Seattle Washington Building Expert Directory

Georgia Court Reaffirms Construction Defect Decision

August 27, 2013 — CDJ STAFF
In 2011, the Georgia Supreme Court ruled that construction defects could count as “occurrences” under a general liability policy. John Watkins, writing in Law360, notes that the ruling “has potentially broad implications for Georgia insureds.” He goes on to look at a later Georgia Supreme Court case, in which the court reaffirmed its decision in the 2011 Hathaway case. In the 2013 case, Taylor Morrison Services Inc. v. HDI-Gerlins Ins., the court held that the property damage had to happen to something other than the work performed by the insured, and that a breaches of warranty without fraud claims may be covered. But Watkins notes that this points to “the continuing efforts of insurers to deny coverage for construction defects under CGL policies.” This overruled some of the past decisions of the United States District Court for the Northern District of Georgia. Watkins noted that the Eleventh Circuit seemed to wonder about the scope of Hathaway, but with Taylor Morrison, “the Georgia Supreme Court provided a clearly stated response.” Looking at the implications, he gives an example in which if a window installer work causes a window to leak and the water intrusion damages a floor, the floor, but not the window would be covered. But he cautions, “the result may turn on the policy language and the particular facts.” In any case, he assures us that “coverage disputes regarding construction defects are sure to continue.” Read the court decision
Read the full story...
Reprinted courtesy of

Las Vegas’ McCarran Tower Construction Issues Delays Opening

August 13, 2014 — Beverley BevenFlorez-CDJ STAFF
The Las Vegas Review-Journal reported that an improperly applied chemical coating might delay the opening of McCarran International Airport’s Federal Aviation Administration tower by a year and cost millions of dollars to repair. The chemical coating was intended “to prevent the spread of toxic fungus,” but was “improperly applied and is ineffective,” workers on the site told the Las Vegas Review-Journal. “Officials said the” $99 million, 352-foot “tower was expected to be operational by 2015, but the FAA now says it won’t be able to use the facility until late 2016 or early 2017.” Read the court decision
Read the full story...
Reprinted courtesy of

Subcontractor Allowed to Sue Designer for Negligence: California Courts Chip Away at the Economic Loss Doctrine (Independent Duty Rule)

August 30, 2017 — John P. Ahlers - Ahlers & Cressman PLLC
An architect may have to pay over $1 million to a subcontractor who was contractually obligated to rely on the designer’s plans – even though the architect was not a party to the contract.[1] That was the ruling in U.S. f/u/b/o Penn Air Control, Inc. v. Bilbro Constr. Co., Inc.[2] The dispute involved a $7.3 million design-build contract award to Bilbro Construction (“Bilbro”) to renovate a facility for the Naval Facilities Engineering Command in Monterey, California. Bilbro hired an architect (“FPBA”) to serve as the designer of record and provide all the architectural design services. FPBA’s design team included an acoustical sub-consultant (Sparling). The general contractor (design builder) also retained Alpha Mechanical (Alpha) as the mechanical electrical and plumbing (“MEP”) design/build subcontractor. Alpha, in turn, subcontracted the MEP design to Shadpour Consulting Engineers. During the design phase of this project, Alpha’s MEP design was reviewed by FPBA, Bilbro, and Sparling at the 35, 75, and 100 percent design completion levels. Alpha demonstrated that it regularly received direct communications during design development from Sparling and FPBA, including comments, changes, and revisions. One example Alpha cited was it raised some concerns about anticipated noise level in eight rooms. Sparling made several recommendations to Alpha and Shadpour that were implemented. Read the court decision
Read the full story...
Reprinted courtesy of John P. Ahlers, Ahlers & Cressman PLLC
Mr. Ahlers may be contacted at jahlers@ac-lawyers.com

Expert Can be Questioned on a Construction Standard, Even if Not Relied Upon

August 07, 2022 — Garret Murai - California Construction Law Blog
It’s not uncommon in construction defect litigation for each side retain one or more experts to give their opinion as to whether something was constructed in accordance with the standard of care. This usually results in what we legal practitioners call a “battle of the experts.” The California Code of Civil Procedure and Evidence Code include specific provisions applicable to experts including when they must be disclosed, when and how they can be deposed, and what opinions they can render. When attempting to challenge an expert it is not uncommon for one side to argue that the other side’s expert did not consider a certain fact or certain standard in reaching his or her opinion, therefore, allowing that party to argue at trial that the expert’s opinion is somehow flawed. However, there are also certain limitations, including a limitation restricting a party from cross-examining an expert on any scientific, technical, or professional test, treatise, journal or similar publication if the witness did not rely on such publication in arriving at or forming his or her opinion. The next case, Paige v. Safeway, Inc. (2021) 74 Cal.App.5th 1108, involved a case of first impression: Namely, whether an expert who did not rely on a publication in forming his or her opinion can nevertheless be questioned on a publication (in this case an ASTM standard) because the publication is a “reliable authority.” Read the court decision
Read the full story...
Reprinted courtesy of Garret Murai, Nomos LLP
Mr. Murai may be contacted at gmurai@nomosllp.com

