Court Denies Insurers' Motions for Summary Judgment Under All Risk Policies
June 05, 2017 —
Tred R. Eyerly - Insurance Law HawaiiThe federal district court found that the insurers could not escape coverage by summary judgment under their all risk policies. Eagle Harbour Condo Assoc'n v. Allstate Ins. Co., 2017 U.S. Dist. LEXIS 54761 (W.D. Wash. April 10, 2017).
Eagle Harbour Condominium Association sued several of its insurers who denied coverage for hidden water damage. Various insurers provided coverage from 1988 to 2015.
The Association asserted that wind-driven rain and inadequate construction allowed water to penetrate the buildings' sheathing and framing, causing decades of deterioration and decay, until the damage was exposed to view in August 2014. The insurers claimed that the loss resulted from poor decisions in constructing and inadequately maintaining a stucco building in the wet and windy Pacific Northwest. The Association argued that the policies did not explicitly exclude damage caused by wind-driven rain, so there was coverage.
Read the court decisionRead the full story...Reprinted courtesy of
Tred R. Eyerly - Insurance Law HawaiiMr. Eyerly may be contacted at
te@hawaiilawyer.com
Vaccine Mandate Confusion Continues – CMS Vaccine Mandate Restored in Some (But Not All) US States
January 03, 2022 —
David S. Harvey, Jr. & Sarah Hock - Lewis BrisboisTampa, Fla. (December 16, 2021) - As has been widely publicized, the Biden Administration has attempted to impose various forms of vaccine mandates under a variety laws and programs. At the same time, we have seen a flurry of opposition to these efforts ranging from new state laws (for example, in Florida) to court challenges seeking to enjoin the effort.
One of the federal mandates was issued by the Centers for Medicare & Medicaid Services (CMS) and is applicable to staff at Medicare- and Medicaid-certified healthcare providers. Initially, fourteen states sued in opposition to the CMS mandate and were able to obtain a nationwide injunction issued by a federal district judge in Louisiana. That injunction was appealed to the Fifth Circuit Court of Appeals, which has now issued a decision that awards points to both sides.
The Fifth Circuit ruled the injunction only applies to the 14 states that participated in the Louisiana lawsuit and not nationwide. Those states are Alabama, Arizona, Georgia, Idaho, Indiana, Kentucky, Louisiana, Mississippi, Montana, Ohio, Oklahoma, South Carolina, Utah, and West Virginia. This opinion has the potential to revive the CMS vaccine mandate in just over half of U.S. states. We can anticipate new suits will be filed as to other states, with the outcome still uncertain. It is unknown at this point whether the United States Supreme Court will agree to review the issues when such review is sought in the near future.
Reprinted courtesy of
David S. Harvey, Jr., Lewis Brisbois and
Sarah Hock, Lewis Brisbois
Mr. Harvey may be contacted at David.Harvey@lewisbrisbois.com
Ms. Hock may be contacted at Sarah.Hock@lewisbrisbois.com
Read the court decisionRead the full story...Reprinted courtesy of
Construction Defect Bill a Long Shot in Nevada
June 28, 2013 —
CDJ STAFFConstruction defect reform may still be on the table in Nevada, according to the Reno Gazette Journal. Assembly member Pat Hickey got a committee hearing for Assembly Bill 504 on Sunday. The bill is backed by the construction industry and opposed by trial lawyers. Hickey told the Assembly Commerce and Labor committee that “this bill is not perfect, I would like for it to do more,” and said that without changes Nevada will “continue to reward litigation over resolution.”
AB504 would, among other provisions, provide some protection to subcontractors from the actions of general contractors, though Ira Hansen, an assembly member from Sparks and the owner of a plumbing business, called it a “backhanded slap.” The Gazette noted that similar language pertaining to subcontractors was in AB367, which is sponsored by Democrats. Hickey and Hansen are both Republicans.
Read the court decisionRead the full story...Reprinted courtesy of
Killer Subcontract Provisions
January 20, 2020 —
Patrick McNamara - Porter Law GroupWe are frequently requested by subcontractor clients to review the subcontract that has been prepared by the prime contractor, before our client signs it. While no two agreements are identical, there are a number of problematic contract provisions that appear in many agreements. Here is a list of ten such provisions (and their variations) that are potential “deal breakers”:
- PAY IF/WHEN PAID (e.g. “Contractor shall have the right to exhaust all legal remedies, including appeals, prior to having an obligation to pay Subcontractor.”) “Pay-if-paid” provisions (“Receipt of payment from Owner shall be a condition precedent to Contractor’s duty to pay Subcontractor”) are illegal in California. However, the only legal limit on “Pay-When-Paid” provisions is that payment must be made “within a reasonable time.” The example above, as written, essentially affords the prime contractor a period of several years following completion of the project before that contractor has an independent duty to pay its subcontractors – not a “reasonable” amount of time, to those waiting to be paid. A compromise is to provide a time limit, such as 6 months or one year following substantial completion of the project.
- CROSS-PROJECT SET-OFF (e.g. “In the event of disputes or default by Subcontractor, Contractor shall have the right to withhold sums due Subcontractor on this Project and on any other project on which Subcontractor is performing work for Contractor.”) Such provisions are problematic and likely unenforceable, as they potentially bar subcontractors’ lien rights. Such provisions should be deleted.
- CONTRACTOR/SUBCONTRACTOR RESPONSIBILITY FOR DESIGN QUALITY (e.g. “Subcontractor warrants that the Work shall comply with all applicable laws, codes, statutes, standards, and ordinances.”) Unless a subcontractor’s scope of work expressly includes design work, this provision should either be deleted or modified, with the addition of the following phrase: “Subcontractor shall not be responsible for conformance of the design of its work to applicable laws, codes, statutes, standards, and ordinances.”
