California Court of Appeal Holds That the Right to Repair Act Prohibits Class Actions Against Manufacturers of Products Completely Manufactured Offsite
February 06, 2019 —
Gus Sara - The Subrogation StrategistIn Kohler Co. v. Superior Court, 29 Cal. App. 5th 55 (2018), the Second District of the Court of Appeal of California considered whether the lower court properly allowed homeowners to bring class action claims under the Right to Repair Act (the Act) against a manufacturer of a plumbing fixture for alleged defects in the product. After an extensive analysis of the language of the Act, the court found that class action claims under the Act are not allowed if the product was completely manufactured offsite. Since the subject fixture was completely manufactured offsite, the Court of Appeal reversed the lower court’s decision. The court’s holding establishes that rights and remedies set forth in the Right to Repair Act are not available for class action claims alleging defects in products completely manufactured offsite.
In Kohler Co., homeowners instituted a class action against Kohler, the manufacturer of water pressure and temperature regulating valves that were installed into their homes during original construction. The class action was filed on behalf of all owners of residential dwellings in California in which these Kohler valves were installed as part of original construction. The complaint asserted, among other claims, a cause of action under the Act. Kohler filed a motion for anti-class certification on the ground that causes of actions under the Act cannot be certified as a class action. The trial court denied the motion with respect to the Act but certified its ruling for appellate review. Kohler filed a petition with the Court of Appeals, arguing that certain sections of the Act explicitly exclude class action claims under the Act.
Read the court decisionRead the full story...Reprinted courtesy of
Gus Sara, White and Williams LLPMr. Sara may be contacted at
sarag@whiteandwilliams.com
Hawaii Building Codes to Stay in State Control
March 01, 2012 —
CDJ STAFFThe Hawaii State Senate voted down Senate Bill 2692. Had it been passed, the State Building Code Council would have been abolished and building codes would have become the responsibility of county governments. The bill was opposed by the Insurance Institute for Business and Home Safety. Their director of code development, Wanda Edwards said that the bill “would have undermined key components that are essential to an effective state building code regime.”
Read the full story…
Read the court decisionRead the full story...Reprinted courtesy of
No Coverage for Construction Defects Under Arkansas Law
January 13, 2017 —
Tred R. Eyerly - Insurance Law Hawaii The federal district court found there was no coverage for the insured contractor under Arkansas law when sued for construction defects by two homeowners. Auto-Owners Ins. Co. v. Hambuchen Constr., 2016 U.S. Dist. LEXIS 160364 (W.D. Ark. Nov. 18, 2016).
In one case, the Pierces hired Hambuchen, the insured contractor for the construction of a new home, which was completed in 2006. Two years after moving in, the Pierces experienced water leaks at various locations inside the home and the basement flooded. Water damage rendered the back deck unstable. In 2010 and 2011, Hambuchen made repairs to stop leaks on the decks, but in 2012 the back deck again showed signs of water damage. The Pierces sued, and Auto-Owners provided a defense under a reservation of rights.
In the second case, the Lessmanns hired Hambuchen in 2005 as general contractor to construct their new home. Following completion of the home, the Lessmanns complained about scratched windows. The Lessmanns filed suit against Hambuchen for breach of the construction contract by failing to build their home in a workmanlike manner. The Lessmanns filed suit in May 2009. Auto-Owners was not aware of the suit until 2015 when it received notice that the Lessmanns had filed an amended complaint. The Lessmans' suit went to trial and Hambuchen prevailed.
Read the court decisionRead the full story...Reprinted courtesy of
Tred R. Eyerly, Insurance Law HawaiiMr. Eyerly may be contacted at
te@hawaiilawyer.com
No Coverage for Defects in Subcontrator's Own Work
February 11, 2019 —
Tred R. Eyerly - Insurance Law HawaiiDamage to the concrete floor installed by the insured subcontractor was not property damage and thus not covered under the insured's CGL policy. Kalman Floor Co. v. Old Republic Gen. Ins. Corp., 2019 U.S. Dist. LEXIS 3319 (D. Colo Jan. 8, 2019).
In 2007, Kalman Floor Co. was subcontracted to construct over 158,000 square feet of concrete flooring for a cold storage facility. The concrete floor was completed in late 2008. In late 2009, the contractor notified Kalman that pockmarks, or "pop-outs," were visible on the concrete flooring. The only damage to tangible property in the facility caused by the pop-outs was the concrete flooring itself.
