Insurer Beware: Failure to Defend Ends with Hefty Verdict
June 01, 2011 —
Douglas Reiser, Builders Council BlogServed with a lawsuit that you turned over to your insurer? Insurer refusing to defend you? Well, find some hope in this news. Washington’s IFCA has the claws to ensure that insurers perform their duties.
Contractors heavily rely on the defense provisions of their Commercial General Liability (CGL) policies. In construction, a legal dispute can easily rear its head when you least expect it. Luckily, Washington registered contractors are required to maintain CGL insurance. That insurance often provides contractors with adequate legal defense in the event that they are sued.
But, what if your insurer turns down the defense request? They might be staring at massive damages. A current Reiser Legal client, Australia Unlimited, Inc., recently won a large verdict against Hartford Insurance, after the insurer unreasonably denied their claim. The firm who represented Australia Unlimited Inc. in that case, Hackett Beecher and Hart, were successful in procuring a $5.43 Million verdict
Read the full story…
Reprinted courtesy of Douglas Reiser of Reiser Legal LLC. Mr. Reiser can be contacted at info@reiserlegal.com
Read the court decisionRead the full story...Reprinted courtesy of
Courthouse Reporter Series: Louisiana Supreme Court Holds Architect Has No Duty to Safeguard Third Parties Against Injury, Regardless of Knowledge of Dangerous Conditions on the Project
July 31, 2024 —
Stu Richeson - The Dispute ResolverIn Bonilla v. Verges Rome Architects, 2023-00928 (La. 3/22/24); 382 So.3d 62, the Louisiana Supreme Court held because the terms of the agreement between the architect and the public owner did not give the architect responsibility for the means and methods of construction or for safety on the project, the architect did not have a duty to safeguard third parties against injury, regardless of whether the architect may have had knowledge of dangerous conditions on the project.
In Bonilla, the City of New Orleans entered into a contract for the renovation of a building owned by the city. The city also entered into an agreement with Verges Rome Architects (“VRA”) to serve as the project architect. The general contractor on the project subcontracted the demolition work to Meza Services, Inc. (“Meza”).
An employee of Meza was injured while attempting to demolish a “vault” on the project. The vault was a ten-foot by ten-foot cinderblock room with a nine-foot-high concrete slab ceiling located on the second floor of the building. The walls of the vault had been partially demolished when one of the employees of Meza was directed by his supervisor to stand on the ceiling of the vault with a jackhammer to continue the demolition. Shortly after beginning the task, the vault structure collapsed and caused the employee to suffer significant injury.
Read the court decisionRead the full story...Reprinted courtesy of
Stu Richeson, PhelpsMr. Richeson may be contacted at
stuart.richeson@phelps.com
Wake County Justice Center- a LEED Silver Project done right!
October 01, 2014 —
Melissa Dewey Brumback – Construction Law in North CarolinaYesterday evening, I had the privilege of attending the Triangle USGBC’s “Talk & Walk” at the Wake County Justice Center. The 576,996 square foot Justice Center was completed 6 months early and over 30 million under budget. (The final cost, including soft costs, came in at ~$141,000,000). Now that’s what I call a LEED project done right!
Interestingly, the County did not endeavor for a LEED Silver rating– the plan was to aim for a Certification. However, as the process unfolded, the Team kept meeting the goals and points for a Silver certification without any appreciable additional costs.
The end result? An “iconic but energy efficient building,” according to Tim Ashby, current Wake County Facilities Project Manager. Tim was initially involved in the Project while working at O’Brien Atkins, which served as the architecture firm for the Project under the direction of Architect Andrew Zwiacher.
Read the court decisionRead the full story...Reprinted courtesy of
Melissa Dewey Brumback, Construction Law in North CarolinaMs. Brumback may be contacted at
mbrumback@rl-law.com
Five Frequently Overlooked Points of Construction Contracts
October 18, 2021 —
Craig H. O'Neill - White and Williams LLPThere is no shortage of articles addressing the key points of construction contracts. Just enter that phrase into any internet search engine and you will find plenty. It should go without saying that a construction contract should be in writing, it should clearly identify the scope of work to be performed and the sums to be paid for that work, and it should address the parties’ rights and responsibilities with regard to termination or suspension of the contract, correcting defective work, and handling claims and disputes—just to name a few. Of course, these items should receive their due consideration. Too often, however, other important aspects of the construction contract get shortchanged. This article aims the spotlight on five often overlooked aspects of construction contracts.
Project Schedules
Surprisingly, many construction contracts pay little attention to a central component of any construction project: the project schedule. Many contracts provide the dates of commencement and substantial completion but not much else. With the frequent use of project management techniques such as the Critical Path Method (CPM) and the associated software, it is easier than ever to identify which tasks should be prioritized and identify potential areas of delay. The owner’s contract with the general contractor should clearly define the scheduling methods used and provide measures to keep the parties informed of the progress of the work. By including basic scheduling requirements in the contract documents—such as the submission of “Baseline Project Schedules” (consistent with the contract time provisions), “Schedule Progress Updates” (comparing the progress of the work against the Baseline Project Schedule), and “Schedule Recovery Plans” (when Schedule Project Updates indicate projected delays)—the parties can avoid or reduce disputes over project delays that often lead to litigation.
