SEATTLE WASHINGTON BUILDING EXPERT
DIRECTORY AND CAPABILITIES

Colorado Legislature Kills SB 20-138 – A Bill to Extend Colorado’s Statute of Repose

June 22, 2020 — David M. McLain – Colorado Construction Litigation
As previously reported, SB 20-138, “Concerning Increased Consumer Protection for Homeowners Seeking Relief for Construction Defects,” would have extended the Colorado statute of repose applicable to construction defect claims. Senate Bill 20-138, if enacted, would have:

1. Extended Colorado’s statute of repose for construction defects from 6+2 years to 10+2 years;
2. Required tolling of the statute of repose until the claimant discovers not only the physical manifestation of a construction defect, but also its cause; and
3. Permitted statutory and equitable tolling of the statute of repose.

Read the court decision
Read the full story...
Reprinted courtesy of David McLain, Higgins, Hopkins, McLain & Roswell
Mr. McLain may be contacted at mclain@hhmrlaw.com

---

Colorado Homes Approved Despite being Too Close Together

January 22, 2014 — Beverley BevenFlorez-CDJ STAFF
ABC 7 reported that more than a dozen homes in Adams County, Colorado were inspected and approved by Building and Safety despite being built too close together. The problem was discovered by an inspector who cited a new home for being “4 inches too close to adjoining property.” Jim Williamette, the Adams County Chief Building Official told ABC 7, “It’s a fire issue for the separation of buildings.” The county may have solved the issue, according to ABC 7. Williamette stated that the properties “will be modified with fire-resistant windows” and combined with the “already-installed fire-resistant siding, the windows will satisfy the international building code.” Currently, the parties are in verbal agreement, and a “signed design proposal” is expected no later than January 21st. Read the court decision
Read the full story...
Reprinted courtesy of

---

Hunton Insurance Practice Again Scores “Tier 1” National Ranking in US News Best Law Firm Rankings

December 05, 2022 — Hunton Insurance Recovery Blog
On November 3, 2022, US News announced its annual law firm rankings, where Hunton Andrews Kurth LLP garnered the highest (Tier 1) ranking among national insurance law practices. Hunton’s insurance team also received Tier 1 honors for “Insurance Law” in three regions (Washington, DC, Atlanta and San Francisco) and Tier 2 honors for “Litigation – Insurance” in Washington, DC. US News ranks law firms in tiers from 1 (highest) to 3 (lowest) based on quantitative data that speaks to general demographic and background information on the practice group, attorneys and other data that speaks to the strengths of a law firm’s practice, as well as qualitative client feedback about:

1. the practice group’s expertise,
2. responsiveness,
3. understanding of a business and its needs,
4. cost-effectiveness,
5. civility, and
6. whether the client would refer another client to the firm.

Read the court decision
Read the full story...
Reprinted courtesy of Hunton Andrews Kurth LLP

---

Georgia Update: Automatic Renewals in Consumer Service Contracts

August 31, 2020 — David R. Cook - AHC Blog
Georgia HB 1039 amends O.C.G.A. § 13-12-3 to provide additional protections for consumers who enter into service contracts containing lengthy automatic renewal provisions. Pre-Existing Requirement: For service contracts with an initial term of twelve months or longer and an automatic renewal provision for more than one month, unless the consumer terminates the agreement, sellers must provide written or electronic notification of the automatic renewal provision to the consumer. The notification must be provided to the consumer between 30 and 60 days before the cancellation deadline under such renewal provision. The notice must also “clearly and conspicuously” disclose that unless the consumer cancels, the agreement will automatically renew and disclose how the consumer may obtain details about the automatic renewal provision and cancellation procedure. The process by which a consumer may obtain such information must include the seller’s contact information (e.g., specific phone number or address), reference to the contract, or any other method provided. Read the court decision
Read the full story...
Reprinted courtesy of David R. Cook, Autry, Hall & Cook, LLP
Mr. Cook may be contacted at cook@ahclaw.com

