FAIRFIELD CONNECTICUT BUILDING EXPERT
DIRECTORY AND CAPABILITIES

NARI Addresses Construction Defect Claim Issues for Remodeling Contractors

November 05, 2014 — Beverley BevenFlorez-CDJ STAFF
The blog of the National Association of the Remodeling Industry (NARI) reported on issues for remodeling contractors that could result in construction defect claims. The most common problems "include water intrusion and water damage (windows, roofs, siding, etc.), heaving/settlement of flatwork areas, structural deficiencies/damage and material defects, etc." NARI suggests starting by analyzing contractual provisions. A few of the provisions addressed by NARI include Dispute Resolution, Performance Guidelines, and Notice of Claim Provisions. The article also covers Warranties, Applicable Laws, Potential Legal Action, and Insurance Coverage. Read the court decision
Read the full story...
Reprinted courtesy of

---

Product Liability Alert: Evidence of Apportionment of Fault Admissible in Strict Products Liability Action

March 26, 2014 — R. Bryan Martin and Kristian B. Moriarty - Haight Brown & Bonesteel LLP
In Romine v. Johnson Controls, Inc. (No. B239761, filed March 17, 2014), the California Court of Appeal for the Second District held that a trial court must permit a defendant, in a products liability action, to present evidence of apportionment of fault among settling and non-settling entities. The case involved an automobile collision in which the plaintiff was struck from behind, causing the driver’s seat to recline and propel plaintiff into the back seat where she struck her head. Plaintiff was left quadriplegic as a result. Plaintiff brought suit against the driver who caused the accident, the Nissan entities who manufactured the car plaintiff was driving, Johnson Controls, Inc. (“Johnson”), Ikeda Engineering Corporation (“Ikeda”), Vintec Co. (“Vintec”), and Autoliv ASP, Inc., who designed and manufactured the driver’s seat of the vehicle plaintiff was driving, and against Faurecia Automotive Seating, Inc. who manufactured the recliner mechanism of plaintiff’s vehicle’s front seat. Ikeda participated in the design of the driver’s seat and Vintec manufactured the driver’s seat. Johnson manufactured the seat belt for the driver’s seat of plaintiff’s vehicle in accordance with Nissan’s design. Prior to trial, plaintiff settled with the defendant driver, the Nissan defendants, the Autoliv defendants, and Faurecia Automotive Seating, Inc. Plaintiff elected to proceed to trial solely on a cause of action for strict products liability against Ikeda and Vintec. Pursuant to a stipulation, Johnson agreed it would be legally responsible for damages awarded to plaintiff at trial based upon the actions of Vintec or Ikeda. At trial, the court precluded Vintec and Ikeda from offering evidence that: (1) plaintiff would not have been injured if her vehicle’s seat belt was designed in a different manner by Nissan; (2) Nissan chose the manufacturer of the recliner mechanism and required defendants to use that manufacturer and that part in the seat; and (3) The other defendants had already reached settlements with plaintiff. Reprinted courtesy of R. Bryan Martin, Haight Brown & Bonesteel LLP and Kristian B. Moriarty, Haight Brown & Bonesteel LLP Mr. Martin may be contacted at bmartin@hbblaw.com; Ms. Moriarty may be contacted at kmoriarty@hbblaw.com Read the court decision
Read the full story...
Reprinted courtesy of

---

Idaho Federal Court Rules Against Sacketts After SCOTUS Decided Judicial Review of an EPA Compliance Order was Permissible

May 13, 2019 — Anthony B. Cavender - Gravel2Gavel
In a decision released on March 31, in Sackett v. EPA, the U.S. District Court for Idaho held, without benefit of oral argument, that the Environmental Protection Agency’s (EPA) motion for summary judgment should be granted, and accordingly, the Sacketts had violated the Clean Water Act (CWA) by making improvements to 0.63 acres of land they owned without a required CWA permit when the land qualified as a “wetlands.” The EPA had determined the Sacketts’ “property is subject to the CWA because it contains wetlands adjacent to Priest Lake, a traditionally ‘navigable water,’ and, additionally, their property is wetland adjacent to a tributary and similarly situated to other wetlands and has a significant nexus to Priest Lake.” The District Court rejected the Sacketts’ arguments that their property was not a “wetlands” subject to the CWA. Read the court decision
Read the full story...
Reprinted courtesy of Anthony B. Cavender, Pillsbury
Mr. Cavender may be contacted at anthony.cavender@pillsburylaw.com

---

Homeowners Must Comply with Arbitration over Construction Defects

January 06, 2012 — CDJ STAFF

The California Court of Appeals has upheld a decision by the Superior Court of Kern County that homeowners must comply with arbitration procedures in their construction defect claim. The California Court of Appeals ruled on December 14 in the case of Baeza v. Superior Court of Kern County, denying the plaintiff’s petition that the trial court vacate its order.

The plaintiffs in the case are homeowners in various developments built by Castle & Cook. The homes were sold with a contract that provided for “nonadversarial prelitigation procedures, including mediation, and judicial reference.” The homeowners made defect claims and argued that Castle & Cooke failed to comply with statutory disclosure requirements and that some of the contracts violate related statutes.

