Columbus Ohio Building Expert Directory

Construction Delays: Which Method Should Be Used to Calculate Delay?

July 25, 2021 — David Adelstein - Florida Construction Legal Updates
If you need to prove and allocate construction project delays, you should engage a scheduling consultant qualified with CPM (critical path method) analysis. You should also engage counsel to assist in preserving your rights, as well as presenting and maximing your arguments for delay. There are numerous methodologies used to quantify and allocate delay. You want to discuss the most effective analysis for your case and facts including whether you want/should use a forward-looking prospective analysis or a backward-looking retrospective analysis that factors in as-built data. In doing so, you want to make sure you understand the pros and cons of each methodology including the bases to attack the methodology that will be subject to cross-examination. The five primary CPM methodologies are as follows:

As-Planned Versus As-Built. This methodology compares the as-planned baseline schedule to an as-built schedule reflecting progress to assign delay. An as-built schedule that reflects progress includes actual start dates, finish dates, and durations. The actual dates and durations are compared with the as-planned dates and durations on the baseline schedule to determine delay. Under this methodology, the delay impact is determined retrospectively.

Read the court decision
Read the full story...
Reprinted courtesy of David Adelstein, Kirwin Norris, P.A.
Mr. Adelstein may be contacted at dma@kirwinnorris.com

Contractor’s Coverage For Additional Insured Established by Unilateral Contract

November 18, 2011 — Tred R. Eyerly - Insurance Law Hawaii

The contractor was covered as an additional insured under the subcontractor’s policy even though the parties had never actually signed an agreement to add the contractor to the policy. Evanston Ins. Co. v. Westchester Surplus Lines Ins. Co., 2011 U.S. App. LEXIS 20081 (9th Cir. Oct. 3, 2011).

The policies held by Bellevue Master, the general contractor, required it to be an additional insured under any subcontractor’s liability policy. Northwest Tower Crane Services was a subcontractor. Bellevue Master LLC, faxed a message that Northwest could continue to be a subcontractor on the project if it complied with Bellevue Master’s insurance requirements. Northwest contacted its insurance broker and requested an insurance certificate be issued to Bellevue Master so that it would be an additional insured under Northwest’s policy.

Read the full story…

Reprinted courtesy of Tred R. Eyerly, Insurance Law Hawaii. Mr. Eyerly can be contacted at te@hawaiilawyer.com

Read the court decision
Read the full story...
Reprinted courtesy of

Tall Mass Timber Buildings Now Possible Under 2021 IBC Code Changes

February 03, 2020 — Kenneth Bland - Construction Executive
The International Code Council (ICC) has approved 17 changes to the 2021 editions of the International Building Code (IBC) and International Fire Code, allowing for mass timber buildings up to 18 stories. With the addition of three new mass timber construction types (Type IV-A, IV-B, and IV-C), this is the first time in the history of the modern building code that significantly new construction types have been added to the code. Building Materials The primary building material that makes tall mass timber (TMT) buildings possible is cross-laminated timber (CLT). CLT is manufactured from dimension lumber (nominal 2x lumber) laid side-by-side or mass plywood panels of a specified width. Laminations of lumber are typically laid perpendicular to each other to form panels of various thicknesses that are bonded together using heat resistant adhesives that cure in large hydraulic presses. CLT commonly consists of an odd number of laminations. These solid wood panels can be anywhere from 6 inches to 20 inches nominal thickness and 60 feet long. Typical CLT panels will be 6 inches to 14 inches nominal thickness. The panels are fabricated off site, transported onto the construction site and assembled in a manner that is efficient and remarkably fast. CLT panels can be used as floor, wall, or roof building elements supported by glued-laminated beams and columns. Reprinted courtesy of Kenneth Bland, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

Construction of World's Tallest Building to Resume With New $1.9B Contract for Jeddah Tower

October 28, 2024 — James Leggate - Engineering News-Record
Construction of the Jeddah Tower in Jeddah, Saudi Arabia—which is planned to be the world’s tallest building—is set to resume with original contractor Saudi Binladin Group Co. after a years-long pause, owner Jeddah Economic Co.'s parent company, Kingdom Holding Co., announced Oct. 2. Reprinted courtesy of James Leggate, Engineering News-Record Mr. Leggate may be contacted at leggatej@enr.com Read the full story... Read the court decision
Read the full story...
Reprinted courtesy of

Insurer’s “Failure to Cooperate” Defense

November 14, 2018 — David Adelstein - Florida Construction Legal Updates
The “failure to cooperate” defense is a defense an insurer may raise when its insured fails to cooperate with it in the defense of the claim against the insured. If an insurer takes this position, it will typically be denying both defense and indemnification obligations, meaning the insured could be forfeiting coverage that otherwise exists through his/her/its failure to cooperate with the insurer. This defense by the insurer is not absolute as recently explained by the Fourth District in Barthelemy v. Safeco Ins. Co. of Illinois, 43 Fla.L.Weekly D2379a (Fla. 4th DCA 2018) discussing the elements of this failure to cooperate defense. Read the court decision
Read the full story...
Reprinted courtesy of David Adelstein, Kirwin Norris
Mr. Adelstein may be contacted at dma@kirwinnorris.com