On January 31, 2009, Old Republic issued a general liability policy to Kalman for one year. The policy excluded for damage to "your work," defined as "work or operations performed by you or on your behalf." Old Republic denied coverage for damage to the concrete floor. Kalman sued, seeking a declaration that the exclusions did not bar coverage.
Read the court decisionRead the full story...Reprinted courtesy of
Tred R. Eyerly, Damon Key Leong Kupchak HastertMr. Eyerly may be contacted at
te@hawaiilawyer.com
Checking the Status of your Contractor License During Contract Work is a Necessity: The Expanded “Substantial Compliance” under B&P 7031 is Here
June 05, 2017 —
Ivo G. Daniele – Newmeyer & Dillion LLP News AlertIt is paramount that a contractor diligently maintains its license prior to and during the performance of any contract work. Failure to do so could result in barring a contractor from receiving payment and/or disgorgement of profits received under the construction contract.
California Business and Professions Code section 7031 is part of the Contractors State License Law (Business & Prof. section 700 et seq.), and is both feared and loathed by all contractors performing work in the state of California. This draconian statute is known as the “Shield” and was enacted over 70 years ago for the singular purpose to bar all actions by contractors seeking compensation for unlicensed contract work – even precluding a contractor from enforcing his or her mechanic’s lien rights. However, a contractor could potentially avoid the harshness of B&P 7031 by establishing that he or she had substantially complied with the appropriate licensing requirements.
SUBSTANTIAL COMPLIANCE WITH LICENSE REQUIREMENTS PRIOR TO 2017 AMENDMENT
The substantial compliance exception is found in section B&P 7031(e), which authorizes the court to determine that there has been substantial compliance with licensure requirements, if the contractor has shown at an evidentiary hearing that he or she engaged in the unlicensed work had:
- Been duly licensed as a contractor in this state prior to the performance of the act or contract;
- Acted reasonably and in good faith to maintain the license;
- Did not know or reasonably should not have known that he or she was not licensed when he or she performed the work; and
- Acted promptly and in good faith to reinstate the license once it learned the license had lapsed.
Although not impossible, satisfying all four requirements of the exception was challenging for the contractor, specifically, requirement # (3) – the lack of knowledge that he or she was unlicensed during performance of work.
SUBSTANTIAL COMPLIANCE POST 2017
Fortunately, Governor Brown heard the collective cry for relief and signed Assembly Bill 1793 (“AB 1793”) into law. The new bill revises the criteria for the court to determine if a contractor is in substantial compliance with the licensing requirements by deleting requirement # (3) in its entirety and modestly amending requirement # (4) to require the contractor to act promptly and in good faith to remedy the failure to comply with the licensure requirements upon learning of the failure.
As a result, the substantial compliance exception under B&P 7031(e) reads as follows:
(e) The judicial doctrine of substantial compliance shall not apply under this section where the person who engaged in the business or acted in the capacity of a contractor has never been a duly licensed contractor in this state. However, notwithstanding subdivision (b) of Section 143, the court may determine that there has been substantial compliance with licensure requirements under this section if it is shown at an evidentiary hearing that the person who engaged in the business or acted in the capacity of a contractor
(1) had been duly licensed as a contractor in this state prior to the performance of the act or contract, (2) acted reasonably and in good faith to maintain proper licensure, and (3) acted promptly and in good faith to remedy the failure to comply with the licensure requirements upon learning of the failure.
This new legislation has tempered the burden of proof born by the contractor in establishing substantial compliance, although be it minor in its modification, the fact of the matter remains the same – be diligent in maintaining your license during all phases of contract work.
Ivo Daniele is a seasoned associate in the Walnut Creek office focusing his practice on commercial transactions and business and construction litigation. For questions regarding California Business and Professions Code section 7031, please feel free to contact Ivo Daniele at (925) 988-3222 or ivo.daniele@ndlf.com.
About Newmeyer & Dillion
For more than 30 years, Newmeyer & Dillion has delivered creative and outstanding legal solutions and trial results for a wide array of clients. With over 70 attorneys practicing in all aspects of business, employment, real estate, construction and insurance law, Newmeyer & Dillion delivers legal services tailored to meet each client’s needs. Headquartered in Newport Beach, California, with offices in Walnut Creek, California and Las Vegas, Nevada, Newmeyer & Dillion attorneys are recognized by The Best Lawyers in America©, and Super Lawyers as top tier and some of the best lawyers in California, and have been given Martindale-Hubbell Peer Review's AV Preeminent® highest rating. For additional information, call 949-854-7000 or visit www.ndlf.com.
