Contractors Must Register with the L&I Prior to Offering or Performing Work, or Risk Having their Breach of Contract Case Dismissed
March 27, 2023 —
Jill Guingcangco - Ahlers Cressman & Sleight PLLCThe Washington State Legislature has an interest in protecting the public from “unreliable, fraudulent, financially irresponsible, or incompetent contractors” (RCW 18.27.140), which is why contractors are required to register with the Department of Labor and Industries (“L&I”) before advertising, offering to do work, or performing any work as a contractor. RCW 18.27.020. Accordingly, if a contractor brings an action for the collection of compensation or sues for breach of contract for work they performed, that individual is required to allege and prove that, at the time they performed the work, they were a registered contractor. RCW 18.27.080.
In
Dobson v. Archibald,1 Dobson worked as a longshoreman, but also simultaneously performed home repair work for pay during her off time. Dobson never registered as a contractor with L&I. Dobson acquired customers for her home repair work through a referral process. Dobson was referred to Archibald through a mutual friend who Dobson performed some home repair work for. Archibald subsequently hired Dobson to refinish the hardwood floors in Archibald’s home.
Read the court decisionRead the full story...Reprinted courtesy of
Jill Guingcangco, Ahlers Cressman & Sleight PLLCMs. Guingcangco may be contacted at
jill.guingcangco@acslawyers.com
The Importance of Preliminary Notices on Private Works Projects
September 03, 2019 —
William L. Porter - Porter Law GroupTime and time again I receive calls from subcontractors and suppliers who find themselves faced with a customer who is either unwilling or unable to pay for labor or materials supplied for a private works project. As an attorney, the first question I usually ask is “did you serve a Preliminary Notice?” The second question I usually ask is “did you serve the Notice within twenty (20) days after first furnishing labor, service, equipment or materials to the job site?” The answers to these questions will often determine the ability to collect on the claim.
The excuses for failing to serve the Preliminary Notice range from “for the last ten years the customer has always paid on time” to “I didn’t want to imply the contractor was not going to pay me” to “it is too much trouble to do on every job” or, simply, “I forgot”. Contractors and suppliers are well advised that any subcontractor or supplier who fails to properly and timely serve a Preliminary Notice is depriving itself of the most powerful tool available for compelling payment of construction related debt on a private works project. For all but the smallest contracts failure to serve the Preliminary Notice is also a violation of contractors’ license law and constitutes grounds for discipline by the Contractor State License Board, up to and including suspension of the contractor’s license.
Most of these rules are found in California Civil Code Section 8200-8216. The requirements of these sections are far too numerous to itemize here. Suffice it to say every contractor, subcontractor and construction material supplier to private construction projects should be familiar with these sections of the California Civil Code. They set forth most of the rules which relate to Preliminary Notices on private construction projects. Some of the most important features are as follows:
Read the court decisionRead the full story...Reprinted courtesy of
William L. Porter, Porter Law GroupMr. Porter may be contacted at
bporter@porterlaw.com
Florida District Court Finds That “Unrelated” Design Errors Sufficient to Trigger “Related Claims” Provision in Architects & Engineers Policy
March 02, 2020 —
Jason Taylor - Traub LiebermanMost professional liability polices include some form of a “related claims” provision that generally provides where two or more claims or wrongful acts are causally or logically related, they will be deemed to constitute a single claim. Importantly, these provisions typically provide that those “claims” are then deemed to have been “first made” at the time the first claim or act was committed for purposes of the policy’s claims-made and reporting requirements. Understandably, these provisions provide insurers and insureds with some clarity over the number and timing of claims that could involve multiple errors or omissions, and potentially aggregate all related claims or acts into a single policy period. While reasonable in principle, application of such provisions, especially involving large scale design and construction projects, is not always so easy.
Nova Southeastern University, Inc. v. Continental Cas. Co., 18-cv-61842 (S.D. Fla. Dec. 27, 2019), involved such an insurance coverage dispute with a design project gone wrong. DeRose Design Consultants, Inc. (“DeRose”) was hired as a structural engineer to design “ice tanks” to store and chill water for an energy efficient air conditioning facility constructed on the campus of Nova Southeastern University (“NSU”). An early water test on one of the tanks determined the walls of the ice tank deflected, leaked, and cracked when the tank was filled with water. DeRose later discovered that the problems with the ice tank were caused by a structural design error.
The first errors were discovered in early 2009, and reported under DeRose’s professional liability policy with Evanston. DeRose then created a remedial design to repair the tanks, which involved strengthening repairs. Additional leaking and an early indication of corrosion involving the Remedial Design arose as early as October 25, 2009. Several field investigation reports were prepared in 2011 and 2012 confirming these issues with the Remedial Design. A third report in February 2012, however, identified a new error involving the concrete slab under the ice tanks also designed by DeRose. The third report concluded that the concreate slab was overstressed and could not handle the loads of the ice tanks. The report also concluded, however, that the design defects in the concrete slab were “unrelated” to the original design defect of the ice tank walls or Remedial Design.
