Seattle Washington Building Expert Directory

The Ghosts of Baha Mar: How a $3.5 Billion Paradise Went Bust

January 06, 2016 — John Lippert & Dawn McCarty – Bloomberg
Beyond the tropical waters, across palm-fringed sands and behind locked gates, looms Baha Mar -- the largest and, at $3.5 billion, priciest resort in the Caribbean. Here, no one frolics pool-side, pina colada in hand, or hits irons on the Jack Nicklaus golf course. No slot machines jingle-jangle in the casino. The Flamingo Bar, the Brasserie des Arts and the Cartier boutique lie dark. On this bright October morning in the Bahamas, all 2,200 guest rooms are empty. The quiet is almost spooky here on the outskirts of Nassau, where the waterscape frills of nearby Paradise Island give way to the vast ghost-resort that is Baha Mar. Just how the place ended up like this -- in a bankruptcy so colossal that it’s jeopardizing the Bahamas’s credit rating -- is the biggest business story to hit this Caribbean nation for as long as anyone here can remember. It stretches far beyond the white beaches and across time zones, to none other than the State Council of China. Reprinted courtesy of John Lippert, Bloomberg and Dawn McCarty, Bloomberg Read the court decision
Read the full story...
Reprinted courtesy of

High-Rise Condominium Construction Design Defects, A Maryland Construction Lawyer’s Perspective

July 15, 2015 — Nicholas D. Cowie – Maryland Condo Construction Defect Law Blog
The increased migration from suburbs to metropolitan areas has accompanied an increase in high-rise construction, including the development of high-rise condominium buildings. The resulting metamorphosis of urban skylines, such as seen from Maryland’s Baltimore harbor, has also brought with it many complex construction law and construction litigation issues. Our law firm’s Maryland condominium construction law practice is increasingly called upon to resolve disputes involving high-rise condominium construction design defects between condominium associations, developers, contractors, builders, and design professionals arising out of the construction of high-rise buildings. A condominium building is typically considered to be a high-rise when it is approximately seven or more stories above grade according to the National Fire Protection Association Life Safety Code, which defines a high-rise as being 75 feet (23 meters) measured from the lowest level accessible to fire department vehicles up to the floor level of the highest occupiable story. High-rise buildings may be residential (e.g., condominiums or multifamily apartment buildings), commercial (e.g., commercial office or retail space), or mixed-use structures. A mixed-use high-rise development might contain retail space, office space, a parking garage, apartments, and condominiums, each owned or maintained by separate entities and each sharing common expenses for the building. Read the court decision
Read the full story...
Reprinted courtesy of Nicholas D. Cowie, Cowie & Mott, P.A.
Mr. Cowie may be contacted at ndc@cowiemott.com

California Trial Court Clarifies Application of SB800 Roofing Standards and Expert’s Opinions

February 18, 2020 — Scott Calkins & Anthony Gaeta - Collinsworth, Specht, Calkins & Giampaoli; Mark Chapman - Bert L. Howe & Associates, Inc.
Collinsworth, Specht, Calkins & Giampaoli partners Scott Calkins and Anthony Gaeta obtained a trial victory when the jury returned a 12-0 defense verdict against one plaintiff homeowner, and awarded the other homeowner less than $2,000, an amount well below the defendant’s pre-trial CCP 998 Offers to Compromise. One of the main issues in the case was the application of SB800 roofing standards. Plaintiffs’ roofing expert testified in deposition no water entered the structure or passed through a moisture barrier [Civ. Code §896(a)(4)], and no materials had fallen off the roof [§896(g)(11)]. In an attempt to circumvent the applicable performance standards, Plaintiffs argued Civ. Code §869(g)(3)(A), also known as the ‘useful life’ exception, applied because the various components of the roof (nailing pattern, tiles, vents, etc.) were installed in such a manner so as to reduce the useful life of the roof. Following pre-trial motions and objections made during Plaintiffs’ direct examination, the Court ruled Section 896(g)(3)(A) did not apply to a conventional roof, as it is not a “manufactured product” as defined in §896(g)(3)(C). Plaintiffs’ roofing claims were summarily dismissed and Plaintiffs’ expert was prevented from testifying. In contrast, the defense expert, Mark Chapman, was allowed to testify regarding his expert opinions as to the appropriate SB800 standard relative to each alleged defect and whether the standards were violated. The SB800 performance standards were included on the jury verdict form, and the jury found Mr. Chapman’s testimony compelling, which was a substantial factor in awarding only minor damages to one Plaintiff. For more information, contact Scott Calkins (scalkins@cslawoffices.com), Anthony Gaeta (ageta@cslawoffices.com) or Mark Chapman (mchapman@berthowe.com). Read the court decision
Read the full story...
Reprinted courtesy of