Read the court decisionRead the full story...Reprinted courtesy of
BIM Legal Liabilities: Not That Different
February 10, 2020 —
Christopher G. Hill - Construction Law MusingsFor this week’s Guest Post Friday here at Musings, we welcome Scott P. Fitzsimmons. Scott is an attorney with the construction law firm Watt, Tieder, Hoffar & Fitzgerald, where he represents contractors, subcontractors, owners, and engineers. He is also a LEED AP and an instructor for AGC of D.C., where he teaches BIM Contract Negotiation and Risk Allocation as part of AGC’s Certificate of Management, Building Information Modeling program.
When a new technology is introduced to the construction industry, contractors inevitably ask themselves one question “Great, how can this new gadget get me into trouble?” Building Information Modeling (BIM) is exactly the kind of technology that raises this fear. But, BIM has been around for a few years now, and the construction industry has done a good job of curtailing the fear of unanticipated legal liability.
Nevertheless, contractors should be aware of the pitfalls BIM introduces and should know how to limit their risk arising from this new “gadget.”
Often described as “CAD on Steroids,” BIM is truly much more than a simple design program. Along with early clash detection, BIM provides time and cost integration; calculates energy efficiency; and assists building maintenance long after project completion. Unlike CAD, BIM also modifies the collaborative nature of a construction project. Thus, subcontractors no longer review a design, submit shop drawings, and go to work. Rather, subcontractors are brought into the design process early in the project and often are asked to contribute to the design long before construction begins.
Asking a contractor or subcontractor to provide design services appears to shift the roles of an architect and a contractor. So, the questions abound: Is a contractor now responsible for design? Can the contractor be held responsible for defective design? Do not fret. To date, there has been only one advertised case addressing BIM liability. The reason is simple. For almost a hundred years, the United States Supreme Court has held that contractors are not responsible for defective design on a traditional design-bid-build project. Using BIM, therefore, should not modify a contractor’s responsibility. But, to ensure that your obligations do not extend beyond construction, all BIM requirements should be in writing and made part of your contract.
Read the court decisionRead the full story...Reprinted courtesy of
The Law Office of Christopher G. HillMr. Hill may be contacted at
chrisghill@constructionlawva.com
SFAA Commends U.S. Senate for Historic Bipartisan Infrastructure Bill
August 16, 2021 —
The Surety & Fidelity Association of AmericaAugust 10, 2021 (WASHINGTON, DC) –
The Surety & Fidelity Association of America (SFAA) commends the U.S. Senate for passing the historic, bipartisan Infrastructure Investment and Jobs Act. The $1.2 trillion deal will lay the foundation for extensive improvements in the nation’s roadways, bridges, railways, waterways and broadband access.
“Investing in infrastructure will create millions of jobs across the country, growing our national and local economies in both the short and long term,” said SFAA president and CEO, Lee Covington. “The surety industry fully supports this investment and will continue to provide the essential protections necessary to support our country’s infrastructure needs through our suite of products and services.”
SFAA also commends the inclusion of the Van Hollen 2354 amendment to the bill, accepted by a unanimous vote of 97-0. The amendment requires payment and performance bonds on all federally-financed infrastructure projects receiving loans and grants under the Transportation Infrastructure Finance and Innovation Act (TIFIA), protecting taxpayers’ dollars, ensuring project completion, protecting local small business contractors and workers, and promoting economic growth.
The Surety & Fidelity Association of America (SFAA) is a trade association of more than 425 insurance companies that write 98 percent of surety and fidelity bonds in the U.S. SFAA is licensed as a rating or advisory organization in all states and it has been designated by state insurance departments as a statistical agent for the reporting of fidelity and surety experience. https://www.surety.org/
Read the court decisionRead the full story...Reprinted courtesy of
North Carolina Weakened Its Building Codes in 2013
October 09, 2018 —
Ari Natter - BloombergFive years ago, encouraged by home builders and an anti-regulatory zeal, lawmakers in North Carolina joined other states in weakening building code requirements.
It’s a decision they may regret as Hurricane Florence takes aim at the Carolinas.
The Legislature in 2013 increased the amount of time between updates to its building code from three years to six. That means that updates that set new standards for elevating the floors in flood-prone homes aren’t in effect, according to the Federal Alliance for Safe Homes Inc., a non-profit disaster safety organization.
Read the court decisionRead the full story...Reprinted courtesy of
Ari Natter, Bloomberg
