contractor, it is your responsibility to know that construction risks run rampant given the nature of the work. Being tuned into the potential for falls, slips, and other common safety-related incidents is a necessary part of operating a safe worksite for you and your employees.
2 – Require Protective Gear
An often overlooked safety precaution on construction sites is the use of up-to-date and well-maintained protective gear. For many subcontractors and employees, it is easy to skip this necessary step in safeguarding themselves from potential safety issues. However, general contractors can take steps to make protective gear a requirement on the job. This may include mandating hardhats and steel-toed shoes, gloves, and eyewear when appropriate. All visitors and workers on a construction site should follow protective gear instructions to avoid unnecessary safety risks.
3 – Educate on Ladder Safety
According to the Bureau of Labor Statistics, ladder injuries account for a significant number of construction worker incidents each year, making up more than 200,000 accidents on average. Ladders have continuously ranked high on OSHA’s list of violations at construction sites because the prevalence of injuries is so high. General contractors can help thwart ladder-related injuries among workers by promoting ladder safety training, including reminders about the right ladder to use for each task. Workers should also be well aware of the importance of inspection before use, and they should always follow the three points of contact rule when going up or down a ladder.
4 – Recognize Equipment Pitfalls
Many construction workers experience injuries relating to equipment used on the job. This could be tied to getting on or off equipment, or loading and unloading materials from machinery. In any case, general contractors can encourage simple tactics to improve equipment safety measures. Paying close attention to secure footing while getting on or off a machine, having more than one person assist with loading and unloading, and ensuring everyone feels comfortable asking for help with these tasks reduces safety risks.
5 – Document Potential Hazards
A general contractor’s main responsibility is to manage the construction site efficiently from start to finish. Part of this duty is recognizing the possible issues on a worksite that may lead to accidents or injuries if not addressed at the beginning of a project. It is necessary to take the time to identify safety risks such as unstable working surfaces, dangerous trenches, or weather-related concerns that may impact the safety of subcontractors, suppliers, or other site visitors. Potential hazards should be documented and shared with site workers, and they should be updated as the project progresses.
6 – Maintain Equipment and Tools
Poorly maintained equipment and tools also cause issues on construction sites. The Infrastructure Health and Safety Association suggests that general contractors
remind workers to inspect tools, machines, handheld equipment, and vehicles before each use to ensure they are properly maintained. Additionally, understanding the maintenance standards for certain tools or equipment and following those guidelines is crucial to reducing injury on the job.
7 – Minimize Crowds
Crowded work areas can be a serious safety issue for general contractors, subcontractors, and vendors and suppliers on site. It is common for crowds to gather during the use of heavy equipment or when a significant task is being completed. However, general contractors should discourage crowd-forming for spectating purposes. This can be done by limiting the number of people allowed to be in an area when certain activities are taking place, and enforcing these rules at every possible opportunity.
8 – Hire Licensed Subcontractors
General contractors may have full- or part-time employees as part of their business model, or there may be a heavy presence of subcontractors not directly tied to the main business. In either case, it is essential to have faith in the capabilities of workers, including their willingness and commitment to follow safety standards. General contractors can help ensure each worker is more likely to take safety seriously when they hire licensed contractors who follow through with
licensing requirements as mandated by the state or city.
9 – Focus on Training
Even after vetting subcontractors and employees based on their licensing status, general contractors also need to ensure training and education are a priority. Several online and in-person courses focus on construction safety training which workers should be encouraged to attend. Safety
education programs from OSHA and other reputable sources are crucial to decreasing accidents on the job.
10 – Be Present
Finally, general contractors can only have an impact on the safety of the job site when they are purposefully present. It is common for some GCs to stop by a project when they are needed or to check on progress periodically. However, new safety hazards, lacking worker training, and other risks are not easily fixed when the general contractor is not consistently on site. Reducing the potential for falls, slips, trips, and fatalities on the job requires communication with workers, and that takes place most effectively when general contractors are in person.
Eric Weisbrot is the Chief Marketing Officer of JW Surety Bonds. With years of experience in the surety industry under several different roles within the company, he is also a contributing author to the surety bond blog.