Read the court decisionRead the full story...Reprinted courtesy of
Craig H. O'Neill, White and Williams LLPMr. O'Neill may be contacted at
oneillc@whiteandwilliams.com
Construction Defects Checklist
July 18, 2018 —
Bremer Whyte Brown & O’MearaConstruction defects have existed since humans first began building structures, and will continue to be an occurrence into the future. For builder developers, contractors, and subcontractors, the specter of construction defects is a constant worry. Construction defect litigation is commonplace and can occur years after the construction project has been completed. This opens up an ongoing channel of risk and liability for construction contractors and project managers that are at risk of litigation far after they have completed a project. In this article, we’ll provide a helpful construction defects checklist that outlines the key avenues of risk and areas where construction defects litigation is most often focused. This checklist can help project managers, contractors, and subcontractors anticipate areas of their projects that may need extra attention or focus in order to ensure that they adhere to relevant local and state construction ordinances.
Gaining a greater understanding of what construction defects are can provide insight into how construction litigation can prove beneficial for structure owners or contractors who received substandard work. Many clients may not understand that they have an avenue to seek redress in cases where faulty workmanship may have resulted in economic damages or safety concerns in their home, building, or another construction project. Understanding the scope of what a construction defect is, and the areas that are most commonly litigated is helpful to understand when construction defect litigation is a viable option to pursue redress.
Read the court decisionRead the full story...Reprinted courtesy of
Bremer Whyte Brown & O’Meara
Georgia Court Rules that Separate Settlements Are Not the End of the Matter
October 14, 2013 —
CDJ STAFFThe Georgia Court of Appeals recently took up the question of how parties in a construction defect settlement relate to one another in terms of apportioning the settlement. Scott Murphy, writing on the Barnes & Thornburg blog clarifies the issues. The underlying construction defect case involved a newly-constructed hotel with mold and mildew problems. The owners sued the contractor (for negligent construction) and the architect (for negligent design). Separately, the owners settled with the contractor for $2.3 million and the architect for $100,000. Subsequently, the contractor sued the architect, attempting to recover part of the settlement the contractors had made with the owners.
At trial, the architect prevailed, obtaining a summary judgment that under Georgia law, “joint-tortfeasors can no longer assert contribution or non-contractual indemnity claims.” This was reversed by the Court of Appeals, determining that the two were not joint tortfeasors. Mr. Murphy notes that “the court rejected the parties’ attempt to disavow joint and several liability in their respective settlement agreements.” The court ruled that the contractor could proceed with their claims against the argument.
Read the court decisionRead the full story...Reprinted courtesy of
Arbitration and Mediation: What’s the Difference? What to Expect.
September 09, 2019 —
Brittany Rupley Haefele - Porter Law GroupMediation
Mediation is a process in which a neutral person or persons facilitate communication between the disputants to assist them in reaching a mutually acceptable settlement agreement. During this process, a neutral third party, with no decision-making power, intervenes in the dispute to help the litigants voluntarily reach their own agreement. Through a series of discussions, statements and private caucuses between the parties and the mediator, the process lets both parties negotiate and agree to a resolution with which everyone can abide. It is an excellent method of bringing a dispute to a conclusion without the further uncertainty and expense of litigation.
Arbitration
Arbitration, in addition to mediation, is one of the most common methods of alternative dispute resolution (“ADR”), whereby the parties bring a dispute before a disinterested third party who is typically selected by both parties. An arbitrator hears evidence presented by the parties, makes legal rulings, determines facts and makes an arbitration award. Arbitration awards may be entered as judgments in accordance with the agreement of the parties or, where there is no agreement, in accordance with California statutes. Arbitrations can be binding or non-binding, as agreed by the parties in writing. In most cases, the arbitrator’s decision is binding and final.
When is it Appropriate to Engage in Mediation and/or Arbitration?
Mediation can be held at any time, before or during a lawsuit. It is a voluntary process, where both sides simply agree to go to mediation in an effort to get the case settled. Sometimes, it is a contractually required process for the parties to complete prior to going to litigation or arbitration. Typically, in this situation, if a party ignores this requirement and fails to participate in a contractually mandated mediation, they will lose their rights to recover attorneys’ fees and costs – even if they ultimately prevail. Other times, mediation is strongly encouraged by the judge if a lawsuit has already been filed, and some would even say, ordered by the court (though it is typically not called “mediation” but something very similar like a “Dispute Resolution Conference” or “Mandatory Settlement Conference”).
Read the court decisionRead the full story...Reprinted courtesy of
Brittany Rupley Haefele, Porter Law GroupMs. Haefele may be contacted at
bhaefele@porterlaw.com
Quick Note: Steps to Protect and Avoid the “Misappropriation” of a “Trade Secret”
November 23, 2020 —
David Adelstein - Florida Construction Legal UpdatesFlorida’s Uniform Trade Secret Act (included in Florida Statute s. 688.001 en seq.) defines the terms “trade secret” and “misappropriation.” These definitions (found
here) are important in that just because 1) we deem something a trade secret does not, in of itself, make it so, and 2) we deem someone to have misappropriated a trade secret does not, in of itself, make it so.
If a party deems something to be a trade secret they should identify the document or paper as “confidential trade secret” as the first-step in preserving the confidentiality of that information. The party should also consider entering into an agreement with the party that may receive that information to maximize the protection of such confidential trade secret information during the parties’ agreement.
Read the court decisionRead the full story...Reprinted courtesy of
David Adelstein, Kirwin Norris, P.A.Mr. Adelstein may be contacted at
dma@kirwinnorris.com