The appeals court found that there was no ground for appeal of the lower court’s order to continue with prelitigation procedures. The court noted that the plaintiffs could not seek a review of the mediation until a judgment was issued, but that then the issue would be moot. The court felt that there were issues presented that needed clarification, and so they reviewed this case. This was cleared for publication.

The court considered the intent of the legislature in passing the Right to Repair Act, noting that “under the statutory scheme, the builder has the option of contracting for an alternative nonadversarial prelitigation procedure,” as established in Chapter 4. The court noted that Chapter 4 “contains no specifics regarding what provisions the alternative nonadversarial contractual provisions may or must include.”

The plaintiffs contended that the builder was in violation of the standards set out in Section 912, however the court responded that these sections set out one set of procedures, but they concluded that “if the Legislature had intended the section 912 disclosure provisions…it could have made the requirements applicable to all builders by locating them in a section outside Chapter 4.”

Read the court’s decision…

Read the court decision
Read the full story...
Reprinted courtesy of

---

Top Talked-About Tech at the 2023 ABC Joint Tech Summit

May 15, 2023 — Grace Arnold - Construction Executive
At the 2023 ABC Joint Tech Summit in Tysons Corner, Virginia, on April 27, there was talk, of course, of various construction technologies, including AI, VR, autonomous vehicles, impairment detection, digital twins, blockchains and Spot the Robot Dog. All this different tech, however, was discussed for the same two reasons: safety and efficiency. While some companies are just discovering the vast uses for and benefits of smart technology in construction, other companies are already well into adoption and implementation. Here is a breakdown of some of the contech showcased at the Joint Tech Summit, which was presented by four ABC chapters: Chesapeake Shores, Greater Baltimore, Metro Washington and Virginia. AUTONOMOUS MACHINES The talk of the Tech Summit was Spot the Robot Dog from Boston Dynamics. Spot can walk, run, crawl, climb stairs and tortuous terrain, right itself from a fall, return to its charging port when its battery runs low and is compatible with a variety of add-ons, like 360 cameras. Spot is controlled via tablet and can be programmed to run on its own, allowing for increased worker and jobsite safety and productivity. Reprinted courtesy of Grace Arnold, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

---

New OSHA Rule Creates Electronic Reporting Requirement

June 22, 2016 — John K. Baker & Kevin Conrad – White and Williams LLP
The United States Occupational Safety and Health Administration (OSHA) issued a Final Rule revising portions of its Recording and Reporting Occupational Injuries and Illnesses regulations (Recording and Reporting Regulations). The revisions take effect August 10, 2016. Employers subject to the new requirements have until July 1, 2017 to submit electronically the required information for calendar year 2016. OSHA will make electronically-submitted workplace-safety data for each reporting employer available publicly in an online database. Reprinted courtesy of John K. Baker, White and Williams LLP and Kevin Conrad, White and Williams LLP Mr. Baker may be contacted at bakerj@whiteandwilliams.com Mr. Conrad may be contacted at conradk@whiteandwilliams.com Read the court decision
Read the full story...
Reprinted courtesy of

---

Complying With Data Breach Regulations in the Construction Industry

November 24, 2019 — Ryan Bilbrey - Construction Executive
Recent data breach incidents—like the massive Capital One cyberattack, where a former employee accessed more than 100 million customer accounts and credit card applications—have left many users questioning how safe their information really is in the hands of companies. There is reason to be concerned. More than 4.1 billion records were exposed in nearly 4,000 data breaches reported in the first half of 2019 alone, according to the 2019 MidYear QuickView Data Breach Report. Construction companies are not immune. As the industry becomes more reliant on technology—using augmented reality, Building Information Modeling and drones on construction sites, for example—construction companies are becoming greater targets for hackers looking to gain a financial or strategic advantage. Instead of assuming a company will never experience a breach (or rather, denying that it will ever happen), it’s important to be aware of possible threats and establish data breach response policies to minimize potentially catastrophic fallout. Reprinted courtesy of Ryan Bilbrey, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of
Mr. Bilbrey may be contacted at rbilbrey@biaprotect.com

---

Understand and Define Key Substantive Contract Provisions

March 23, 2020 — Phillip L. Sampson Jr. & Richard F. Whiteley, Construction Executive
The following contract provisions should be clearly understood before undertaking any construction project commences. Force Majeure Often referred to as an “Act of God,” a force majeure is an event, typically beyond the parties’ control, that prevents performance under a contract. To determine if a contractor need a force majeure clause in its contract, it should ask whether there may be instances where events beyond the contractor’s control could impact its contractual performance? If so, it will want this clause. Courts currently treat force majeure as an issue of contractual interpretation, focusing on the express language in the contract. Consequently, the scope and applicability of a force majeure clause depends on the contract’s terms. Using broad language in a force majeure clause may help protect against unforeseen events. But to the extent possible, parties should describe with particularity the circumstances intended to constitute a force majeure. The law relating to force majeure also fairly consistently provides that parties cannot avoid contractual obligations because performance has become economically burdensome. Courts have refused to apply force majeure clauses where an event only affects profitability. Recent attempts to categorize tariffs on construction materials as a force majeure have failed. Unless a tariff or tax is specifically listed as a force majeure event, it is unlikely to constitute a force majeure because it only affects profitability. Reprinted courtesy of Phillip L. Sampson Jr. & Richard F. Whiteley, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

---