A Trio of Environmental Decisions from the Fourth Circuit
August 28, 2018 —
Anthony B. Cavender - Gravel2GavelWithin the past few weeks, the U.S. Court of Appeals for the Fourth Circuit has issued some very significant rulings regarding the construction of new natural gas pipelines. These cases are Berkley, et al. v. Mountain Valley Pipeline, LLC, decided July 25; Sierra Club, Inc., et al., v. U.S. Forest Service, The Wilderness Society, et al., v. U.S. Forest Service, and Sierra Club, Inc. et al. v. U.S. Department of the Interior, decided July 27, 2018; and Sierra Club v. U.S. Department of the Interior and Defenders of Wildlife, et al., v. U.S. Department of the Interior, decided August 6, 2018. The first two cases involve the Mountain Valley Pipeline, and the last case involves the Atlantic Coast Pipeline.
Read the court decisionRead the full story...Reprinted courtesy of
Anthony B. Cavender, PillsburyMr. Cavender may be contacted at
anthony.cavender@pillsburylaw.com
Corps Proposes $4.6B Plan to Steel Miami for Storm Surge
June 22, 2020 —
Pam Radtke Russell - Engineering News-RecordA $4.6-billion U.S. Army Corps of Engineers proposal to protect Miami from future storm surge, largely by building massive sea walls and elevating infrastructure systems, is the latest of such plans the agency has developed for East Coast communities.
Pam Radtke Russell, Engineering News-Record
Ms. Russell may be contacted at Russellp@bnpmedia.com
Read the full story... Read the court decisionRead the full story...Reprinted courtesy of
U.S. Home Prices Climbed 0.1% in July as Gains Slowed
September 24, 2014 —
Prashant Gopal – BloombergU.S. home prices rose less than economists estimated in July as investors pull back from the property market.
Prices climbed 0.1 percent on a seasonally adjusted basis from June, the Federal Housing Finance Agency said today in a report from Washington. The average economist estimate was for a 0.5 percent increase, according to data compiled by Bloomberg.
Investors who helped drive up prices are retreating as fewer foreclosures and other discounted homes become available. All-cash purchases in August fell to about 23 percent of the market from the usual 33 percent, the National Association of Realtors reported yesterday. Investors accounted for 12 percent, the least since late 2009.
Read the court decisionRead the full story...Reprinted courtesy of
Prashant Gopal, BloombergMr. Gopal may be contacted at
pgopal2@bloomberg.net
4 Ways the PRO Act Would Impact the Construction Industry
October 24, 2021 —
Andrew M. MacDonald - ConsensusDocsThe Protecting the Right to Organize Act (the “PRO Act”) is a proposed law that would dramatically rewrite the National Labor Relations Act (“NLRA”). Breathtakingly broad in scope, the PRO Act targets several longstanding features of existing law perceived by unions and labor activists to be unfair to labor and too favorable to employers. The proposed legislation is essentially a grab-bag of grievances that the labor movement has compiled over decades and sought to change through legislation and before the National Labor Relations Board (“NLRB”) without success in the past.
While the PRO Act would affect virtually all private sector employers, it would alter the labor dynamic in the construction industry in four major ways:
1. Removing the current prohibitions on secondary, jurisdictional, and other forms of picketing. Current law attempts to balance the rights of employers to operate their businesses without unnecessary interference with the rights of unions to protest concerning wages and working conditions. As part of this balancing act, the NLRA prohibits unions from picketing under certain conditions or with certain aims. These restrictions include the prohibition on “secondary” picketing by unions of neutral employers, which are employers with which the union does not have a direct labor dispute, and “jurisdictional” picketing by unions to force an employer to assign certain work to a specific trade or group of employees. The elimination of these restrictions in the PRO Act would have a significant impact on the construction industry.
Read the court decisionRead the full story...Reprinted courtesy of
Andrew M. MacDonald, Fox Rothschild LLPMr. MacDonald may be contacted at
amacdonald@foxrothschild.com
Investigators Eye Fiber Optic Work in Deadly Wisconsin Explosion
July 18, 2018 —
Jeff Yoders – Engineering News-RecordA hole punched into a 4-in.-dia gas pipeline during fiber-optic line laying is blamed for an explosion that killed a 34-year-old fire captain and injured nine other people, including four firefighters, in downtown Sun Prairie, Wis., on July 10. The injured were treated at nearby hospitals and have since been released.
