Fairfield Connecticut Building Expert Directory

Recent Decision Further Jeopardizes Availability of Additional Insured Coverage in New York

July 08, 2024 — Nina Catanzaro & Bethany L. Barrese - Saxe Doernberger & Vita, P.C.
Additional insured endorsements often provide “blanket” coverage to persons or organizations as required by a written contract. However, the wording of the “blanket” language is critically important, as the inclusion of certain phrases in an additional insured endorsement can result in a denial of coverage for the upstream party. For example, risk transfer issues can arise when an additional insured endorsement provides coverage to parties “when you [the named insured] and such person or organization [the additional insured] have agreed in writing in a contract or agreement.” Courts in New York (among other jurisdictions) have interpreted this phrase to require contractual privity – that is, only the entity that contracted directly with the named insured is entitled to additional insured coverage, even if the named insured agreed in that contract to provide additional insured coverage for others as well. The same goes for the phrase “any person or organization with whom you [the named insured] have agreed to add as an additional insured by written contract.” Reprinted courtesy of Nina Catanzaro, Saxe Doernberger & Vita, P.C. and Bethany L. Barrese, Saxe Doernberger & Vita, P.C. Ms. Catanzaro may be contacted at NCatanzaro@sdvlaw.com Ms. Barrese may be contacted at BBarrese@sdvlaw.com Read the court decision
Read the full story...
Reprinted courtesy of

EPA Announces that January 2017 Revised RMP Rules are Now Effective

February 06, 2019 — Anthony B. Cavender - Gravel2Gavel
On December 3, the Environmental Protection Agency (EPA) published a Federal Register notice advising the regulated community that EPA’s controversial Clean Air Act (CAA) stationary source Risk Management Program (RMP) rules are effective as of December 3, 2018 – the Final Rule: Accidental Release Prevention Requirements: Risk Management Programs Under the Clean Air Act (83 FR 62268). The initial package of the RMP rules was promulgated in 1996, but a series of chemical explosions prompted the development of new rules, whose process safety, third party auditing, emergency response, preparedness and information sharing provisions were designed to confront these challenges. Read the court decision
Read the full story...
Reprinted courtesy of Anthony B. Cavender, Pillsbury
Mr. Cavender may be contacted at anthony.cavender@pillsburylaw.com

Walmart Seeks Silicon Valley Vibe for New Arkansas Headquarters

June 18, 2019 — Matthew Boyle - Bloomberg
Walmart Inc. took inspiration from McDonald’s Corp., Apple Inc. and locations like Stanford University when designing the new headquarters that will start taking shape this summer. The 350-acre campus will be located just a few blocks east of Walmart’s current home, a patchwork of more than 20 buildings in Bentonville, Arkansas. It will feature bike paths, food trucks and outdoor meeting areas -- part of an effort to lure younger, digitally-savvy workers to northwestern Arkansas. Read the court decision
Read the full story...
Reprinted courtesy of Matthew Boyle, Bloomberg

The Multigenerational Housing Trend

May 02, 2014 — Beverley BevenFlorez-CDJ STAFF
Reuters reported that “[m]ore than 50 million Americans already live in multigenerational situations, according to Pew Research, and the number is expected to grow as baby boomers age.” Lennar Corp has “Next Gen” home models, which provides multigenerational housing for prices similar to traditional homes. For instance, according to Reuters, one of the Next Gen models contains “an 800-square-foot house-within-a-house” with “a separate entrance and its own patio, plus a bedroom, sitting area, and bathroom.” Other home builders are also providing multigenerational housing: “Gertz Fine Homes, which builds between 12-30 houses a year near Portland, Oregon, says about 30 percent of sales are now multigenerational models, which can cost around $600,000.” Read the court decision
Read the full story...
Reprinted courtesy of

Kansas Man Caught for Construction Scam in Virginia

December 20, 2012 — CDJ STAFF
A Virginia court sent charges of construction fraud against a Kansas man to a grand jury. Larry Foster visited homes in Bedford County, Virginia, tested the water, and told homeowners that they needed new water filtration systems. The homeowners paid, but Mr. Foster never delivered. One homeowner who testified paid him $1,690. Another paid even more, giving $3,090 to Mr. Foster. In order to dupe his victims, Foster used the address of a chiropractor as a business address, unbeknownst to the actual business there.. He is wanted for charges in other states as well. Read the court decision
Read the full story...
Reprinted courtesy of

Construction Insurance Rates Up in the United States

November 20, 2013 — CDJ STAFF
A new report says that construction firms paid from three to seven percent more on average during the first six months of 2013 than they had in the last half of 2012. Firms with poor loss histories paid even more, reaching double-digit increases. Michael Anderson, of Marsh’s U.S. Construction Practice said that “U.S. construction firms are grappling with a firming insurance market, especially when it comes to liability insurance where underwriters continue to tighten coverage terms and seek rate increases to make up for reduced investment income.” He did note that “the good news for well-managed construction firms is they can still generally find competitive pricing and terms.” Read the court decision
Read the full story...
Reprinted courtesy of