Read the court decisionRead the full story...Reprinted courtesy of
Jason Taylor, Traub LiebermanMr. Taylor may be contacted at
jtaylor@tlsslaw.com
Construction Spending Highest Since April 2009
October 25, 2013 —
CDJ STAFFThe Commerce Department has announced that construction spending has increased by 0.6 percent, but that modest gain puts it at the highest it has been in four and a half years. The last time construction spending was this high was April 2009.
The rise in construction spending is due to increases in both public and private construction project. Public construction was up, despite a decrease in spending by the federal government. Private residential construction is at a five-year high.
Read the court decisionRead the full story...Reprinted courtesy of
Water Damage: Construction’s Often Unnoticed Threat
November 02, 2020 —
Yaron Dycian - Construction ExecutiveFire damage to commercial buildings might get headlines, but water damage, whether to projects under construction or completed buildings, delivers massive financial blows to owners, developers and contractors. The impact is massive, reaching many billions of dollars per year. One water leak on the 19th floor at a construction site of a high-end apartment building in New York City resulted in $30 million in property damage and millions in delayed delivery penalties.
Imagine this all-too-typical scenario: A 20-story building has thousands of pipe connections and many tens of thousands throughout the entire building. It only takes one of those joints failing, perhaps due to human oversight. Early on a Saturday morning when no one is onsite, one of the connections inside a wall begins to leak, slowly at first. In a couple hours the connection fails completely, sending a cascade of water into the building. The site is located next to a highway, so the security guards don’t hear the water flowing.
The leak goes undetected until crews come back onsite on Monday morning. By that point, lower levels of the building have been inundated with thousands of gallons of water that has destroyed construction material, carpeting and electrical switchgear. It’s flowed into the elevator pits and mechanical room.
Reprinted courtesy of
Yaron Dycian, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved.
Read the court decisionRead the full story...Reprinted courtesy of
Mr. Dycian may be contacted at
yaron@wint.ai
Maui Wildfire Cleanup Could Cost $1B and Take One Year
September 18, 2023 —
James Leggate - Engineering News-RecordHawaii Gov. Josh Green and Sen. Brian Schatz (D-Hawaii) have estimated at $1 billion the cost of cleanup after the Maui wildfires—which started Aug. 8 and killed at least 115 people and destroyed more than 2,200 structures. Officials planning the rebuilding of the parts of West Maui
devastated by the wildfires are emphasizing safety and residents’ wishes over speed.
Reprinted courtesy of
James Leggate, Engineering News-Record
Mr. Leggate may be contacted at leggatej@enr.com
Read the full story... Read the court decisionRead the full story...Reprinted courtesy of
How Tech Is Transforming the Construction Industry in 2019
July 08, 2019 —
Ginger Butz - Construction ExecutiveThe immediate applications and benefits of Industrial Internet of Things technologies are obvious in industries like manufacturing and computing, but these digital transformation technologies may not be top of mind for construction managers.
It’s time for that mindset to change. Worldwide spending on IIoT is expected to reach nearly $2 trillion in 2022, proving that these technologies hold a significant amount of value to the industries using them. That rings especially true in construction, where IIoT stands to bolster an already significant commitment to safety and communication. Construction managers should keep these technologies firmly on the radar when making investments in 2019.
Smart equipment
With sensors and radio-frequency identification (RFID) tags, even legacy construction equipment can become part of a construction company’s IIoT fleet. The data collected from these machines provides construction managers with a wealth of knowledge around downtime, safety, labor, efficiency and more.
Additionally, the next era of smart construction equipment will feature more autonomous vehicles and automatic equipment shutdown, both of which promote worker safety. Autonomous vehicles, which self-correct based on feedback and environmental factors, also free up human engineers to move from maintenance tasks into more complex roles that leverage the feedback data reported by IIoT machinery.
Reprinted courtesy of
Ginger Butz, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved.
Read the court decisionRead the full story...Reprinted courtesy of
Ms. Butz may be contacted at
info@moreycorp.com
Lessee Deemed Statutory Employer, Immune from Tort Liability by Pennsylvania Court
November 03, 2016 —
Jerry Anders & Alison Russell – White and Williams LLPThe Superior Court of Pennsylvania addressed whether a lessee can be shielded from tort liability as a statutory employer and thus, immune from civil liability under the Workers’ Compensation Act. The court in Doman v. Atlas America, Inc. held that a primary contractor who leased property for the purposes of removing and drilling natural gas is a statutory employer under Section 302(a) of the Act and thus, entitled to tort immunity under Section 203 of the Act.
Reprinted courtesy of
Jerrold Anders, White and Williams LLP and
Alison Russell, White and Williams LLP
Mr. Anders may be contacted at andersj@whiteandwilliams.com
Ms. Russell may be contacted at russella@whiteandwilliams.com
Read the court decisionRead the full story...Reprinted courtesy of