Coverage for Construction Defects Barred By Exclusion j (5)

April 15, 2015 — Tred R. Eyerly – Insurance Law Hawaii
The Texas Court Appeal reversed a trial court judgment which found coverage in favor of the contractor based upon exclusion j(5). Dallas Nat'l Ins. Co. v. Calitex Corp., 2015 Tex. App. LEXIS 2002 (Tex. Ct. App. March 3, 2015). Turnkey Residential Group, Inc., was the contractor to construct a twelve-unit townhome complex in Dallas. The owner of the project was Calitex Corporation. Construction began on November 2006. The project was to be completed by Turnkey by October 27, 2007. Calitex filed suit against Turnkey and some of its subcontractors in February 2008. Calitex alleged problems with Turnkey's work included: (1) the stone exterior was not properly treated and leaked, and some areas were left uncovered with stone; and (2) windows leaked. It was further alleged that the quality of materials, labor and craftsmanship did not meet the standards of the contract and resulted in damages. Turnkey submitted a notice of claim to its insurer, Dallas National Insurance Company (DNIC). Coverage was denied. Read the court decision
Read the full story...
Reprinted courtesy of Tred R. Eyerly, Insurance Law Hawaii
Mr. Eyerly may be contacted at te@hawaiilawyer.com

Smart Cities Offer New Ideas for Connectivity

April 05, 2017 — Jennifer Seward - Engineering News-Record
Innovative, technology-driven communities are being designed and constructed for the next generation—and beyond. Although each of them is uniquely planned, experts say the central theme of connectivity is the key to turning concepts into reality. Read the court decision
Read the full story...
Reprinted courtesy of Jennifer Seward, ENR
ENR may be contacted at ENR.com@bnpmedia.com

Get Smarter About Electric Construction Equipment

October 24, 2022 — CONEXPO-CON/AGG
MILWAUKEE – Sustainability in the construction industry is being advanced by the public and private sectors. Governments are adopting more clean-air regulations at local and regional levels and companies are adopting sustainability policies and asking partners to help them meet their targets. Consequently, many manufacturers have already developed – or are in the process of developing – electric-powered construction equipment to meet increasing emissions regulations, provide efficiency improvements, and lower operating costs. All electric, electric/hydraulic, and battery-operated versions rival their diesel and gas counterparts in performance, notes Joel Honeyman, Vice President of Global Innovation at Bobcat. THE CHANGING INDUSTRY “People say electric machines are not going to perform as well as a diesel machine,” Honeyman observes. “That is simply not true. In many cases they can outperform them.” “Many people are so used to what they have and are afraid of new technology. Some companies have been running diesel- and gas-powered equipment for 40, 50 years. Hydraulics have been on equipment for 80 years. Adjusting to an electric-powered machine is quite a paradigm shift.” About the Association of Equipment Manufacturers (AEM) AEM is the North America-based international trade group representing off-road equipment manufacturers and suppliers with more than 1,000 companies and more than 200 product lines in the agriculture and construction-related industry sectors worldwide. The equipment manufacturing industry in the United States supports 2.8 million jobs and contributes roughly $288 billion to the economy every year. About CONEXPO-CON/AGG Held every three years, CONEXPO-CON/AGG is the must-attend event for construction industry professionals. The show features the latest equipment, products, services and technologies for the construction industry, as well as industry-leading education. The next CONEXPO-CON/AGG will be held March 14-18, 2023 in Las Vegas, Nevada. For more information on CONEXPO-CON/AGG, visit https://www.conexpoconagg.com. Learn more about excavator tech here. Read the court decision
Read the full story...
Reprinted courtesy of

Details of Sealed Whistleblower Charges Over Cuomo Bridge Bolts Burst Into Public View

March 22, 2021 — Richard Korman - Engineering News-Record
Tappan Zee Constructors, the consortium that built the big New York Hudson River crossing that opened in 2018, is embroiled in another lawsuit related to the bridge. Reprinted courtesy of Richard Korman, Engineering News-Record Mr. Korman may be contacted at kormanr@enr.com Read the full story... Read the court decision
Read the full story...
Reprinted courtesy of

SEATTLE WASHINGTON BUILDING EXPERT DIRECTORY AND CAPABILITIES