Standard of Care

December 16, 2019 — Jay Gregory - Gordon & Rees Construction Law Blog
One of the key concepts at the heart of Board complaints and civil claims against a design professional is whether or not that design professional complied with the applicable standard of care. In order to prevail on such a claim, the claimant must establish (typically with the aid of expert testimony) that the design professional deviated from the standard of care. On the other side of the coin, to defend a design professional against a professional malpractice claim, defense counsel attempts to establish that – contrary to the claimant’s allegations – the design professional, in fact, complied with the standard of care. Obviously, it becomes very important in such a claim situation to determine what the standard of care is that applies to the conduct of the defendant design professional. Often, this is easier said than done. There is no dictionary definition or handy guidebook that identifies the precise standard of care that applies in any given situation. The “standard of care” is a concept and, as such, is flexible and open to interpretation. Traditionally, the standard of care is expressed as being that level of service or competence generally employed by average or prudent practitioners under the same or similar circumstances at the same time and in the same locale. In other words, to meet the standard of care a design professional must generally follow the pack; he or she need not be perfect, exemplary, outstanding, or even superior – it is sufficient merely for the designer to do that which a reasonably prudent practitioner would do under similar circumstances. The negative or reverse definition also applies, to meet the standard of care, a practitioner must refrain from doing what a reasonably prudent practitioner would have refrained from doing. Although we have this ready definition of the standard of care, in any given dispute it is practically inevitable that the parties will have markedly different opinions as to: (1) what the standard of care required of the designer; and (2) whether the defendant design professional complied with that requirement. The claimant bringing a claim against a design professional typically will be able to find an expert reasonably qualified (at least on paper) who will offer an opinion that the defendant failed to comply with the standard of care. It is just as likely that the counsel for the defendant design professional will be able to find his or her own expert who will counter the opinion of the claimant’s expert and maintain that the defendant design professional, in fact, complied with the standard of care. What’s a jury to think? The concept of standard of care is intertwined with the legal concept of negligence. In the vast majority of law suits against design professionals, a claimant (known as the plaintiff) will assert a claim for negligence against the design professional now known as the defendant.1 As every first year law student learns while studying the field of “Torts,” negligence has four subparts. In order for a defendant to be found negligent, the claimant must establish four elements: (1) duty; (2) breach; (3) causation; and (4) damages. In other words, to establish a claim against a defendant design professional, a plaintiff must demonstrate that the defendant owed the plaintiff a duty of care but breached that duty and, as a result, caused the plaintiff to suffer damages. Read the court decision
Read the full story...
Reprinted courtesy of Jay Gregory, Gordon & Rees Scully Mansukhani
Mr. Gregory may be contacted at jgregory@grsm.com

Blue Gold: Critical Water for Critical Energy Materials

October 24, 2022 — Robert A. James & Ashleigh Myers - Gravel2Gavel Construction & Real Estate Law Blog
As demand increases for low-carbon technologies to power the energy transition, the acquisition of critical materials—so-called given their integral role in the transition of energy activities—is becoming increasingly important. As described in our previous post, such critical materials include rare earth elements (REE), lithium, nickel and platinum group metals. In short, the transition endeavors to reduce use of one non-renewable resource—fossil fuel—by significantly ramping up our use of other non-renewable resources. While critical material discussions have largely centered on the availability and economic extractability of the minerals themselves, Pillsbury is also counseling on the other resources needed to bring the materials to market at the scales required for our decarbonization goals. Chief among these resources is water. The extraction, processing and manufacture of critical materials into low-carbon technologies all require significant volumes of water. For example, up to 5,000 gallons of water are needed to produce one ton of lithium. Critical materials are often found in arid climates that are already experiencing water stress (such as the “lithium triangle” of Argentina, Bolivia and Chile, and copper in Chile), or in areas experiencing conflict and challenges to water development (such as cobalt production in the Democratic Republic of the Congo). In the U.S., development potential resides largely in the water-constrained western and southwestern states, such as Arizona (copper), California (REE), New Mexico (copper, REE), Texas (REE), Utah (magnesium, lithium, platinum, palladium, vanadium, copper), and Wyoming (REE, platinum, titanium, vanadium). Reprinted courtesy of Robert A. James, Pillsbury and Ashleigh Myers, Pillsbury Mr. James may be contacted at rob.james@pillsburylaw.com Ms. Myers may be contacted at ashleigh.myers@pillsburylaw.com Read the court decision
Read the full story...
Reprinted courtesy of

FAIRFIELD CONNECTICUT BUILDING EXPERT DIRECTORY AND CAPABILITIES