Read the court decisionRead the full story...Reprinted courtesy of
Jeff Yoders, ENRMr. Yoders may be contacted at
yodersj@enr.com
Insurers Subrogating in Arkansas Must Expend Energy to Prove That Their Insureds Have Been Made Whole
July 30, 2019 —
Michael J. Ciamaichelo - The Subrogation StrategistArkansas employs the “made whole” doctrine, which requires an insured to be fully compensated for damages (i.e., to be “made whole”) before the insurer is entitled to recover in subrogation.[1] As the Riley court established, an insurer cannot unilaterally determine that its insured has been made whole (in order to establish a right of subrogation). Rather, in Arkansas, an insurer must establish that the insured has been made whole in one of two ways. First, the insurer and insured can reach an agreement that the insured has been made whole. Second, if the insurer and insured disagree on the issue, the insurer can ask a court to make a legal determination that the insured has been made whole.[2] If an insured has been made whole, the insurer is the real party in interest and must file the subrogation action in its own name.[3] However, when both the insured and an insurer have claims against the same tortfeasor (i.e., when there are both uninsured damages and subrogation damages), the insured is the real party in interest.[4]
In EMC Ins. Cos. v. Entergy Ark., Inc., 2019 U.S. App. LEXIS 14251 (8th Cir. May 14, 2019), EMC Insurance Companies (EMC) filed a subrogation action in the District Court for the Western District of Arkansas alleging that its insureds’ home was damaged by a fire caused by an electric company’s equipment. EMC never obtained an agreement from the insureds or a judicial determination that its insureds had been made whole. In addition, EMC did not allege in the complaint that its insureds had been made whole and did not present any evidence or testimony at trial that its insureds had been made whole. After EMC presented its case-in-chief, the District Court ruled that EMC lacked standing to pursue its subrogation claim because “EMC failed to obtain a legal determination that its insureds had been made whole . . . prior to initiating this subrogation action.” Thus, the District Court granted Entergy Ark., Inc.’s motion for judgment as a matter of law and EMC appealed the decision.
Read the court decisionRead the full story...Reprinted courtesy of
Michael J. Ciamaichelo, White and Williams LLPMr. Ciamaichelo may be contacted at
ciamaichelom@whiteandwilliams.com
Presidential Executive Order 14008: The Climate Crisis Order
August 16, 2021 —
Anthony B. Cavender - Gravel2GavelPresidential Executive Order 14008, “Tackling the Climate Crisis,” a long and unusually detailed Executive Order published in the Federal Register on February 1, 2021 (see 86 FR 7619), has generated considerable discussion and commentary. Below, I briefly outline its provisions.
This EO describes the “climate crisis” in existential terms:
“There is little time left to avoid setting the world on a dangerous, potentially catastrophic climate trajectory.” Confronting and combating climate change will be an important component of American foreign policy and national security, and domestically, the federal government’s resources will be mobilized to deploy a “govern-wide approach to the climate crisis.”
Read the court decisionRead the full story...Reprinted courtesy of
Anthony B. Cavender, PillsburyMr. Cavender may be contacted at
anthony.cavender@pillsburylaw.com
10 Safety Tips for General Contractors
October 09, 2018 —
Eric Weisbrot – JW Surety BondsThe construction industry continues to grow each year, paving the way for general contractors to make a profitable, sustainable living when the job is done right. However, to do so effectively, safety standards need to be met with consistency and focus on each worksite. General
contractors who are licensed and bonded must take proactive steps to avoid potentially fatal injuries among their subcontractors and employees, even though this may be easier said than done. To create and maintain a safe worksite each and every time, general contractors should consider how to implement the following best practices and safety tips on the job.
1 – Know the Risks
The most crucial step toward maintaining a safe construction site is to first be aware of the risks involved. Each year, thousands of
construction workers experience injuries on the job, and some ultimately lose their life because of safety missteps at work. As a general contractor, it is your responsibility to know that construction risks run rampant given the nature of the work. Being tuned into the potential for falls, slips, and other common safety-related incidents is a necessary part of operating a safe worksite for you and your employees.