---

Top Talked-About Tech at the 2023 ABC Joint Tech Summit

May 15, 2023 — Grace Arnold - Construction Executive
At the 2023 ABC Joint Tech Summit in Tysons Corner, Virginia, on April 27, there was talk, of course, of various construction technologies, including AI, VR, autonomous vehicles, impairment detection, digital twins, blockchains and Spot the Robot Dog. All this different tech, however, was discussed for the same two reasons: safety and efficiency. While some companies are just discovering the vast uses for and benefits of smart technology in construction, other companies are already well into adoption and implementation. Here is a breakdown of some of the contech showcased at the Joint Tech Summit, which was presented by four ABC chapters: Chesapeake Shores, Greater Baltimore, Metro Washington and Virginia. AUTONOMOUS MACHINES The talk of the Tech Summit was Spot the Robot Dog from Boston Dynamics. Spot can walk, run, crawl, climb stairs and tortuous terrain, right itself from a fall, return to its charging port when its battery runs low and is compatible with a variety of add-ons, like 360 cameras. Spot is controlled via tablet and can be programmed to run on its own, allowing for increased worker and jobsite safety and productivity. Reprinted courtesy of Grace Arnold, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

---

Coverage for Injury to Insured’s Employee Not Covered

June 10, 2015 — Tred R. Eyerly – Insurance Law Hawaii
The employee exclusions in the employer's CGL and Umbrella policies barred coverage. Piatt v. Indiana Lumbermen's Mut. Ins. Co., 2015 Mo. LEXIS 32 (Mo. April 28, 2015). Linda Nunley was killed while working for Missouri Hardwood Charcoal, Inc. The kiln's large steel door had been removed and was leaning upright against another kiln when it blew over and crushed Ms. Nunley. Her family filed a wrongful death suit against Junior Flowers, the company's sole owner, director, and executive officer. The complaint alleged that Flowers was negligent in ordering employees to lean the kiln doors upright, even though he knew it was unsafe. The complaint further alleged that Flowers breached a personal duty of care owed to Ms. Nunley and that his actions were "something more" that a breach of the company's duty to provide a safe workplace. Flowers requested a defense under CGL and Umbrella policies issued by Lumbermen's. The policies insured Missouri Hardwood and its executive officers, but excluded liability for a work-related injury to an "employee of the insured." The policies also had a "separation of insureds" provision, stating that the insurance applied "separately to each insured against whom claim is made or suit is brought." Lumbermen's denied coverage. Read the court decision
Read the full story...
Reprinted courtesy of Tred R. Eyerly, Insurance Law Hawaii
Mr. Eyerly may be contacted at te@hawaiilawyer.com

---

Tall Mass Timber Buildings Now Possible Under 2021 IBC Code Changes

February 03, 2020 — Kenneth Bland - Construction Executive
The International Code Council (ICC) has approved 17 changes to the 2021 editions of the International Building Code (IBC) and International Fire Code, allowing for mass timber buildings up to 18 stories. With the addition of three new mass timber construction types (Type IV-A, IV-B, and IV-C), this is the first time in the history of the modern building code that significantly new construction types have been added to the code. Building Materials The primary building material that makes tall mass timber (TMT) buildings possible is cross-laminated timber (CLT). CLT is manufactured from dimension lumber (nominal 2x lumber) laid side-by-side or mass plywood panels of a specified width. Laminations of lumber are typically laid perpendicular to each other to form panels of various thicknesses that are bonded together using heat resistant adhesives that cure in large hydraulic presses. CLT commonly consists of an odd number of laminations. These solid wood panels can be anywhere from 6 inches to 20 inches nominal thickness and 60 feet long. Typical CLT panels will be 6 inches to 14 inches nominal thickness. The panels are fabricated off site, transported onto the construction site and assembled in a manner that is efficient and remarkably fast. CLT panels can be used as floor, wall, or roof building elements supported by glued-laminated beams and columns. Reprinted courtesy of Kenneth Bland, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

---

First-Time Homebuyers Make Biggest Share of Deals in 17 Years

February 22, 2018 — Prashant Gopal – Bloomberg
Millennials are playing homeownership catch-up. First-time buyers rushed into the market last year, making 38 percent of all U.S. single-family home purchases, the biggest share since 2000, data released Thursday by Genworth Mortgage Insurance show. The 2.07 million new or existing homes bought by first-timers was 7 percent more than in 2016, according to the insurer, part of Genworth Financial Inc. Read the court decision
Read the full story...
Reprinted courtesy of Prashant Gopal, Bloomberg

---