Bert L. Howe & Associates Brings Professional Development Series to Their San Antonio Office

March 28, 2014 — Beverley BevenFlorez-CDJ STAFF
Mirroring similar seminars currently provided in other regional markets, BHA’s Professional Development Series provides seminar attendees with a heightened level of knowledge and understanding on a wide range of subjects covering construction and construction defect litigation, tailored to the unique needs of local counsel and insureds. The first seminar in this series will be presented on May 9th, and is entitled THE RESIDENTIAL CONSTRUCTION PROCESS & CONSTRUCTION DEFECT LITIGATION. This course has been approved for Minimum Continuing Legal Education credit by the State Bar of Texas Committee on MCLE in the amount of 1.0 credit hours, of which 0.0 credit hours will apply to legal ethics/professional responsibility credit. The seminar will be presented by Don MacGregor, general contractor and project manager, at BHA’s San Antonio office during the noontime hour, and luncheon will be provided. As with all BHA Professional Development activities, there is no cost for participation. Water intrusion through doors, windows and roofing systems, as well as soil and foundation-related movement, and the resultant damage associated therewith, are the triggering effects for the vast majority of homeowner complaints today and serve as the basis for most residential construction defect litigation. The graphic and animation-supported workshop/lecture activity will focus on the residential construction process from site preparation through occupancy, an examination of associated damages most often encountered when investigating construction defect claims, and the inter-relationships between the developer, general contractor, sub trades and design professionals. Typical plaintiff homeowner/HOA expert allegations will be examined in connection with those building components most frequently associated with construction defect and claims litigation. The workshop will examine: * Typical construction materials, and terminology associated with residential construction * The installation process and sequencing of major construction elements, including interrelationship with other building assemblies * The parties (subcontractors) typically associated with major construction assemblies and components * The various ASTM standard testing protocols utilized to field test buildings * An analysis of exposure/allocation to responsible parties Attendance at THE RESIDENTIAL CONSTRUCTION PROCESS & CONSTRUCTION DEFECT LITIGATION seminar will provide the attendee with: * A greater understanding of the terms and conditions encountered when dealing with common construction defect issues * A greater understanding of contractual scopes of work encountered when reviewing construction contract documents * The ability to identify, both quickly and accurately, potentially responsible parties * An understanding of damages most often associated with construction defects, as well as a greater ability to identify conditions triggering coverage * Assistance in the satisfaction of important continuing education requirements. Course #: 901290467 / Sponsor #: 14152 To register for the event, please email Don MacGregor at dmac@berthowe.com. Read the court decision
Read the full story...
Reprinted courtesy of

Thank You for 17 Years of Legal Elite in Construction Law

December 16, 2023 — Christopher G. Hill - Construction Law Musings
Thank you once again to those in the Virginia legal community who elected me to the Virginia Business Legal Elite in the Construction Law category for the 17th consecutive year. The 17 consecutive years of election to the Legal Elite in the Construction Category span my entire close to 14 years as a solo construction attorney. The fact that you all have continued to elect “100%” of the lawyers at The Law Office of Christopher G. Hill, PC for the last 13 years is most gratifying and only confirms that my decision to “go solo” over 13 years ago was a good one. To be included in this list of top construction attorneys is both humbling and gratifying. For the complete list of the Virginia construction lawyers who were elected along with me, see the 2023 Virginia Business Legal Elite in Construction Law. Read the court decision
Read the full story...
Reprinted courtesy of The Law Office of Christopher G. Hill
Mr. Hill may be contacted at chrisghill@constructionlawva.com

Important Insurance Alert for Out-of-State Contractors Assisting in Florida Recovery Efforts!

November 01, 2022 — Richard W. Brown & Stephanie A. Giagnorio - Saxe Doernberger & Vita
Significant portions of Florida suffered extensive damage from Hurricane Ian. Many out-of-state contractors have sent their workers to Florida to help with the cleanup and rebuilding process. SDV is sending out this important notice for all out-of-state contractors to contact their workers’ compensation brokers and insurers to ensure their out-of-state workers’ compensation policy will cover workers in Florida. The state of Florida does not recognize the “All States Endorsement” on workers’ compensation policies, and in some instances could potentially result in out-of-state contractors being without coverage in the State of Florida. As per the Florida Division of Workers’ Compensation: “Out of State Employers must notify their insurance carrier that they are working in Florida. If there is no insurance, the out-of-state employer is required to obtain a Florida Workers’ Compensation Insurance policy with a Florida approved insurance carrier which meets the requirements of Florida law and the Florida Insurance Code. This means that ‘Florida’ must be specifically listed in Section 3A of the policy (on the Information Page).” Reprinted courtesy of Richard W. Brown, Saxe Doernberger & Vita and Stephanie A. Giagnorio, Saxe Doernberger & Vita Mr. Brown may be contacted at RBrown@sdvlaw.com Ms. Giagnorio may be contacted at SGiagnorio@sdvlaw.com Read the court decision
Read the full story...
Reprinted courtesy of

COLUMBUS OHIO BUILDING EXPERT DIRECTORY AND CAPABILITIES