2 – Require Protective Gear
An often overlooked safety precaution on construction sites is the use of up-to-date and well-maintained protective gear. For many subcontractors and employees, it is easy to skip this necessary step in safeguarding themselves from potential safety issues. However, general contractors can take steps to make protective gear a requirement on the job. This may include mandating hardhats and steel-toed shoes, gloves, and eyewear when appropriate. All visitors and workers on a construction site should follow protective gear instructions to avoid unnecessary safety risks.
3 – Educate on Ladder Safety
According to the Bureau of Labor Statistics, ladder injuries account for a significant number of construction worker incidents each year, making up more than 200,000 accidents on average. Ladders have continuously ranked high on OSHA’s list of violations at construction sites because the prevalence of injuries is so high. General contractors can help thwart ladder-related injuries among workers by promoting ladder safety training, including reminders about the right ladder to use for each task. Workers should also be well aware of the importance of inspection before use, and they should always follow the three points of contact rule when going up or down a ladder.
4 – Recognize Equipment Pitfalls
Many construction workers experience injuries relating to equipment used on the job. This could be tied to getting on or off equipment, or loading and unloading materials from machinery. In any case, general contractors can encourage simple tactics to improve equipment safety measures. Paying close attention to secure footing while getting on or off a machine, having more than one person assist with loading and unloading, and ensuring everyone feels comfortable asking for help with these tasks reduces safety risks.
5 – Document Potential Hazards
A general contractor’s main responsibility is to manage the construction site efficiently from start to finish. Part of this duty is recognizing the possible issues on a worksite that may lead to accidents or injuries if not addressed at the beginning of a project. It is necessary to take the time to identify safety risks such as unstable working surfaces, dangerous trenches, or weather-related concerns that may impact the safety of subcontractors, suppliers, or other site visitors. Potential hazards should be documented and shared with site workers, and they should be updated as the project progresses.
6 – Maintain Equipment and Tools
Poorly maintained equipment and tools also cause issues on construction sites. The Infrastructure Health and Safety Association suggests that general contractors
remind workers to inspect tools, machines, handheld equipment, and vehicles before each use to ensure they are properly maintained. Additionally, understanding the maintenance standards for certain tools or equipment and following those guidelines is crucial to reducing injury on the job.
7 – Minimize Crowds
Crowded work areas can be a serious safety issue for general contractors, subcontractors, and vendors and suppliers on site. It is common for crowds to gather during the use of heavy equipment or when a significant task is being completed. However, general contractors should discourage crowd-forming for spectating purposes. This can be done by limiting the number of people allowed to be in an area when certain activities are taking place, and enforcing these rules at every possible opportunity.
8 – Hire Licensed Subcontractors
General contractors may have full- or part-time employees as part of their business model, or there may be a heavy presence of subcontractors not directly tied to the main business. In either case, it is essential to have faith in the capabilities of workers, including their willingness and commitment to follow safety standards. General contractors can help ensure each worker is more likely to take safety seriously when they hire licensed contractors who follow through with
licensing requirements as mandated by the state or city.
9 – Focus on Training
Even after vetting subcontractors and employees based on their licensing status, general contractors also need to ensure training and education are a priority. Several online and in-person courses focus on construction safety training which workers should be encouraged to attend. Safety
education programs from OSHA and other reputable sources are crucial to decreasing accidents on the job.
10 – Be Present
Finally, general contractors can only have an impact on the safety of the job site when they are purposefully present. It is common for some GCs to stop by a project when they are needed or to check on progress periodically. However, new safety hazards, lacking worker training, and other risks are not easily fixed when the general contractor is not consistently on site. Reducing the potential for falls, slips, trips, and fatalities on the job requires communication with workers, and that takes place most effectively when general contractors are in person.
Eric Weisbrot is the Chief Marketing Officer of JW Surety Bonds. With years of experience in the surety industry under several different roles within the company, he is also a contributing author to the surety bond blog.
Read the court decisionRead the full story...Reprinted courtesy of