Read the court decisionRead the full story...Reprinted courtesy of
Patrick McNamara, Porter Law GroupMr. McNamara may be contacted at
pmcnamara@porterlaw.com
Banks Loosening U.S. Mortgage Standards: Chart of the Day
August 13, 2014 —
Jody Shenn – BloombergPerhaps more U.S. banks than at any time in two decades are making it easier to qualify for a mortgage.
The CHART OF THE DAY shows the net share of banks telling the Federal Reserve that they’re tightening standards in the home-loan market. In the central bank’s July survey of senior loan officers released last week, the net percentage for prime mortgages was negative 18.3 percent, by far the most loosening since it started asking the question by loan-quality category in 2007. It was also greater than the highest net share of banks easing in “all” mortgages in the 1990s or 2000s.
Still, lenders have a long way to go before they unwind the restrictions they imposed in the wake of the global financial crisis that risky home loans helped to create. The current trend is mainly about “small tweaks around the edges,” according to JPMorgan Chase & Co. mortgage-bond analysts.
Read the court decisionRead the full story...Reprinted courtesy of
Jody Shenn, BloombergMs. Shenn may be contacted at
jshenn@bloomberg.net
Study Finds San Francisco Bay is Sinking Faster than Expected
July 15, 2019 —
Alan Rider - Engineering News-RecordAll coastal cities in the U.S. face some potential threat from sea-level rise, but areas around San Francisco Bay may be more vulnerable than previously thought according to a recent study by Arizona State University’s Manoochehr Shirzaei and UC Berkley’s Roland Bürgmann published in the peer-reviewed journal Science Advances.
Read the court decisionRead the full story...Reprinted courtesy of
Alan Rider, ENRENR may be contacted at
ENR.com@bnpmedia.com
7 Areas where Technology is Shifting the Construction Business
November 21, 2018 —
Eric Weisbrot – JW Surety BondsThe digital transformation of the last two decades has taken hold of the business environment in a powerful way. Companies in nearly all sectors are experiencing a significant shift in the way business is done, with a heavy focus on improved productivity, increase profitability, and enhanced product and service offerings. The construction industry has been historically slow to update its processes and business models in-line with other industries, but technology is currently making its long-awaited appearance in the sector. Construction professionals can embrace these new solutions to run more efficient businesses and keep a closer eye on profitability by reducing
common costs over time.
These are the seven major areas where technology is changing construction.
1 - Business Management
One of the most apparent shifts taking place in the construction industry thanks to technology is the advancement of business processes and systems behind the scenes. Construction managers and job site owners have countless
digital tools at their fingertips to help with managing all aspects of the business. This includes more efficient ways to manage material use and equipment inventory, logging subcontractor hours and pay, and maintaining reporting requirements from regulatory perspectives. Many software solutions integrate with older, legacy systems, making this change an easy one for construction businesses across the board.
2 – Jobsite Productivity
Another area of transformation in construction is productivity on each job site. Technology has offered job owners and general contractors more efficient methods to keep track of project timelines as well as subcontractor progress from start to finish. The technology advancements in this arena come in the form of wearable devices that track work performed, as well as mobile devices that help keep the often mundane tasks necessary for a project’s success up to date and completed on time.
3 – Worker Safety
Although wearables are being utilized in several different ways in the construction business, these devices are making a significant difference in the safety of workers. From smart helmets to digitally enhanced eyewear, workers are alerted to potential hazards on the job that they otherwise could not identify. Similarly, augmented and virtual reality solutions are being used to train workers before they arrive at a job, preparing them for safety concerns well in advance. Even though most licensed and
bonded construction workers have appropriate training throughout their careers, the addition of these resources has the ability to further reduce the risks often associated with construction work.
4 – Surveying and Monitoring
Unmanned aerial vehicles, also known as
drones, are being used throughout construction. These digital tools are equipped with cameras to offer a bird’s eye view of a construction site to help with surveying and identifying potential hazards for workers. Drones also help with inspections throughout a project’s progression, offering some reduction in cost and improving efficiencies.
5 – Improved Materials
Technology is also playing a role in the materials used on job sites. The addition of 3D printing has proven beneficial for construction companies, as concrete composites, plastics, and other materials are being printed and used to create structures on-site. This offers a more cost-effective and accurate way to complete a project.
6 – Self-operating Equipment
Some technology firms are making waves in the construction industry because they are currently developing and implementing
autonomous equipment solutions. Heavy machinery, like excavators, bricklayers, and bulldozers, are already being used on construction sites to help ease the burden of the labor shortage in the industry. While these machines are not yet mainstream, the benefits they offer mean they are likely to become a staple in construction in the years to come.
7 – Big Data
Finally, technology is shifting the construction business by way of big data analytics. With the detailed information from new software solutions, wearable tech, and drones, construction site managers have more data than they have ever had. This influx of information offers a way to analyze job site progress, budgets, timelines, and efficiency for companies large and small.
Author:
Eric Weisbrot is the Chief Marketing Officer of
JW Surety Bonds. With years of experience in the surety industry under several different roles within the company, he is also a contributing author to the surety bond blog.
Read the court decisionRead the full story...Reprinted courtesy of
Construction Bright Spot in Indianapolis
March 01, 2012 —
CDJ STAFFThe downtown Indianapolis area is the site of about 85 major building projects that are from groundbreaking to just complete. The Indianapolis Star reports that the cumulative worth of the projects is about $3 billion, a level of construction that Indianapolis has seen only once before.
About thirty of the projects are residential. The main commercial project is a $754 million hospital building. The boom in downtown Indianapolis is not matched elsewhere, with the Indianapolis Star reporting that in the rest of Central Indiana, construction has slowed.
Read the full story…
Read the court decisionRead the full story...Reprinted courtesy of