Reminder About the Upcoming Mechanic’s Lien Form Change

August 26, 2019 — Christopher G. Hill - Construction Law Musings
As July 1, 2019 approaches with its inevitable changes to the Virginia Code, I wanted to remind you once again that the statutory form for a Virginia mechanic’s lien will change as of that date. HB2409 passed both houses of the General Assembly and has been signed by the Governor. This bill reconciled the language found in Virginia Code Sec. 43-4 with the various forms for general contractor, subcontractor and sub-subcontractor/supplier forms found in later sections of the code. As you will see if you download the .pdf of the bill as signed, this involved some tweaks to 43-4 and some updates to the mechanic’s lien forms that are in the code. The recent Desai case from the Virginia Supreme Court made it clear that such action was necessary. Read the court decision
Read the full story...
Reprinted courtesy of The Law Office of Christopher G. Hill
Mr. Hill may be contacted at chrisghill@constructionlawva.com

Hawaii Federal District Court Denies Brokers' MSJ on Duties Owed In Construction Defect Case

October 19, 2017 — Tred R. Eyerly - Insurance Law Hawaii
The federal district court for the District of Hawaii denied the brokers' motion for summary judgment seeking dismissal from claims that they inadequately advised the insured of the law regarding construction defects in Hawaii. Am Auto. Ins. Co. v. Haw. Nut & Bolt, Inc., 2017 U.S. Dist. LEXIS 148571. Safeway sued Hawaii Nut & Bolt (HNB) and others for construction defects in a newly constructed store. The underlying complaint alleged products liability claims against HNB as the distributor of the "VersaFlex Coating System." HSB had represented that the coating system was adequate for its intended use. The underlying complaint alleged failure of the VersaFlex Coating System in waterproofing the roof deck of the store. After the store opened, water leaks from the roof deck appeared. Safeway alleged they were caused by the cracks and failures in the waterproof membrane in the roof deck. HNB notified its insurers of the claims. The insurers defended HNB during the litigation subject to reservation of rights letters. Read the court decision
Read the full story...
Reprinted courtesy of Tred R. Eyerly, Insurance Law Hawaii
Mr. Eyerly may be contacted at te@hawaiilawyer.com

Improperly Installed Flanges Are Impaired Property

February 16, 2016 — Tred R. Eyerly – Insurance Law Hawaii
Answering certified questions from the Fifth Circuit, the Texas Supreme Court found there was no coverage for flanges that leaked after installation. U. S. Metals, Inc. v. Liberty Mutual Group, Inc., 2015 Texas LEXIS 1081 (Dec. 4, 2015). U. S. Metals sold Exxon 350 custom-made, stainless steel, weld-neck flanges for use in refineries. Testing after installation showed the flanges leaked and did not meet industry standards. Exxon decided to replace the flanges to avoid risk of fire and explosion. For each flange, this involved stripping the temperature coating and insulation, cutting the flange out of the pipe, removing the gaskets, grinding the pipe surfaces smooth for re-welding, replacing the flange and gaskets, welding the new flange to the pipes, and replacing the temperature coating and insulation. The replacement process delayed operation of the diesel units for several weeks. Exxon sued U.S. Metal for over $6 million as the cost of replacing the flanges and $16 million as damages for lost use of the diesel units during the process. U.S. Metals settled with Exxon for $2.2 million and then sought indemnification from its liability insurer, Liberty Mutual. Read the court decision
Read the full story...
Reprinted courtesy of Tred R. Eyerly, Insurance Law Hawaii
Mr. Eyerly may be contacted at te@hawaiilawyer.com