Read the court decisionRead the full story...Reprinted courtesy of
Puerto Rico Grid Restoration Plagued by Historic Problems, New Challenges
November 08, 2017 —
Pam Radtke Russell - Engineering News-RecordWhile the federal government is helping to restore power to Puerto Rico as fast as it can, that work is being made more difficult due to the dilapidated, pre-Hurricane Maria state of the grid and because long-term, post-disaster power restoration is typically not the federal government's mission.
Read the court decisionRead the full story...Reprinted courtesy of
Pam Radtke Russell, ENRMs. Russell may be contacted at
Russellp@bnpmedia.com
Appraisal Goes Forward Even Though Insurer Has Yet to Determine Coverage on Additional Claims
December 11, 2023 —
Tred R. Eyerly - Insurance Law HawaiiThe trial court's order granting the insured's motion to stay litigation and compel an appraisal was affirmed even though the insurer had not determined coverage on the insured's additional claims.Heritage Prop. & Cas. Ins. Co. v. Wellington Place HOA, 2023 Fla. App. LEXIS 6405 (Fla. Ct. App. Sept. 13, 2023).
The insured homeowner's association reported roof damage to its insurer, Heritage, after Hurrican Irma struck. Heritage agreed the damage was covered, but issued no payment because the amount of loss was less than the deductible.
The insured hired its own adjuster. The insured requested an extension of the policy's two year time limit to complete repairs because the claim was still in dispute and the insurer had not yet paid sufficient funds to allow necessary repairs. Heritage sent a revised estimate and asked the insured to send its adjuster's estimate in order to address any disputes. The insured submitted its adjuster's estimate of more than $6 million, including, for the first time, the cost to replace all the windows and sliding glass doors.
Read the court decisionRead the full story...Reprinted courtesy of
Tred R. Eyerly, Damon Key Leong Kupchak HastertMr. Eyerly may be contacted at
te@hawaiilawyer.com
Policyholders' Coverage Checklist in Times of Coronavirus
March 16, 2020 —
Richard W. Brown & Andres Avila - Saxe Doernberger & Vita, P.C.Every state but West Virginia have reported hundreds of Coronavirus (COVID-19) cases in the U.S. More than half are in California, Washington, New York, and Massachusetts. The unprecedented social and economic impact of the Coronavirus makes it necessary for policyholders to keep open all lines of communications with their insurance brokers, insurance carriers, financial advisors, safety & compliance experts, and insurance coverage counsel even if it is not certain whether they will need to file insurance claims.
As always, the specific terms of the insurance policies and the way losses are documented and presented to insurance carriers will be pivotal in securing coverage for Coronavirus-related exposures, such as jobsite closures, stop-work orders, remote work mandated measures, business interruption, event cancelation, employees’ claims, among others.
Policyholders should consider the following checklist of key insurance coverage tasks to be better positioned to face the risks posed by the Coronavirus:
- Pre-Loss Risk Management: A careful review of the policyholder’s insurance program may show coverage for the Coronavirus outbreak. Now is the time to assess, with the guidance of your brokers and insurance coverage counsel, the specific coverages in place. Policyholders may want to particularly review the terms and conditions of their Property, General Liability, Pollution, Directors & Officers, Professional Liability, Fiduciary Liability, as well as Event Cancelation Insurance coverages, among others depending on their specific business trade. For instance, Policyholders would want to assess, ahead of time, whether there are bacterial/virus/communicable diseases/pandemics exclusions in their policies. It is also relevant to review, with a keen eye, the insuring agreements and pose hypotheticals to stress test them and see how far coverage would go with respect to a Coronavirus exposure;
Reprinted courtesy of
Richard W. Brown, Saxe Doernberger & Vita, P.C. and
Andres Avila, Saxe Doernberger & Vita, P.C.
Mr. Brown may be contacted at rwb@sdvlaw.com
Mr. Avila may be contacted at ara@sdvlaw.com
Read the court decisionRead the full story...Reprinted courtesy of
U.S. Steel Invoking Carnegie’s Legacy in Revival Strategy
July 23, 2014 —
Sonja Elmquist – BloombergIn March 2013, Mario Longhi lobbed an unexpected question into a roomful of 150 U.S. Steel Corp. managers: Who here would buy the company’s stock, tomorrow?
He gave them three seconds, and “only a few reacted in that time frame positively,” Longhi said.