The Privilege Is All Mine: California Appellate Court Finds Law Firm Holds Attorney Work Product Privilege Applicable to Documents Created by Formerly Employed Attorney

June 29, 2017 — David W. Evans & Stephen J. Squillario – Haight Brown & Bonesteel LLP
In Tucker Ellis LLP v. Superior Court (A148956 – Filed 6/21/2017), the First Appellate District held that (1) the holder of the attorney work product privilege is the employer law firm rather than the former employee attorney who created the privileged documents while a firm employee, and (2) as a result, the firm did not owe a duty to obtain the former attorney’s permission before disclosing the subject documents to third parties. In Tucker Ellis LLP, the attorney, while still employed by Tucker Ellis, exchanged a series of e-mails with a consultant retained by the firm to assist in asbestos litigation for a client. The firm also entered into an agreement with the consultant to summarize scientific studies on the causes of mesothelioma in a published review article. After the attorney departed the firm, Tucker Ellis was served with a subpoena in connection with a matter pending in Kentucky for the production of communications with the consultant regarding the article. In response, Tucker Ellis, in relevant part, produced the work product e-mails authored by the former attorney. The e-mails eventually ended up on the Internet and reached over 50 asbestos plaintiffs’ attorneys, resulting in the attorney’s termination from his new firm. After Tucker Ellis ignored the attorney’s “claw-back” letter, he filed suit against the firm for negligence, among other causes of action. The trial court granted the former attorney’s motion for summary adjudication on the issue of duty, reasoning that the firm owed the attorney a legal duty to prevent the disclosure of the work product. Tucker Ellis filed a petition for a writ of mandate with the Court of Appeal challenging the trial court’s decision on the duty issue. Reprinted courtesy of David W. Evans, Haight Brown & Bonesteel LLP and Stephen J. Squillario, Haight Brown & Bonesteel LLP Mr. Evans may be contacted at devans@hbblaw.com Mr. Squillario may be contacted at ssquillario@hbblaw.com Read the court decision
Read the full story...
Reprinted courtesy of

Standard For Evaluating Delay – Directly from An Armed Services Board Of Contract Appeal’s Opinion

October 04, 2021 — David Adelstein - Florida Construction Legal Updates
Sometimes, it is much better to hear it from the horse’s mouth. That is the case here. The Armed Services Board of Contract Appeal’s (ASBCA) opinion in Appeals of -GSC Construction, Inc., ASBCA No. 59402, 2020 WL 8148687 (ASBCA November 4, 2020) includes an informative discussion of a contractor’s burden when it encounters excusable delay and, of importance, the standard for evaluating delay. It’s a long discussion but one that parties in construction need to know, appreciate, and understand. EVERY WORD IN THIS DISCUSSION MATTERS. Construction projects get delayed and with a delay comes money because time is money. Many claims are predicated on delay. These can be an owner assessing liquidated damages due to a delayed job or a contractor seeking its costs for delay. Either way, the standard for evaluating delay and the burdens imposed on a party cannot be understated and, certainly, cannot be overlooked. For this reason, here is the discussion on evaluating delay directly from the horse’s mouth in the Appeal of-GSC Construction, Inc.:

The critical path is the longest path in the schedule on which any delay or disruption would cause a day-for-day delay to the project itself; those activities must be performed as they are scheduled and timely in order for the project to finish on time. Wilner v. United States, 23 Cl. Ct. 241, 245 (1991). In Yates-Desbuild Joint Venture, CBCA No. 3350 et al., 17-1 BCA ¶ 36,870, our sister board compiled an excellent and very helpful synopsis of the standards for evaluating delay claims, which I adopt nearly verbatim among the discussion that follows.

Read the court decision
Read the full story...
Reprinted courtesy of David Adelstein, Kirwin Norris, P.A.
Mr. Adelstein may be contacted at dma@kirwinnorris.com

SEATTLE WASHINGTON BUILDING EXPERT DIRECTORY AND CAPABILITIES