Since that meeting, Longhi has been promoted to chief executive officer, and nine months into his tenure he’s closed one plant permanently, two more are temporarily idled and he’s planning to overhaul another. It’s all part of his plan to transform the 144-year-old company into a lean, modern steel producer. Investors are taking note, with the shares up 53 percent since he took over.
Read the court decisionRead the full story...Reprinted courtesy of
Sonja Elmquist, BloombergMs. Elmquist may be contacted at
selmquist1@bloomberg.net
Arizona Supreme Court Confirms Eight-Year Limit on Construction Defect Lawsuits
July 18, 2011 —
CDJ STAFFActing on the case of Albano v. Shea Homes Ltd. Partnership, the Arizona Supreme Court has ruled that Arizona’s eight-year statute of repose applies. The case was referred to the court by the Ninth Circuit Court of Appeals which had asked for a clarification of Arizona law. The case focused on three questions:
1. Does the filing of a motion for class certification in an Arizona court toll the statute of limitations for individuals, who are included within the class, to file individual causes of action involving the same defendants and the same subject matter? 2. If so, does this class-action tolling doctrine apply to statutes of repose, and more specifically, to the statute of repose for construction defects set forth in Arizona Revised Statutes ("A.R.S.") § 12-552? 3. If the doctrine applies to statutes of repose, and specifically § 12-552, may a court weigh the equities of the case in determining whether, and to what extent, an action is tolled?
The litigation at hand has a lengthy history, starting with a case referred to as “Hoffman” in 2003. The Albano plaintiffs were not able to join in Hoffman, and they filed their own lawsuit in 2006. An additional lawsuit was filed by the Albano plaintiffs in 2007. The courts decided that the Albano plaintiffs’ lawsuit was untimely.
The Arizona Supreme Court concluded that the statute of repose was the appropriate standard for this case. They noted that “the eight-year statute of repose period began to run on November 6, 1997, the date of the Town of Gilbert’s final inspection. Albano II was filed on November 5, 2007.”
The court found that the plaintiffs had waited too long for start their suit. As a result, they found it unnecessary to answer the first or third questions. Justice A. John Pelander of the Arizona Supreme Court wrote the opinion, dated June 30, 2011.
Read the court’s decision…
Read the court decisionRead the full story...Reprinted courtesy of
Karen Campbell, Kristen Perkins to Speak at CLM 2020 Annual Conference in Dallas
March 02, 2020 —
Karen Campbell & Kristen Perkins - Lewis BrisboisNew York Partner Karen L. Campbell and Fort Lauderdale Partner Kristen D. Perkins will both speak at the upcoming CLM 2020 Annual Conference taking place March 18 to 20 at the Gaylord Texan Resort outside Dallas, Texas.
On March 19 at 2:00 p.m., Ms. Perkins will join a panel discussion titled “Predictive Analytics – You Don’t Need a Crystal Ball to Predict the Future,” exploring how predictive analytics affects litigation management programs, including case budgets, case cycle times, and claims outcomes. The panelists will also look at how machine learning picks up on nuances or anomalies that can affect analytics and give attendees a clearer picture on expected case parameters, and how that information can empower claims professionals during firm selection.
Then, on March 20 at 10:40 a.m., Ms. Campbell will join a roundtable discussion titled “How to Calculate Damages and Defend in Serious Injury Cases,” covering the calculation of both economic and non-economic damages, as well as trends and recent verdicts involving punitive damages and assessing the various types of third-party liability.
Reprinted courtesy of
Karen Campbell, Lewis Brisbois and
Kristen Perkins, Lewis Brisbois
Ms. Campbell may be contacted at Karen.Campbell@lewisbrisbois.com
Ms. Perkins may be contacted at Kristen.Perkins@lewisbrisbois.com
Read the court decisionRead the full story...Reprinted courtesy of
Mass-Timber Furnished Apartments Fare Well in Fire Tests
August 24, 2017 —
Nadine M. Post - Engineering News-RecordAdvocates for a code change that would allow taller heavy-timber frames are buoyed by the good performance of mass-timber structures in the first U.S. fire tests on full-scale furnished apartments.
Read the court decisionRead the full story...Reprinted courtesy of
Nadine M. PostMs. Post may be contacted at
postn@enr.com
