When Is Mandatory Arbitration Not Mandatory?
August 19, 2015 —
Christopher G. Hill – Construction Law MusingsI have discussed my views on mandatory mediation in construction contracts at other places here at Musings and also discussed how the contract is king here in Virginia. A recent Charlottesville, Virginia Circuit Court case combined these two concepts to allow a subcontractor to proceed straight to litigation despite various ADR provisions in the contract between it and the general contractor.
In ProBuild v. DPR & Continental Casualty, the Court looked at a series of ADR steps that were to be followed in the contract between the parties in order to allow DPR, the general contractor to require arbitration as opposed to litigation. The Court considered the surety’s motion to stay the litigation against it pending arbitration between ProBuild and DPR.
In ProBuild, the Court looked at a contractual provision that provided certain steps to be followed in the event of a dispute, starting with a notice of dispute, followed by negotiation, followed by mediation should the disputing party request it, and in the event that mediation was tried and failed, the disputing party or general contractor could require arbitration. The Court determined that ProBuild, the subcontractor, was the disputing party under the contract, had pursued unsuccessful formal negotiations and that neither ProBuild nor DPR requested mediation. The Court then held that because unsuccessful mediation was a prerequisite to required arbitration and because mediation was never pursued, the mandatory arbitration clause did not apply.
Read the court decisionRead the full story...Reprinted courtesy of
Christopher G. Hill, Law Office of Christopher G. Hill, PCMr. Hill may be contacted at
chrisghill@constructionlawva.com
Property Damage to Insured's Own Work is Not Covered
May 27, 2019 —
Tred R. Eyerly - Insurance Law HawaiiThe Michigan Court of Appeals found there was no coverage for a lawsuit filed against the insureds for faulty workmanship. Skanska United States Bldg. v M.A.P. Mech. Contrs., 2019 Mich App. LEXIS 529 (Mich. Ct. App. March 19, 2019).
Contractor Skanska United States Building was the construction manager on a renovation project for the medical center. The heating and cooling portion of the project was subcontracted to M.A.P. Mechanical Contractors (MAP). MAP had a CGL policy from Amerisure Insurance Company. Skanska and the medical center were named as additional insureds on the policy.
After installation of the steam boiler and related piping, it was discovered that the heating system did not function property. Skanska discovered that MAP had installed some of the expansion joints backward, causing damage to concrete, steel, and heating system. The medical center sent a demand to MAP. Skanska performed the repairs and replaced the damaged property. Skanska then submitted a claim to Amerisure, which was denied.
Read the court decisionRead the full story...Reprinted courtesy of
Tred R. Eyerly, Damon Key Leong Kupchak HastertMr. Eyerly may be contacted at
te@hawaiilawyer.com
Not All Work is Covered Under the Federal Miller Act
May 24, 2021 —
David Adelstein - Florida Construction Legal UpdatesThe recent opinion out of the Eastern District Court of Virginia, Dickson v. Forney Enterprises, Inc., 2021 WL 1536574 (E.D.Virginia 2021), demonstrates that the federal Miller Act is not designed to protect ALL that perform work on a federal construction project. This is because NOT ALL work is covered under the Miller Act.
In this case, a professional engineer was subcontracted by a prime contractor to serve on site in a project management / superintendent capacity. The prime contractor’s scope of work was completed by January 31, 2019. However, the prime contractor was still required to inventory certain materials on site, which was performed by the engineer. The engineer claimed it was owed in excess of $400,000 and filed a Miller Act payment bond lawsuit on February 5, 2020 (more than a year after the project was completed).
Read the court decisionRead the full story...Reprinted courtesy of
David Adelstein, Kirwin Norris, P.A.Mr. Adelstein may be contacted at
dma@kirwinnorris.com
Builders Beware: Smart Homes Under Attack by “Hide ‘N Seek” Botnet
October 30, 2018 —
Scott L. Satkin & Amtoj S. Randhawa - Newmeyer & Dillion LLPGerman manufacturer eQ-3 has found itself under siege by a botnet known as "Hide 'N Seek." This pernicious malware has infected tens of thousands of eQ-3's smart home devices by compromising the device's central control unit. Once a device has been infected, the malware spreads to other Internet of Things ("IoT") devices connected to the same wireless network. IoT devices have become the prime target for botnet attacks. As opposed to computers, laptops, or other larger computing devices, the smaller storage capacity and lower processing power of IoT devices limit the amount and complexity of the security measures that can be installed—making them an easier target for botnets.
What is a Botnet?
For those unfamiliar with the term, a botnet is a network of devices infected with a malware program allowing the infector to control and/or exploit the devices. Once a suitable number of devices are infected, the person or group controlling the botnet can harness the computing power of each infected device to perform activities which were previously constrained by a single device's capabilities (i.e. DDoS attacks, spamming, cryptocurrency mining, etc.).
Hide 'N Seek – History and Capabilities
The Hide 'N Seek botnet first appeared in January 2018 and has since spread rapidly. Its sophisticated design and capabilities have captivated the attention of many security watchdogs and researchers. While many botnets are designed to be "quick and dirty" (i.e. infect a few devices, eke out a little profit, and inevitably be cleared out or rendered ineffective by security updates and fixes), Hide 'N Seek was designed to maintain itself in the host's system indefinitely. When it was first released, Hide 'N Seek primarily targeted certain routers and internet-enabled security cameras; however, it has now began targeting digital video recorders, database servers, and most recently, smart home hubs.
Hide 'N Seek's communication capabilities are also more advanced than previous botnets. Previous botnets relied on existing communications protocols to communicate with other another, but Hide 'N Seek uses a custom-built peer-to-peer system to communicate. This advancement allows Hide 'N Seek to spread more rapidly than previous botnets.
Hide 'N Seek is also capable of extracting a device owner's personal information (i.e. name, address, e-mail, telephone numbers, etc.) whereas previous botnets were not. Most importantly, Hide 'N Seek is consistently updated to increase its infection rate, decrease its detection probability, and bypass any security measures designed to detect and remove it from the system. This modularity has proved to be Hide 'N Seek's greatest strength.
Protecting Against Hide 'N Seek and Other Botnets
While many of the precautions will undoubtedly come from the device manufactures vis-à-vis software programming and updates, homebuilders can still take some precautions to protect their customers.
- When selecting a smart home system to incorporate into a home's construction, be sure to evaluate its security features including, but not limited to its: wireless connectivity, password/passphrase requirements, interconnectedness with other IoT devices, etc. Third-party reviews from tech-oriented outlets will likely have useful information on a device's security measures, vulnerabilities, and any recent security compromises.
- Be vigilant in installing any eQ-3 smart home systems. The extent of the damage caused by Hide 'N Seek botnet remains unknown, as does damage from other potentially-infected technology. Thus, it may be prudent to avoid installing any eQ-3 device until it becomes evident that the threat has been neutralized and all security vulnerabilities have been remedied.
- If a builder uses technology other than eQ-3, precautions must be taken. Ensure that technology providers are thoroughly researched. It is also recommended to include strong contractual indemnity provisions, and require vendors to carry cyber-specific insurance policies.
- Homebuilders should consider purchasing their own stand alone cyber liability policies as a safety net, should potential exposure arise.
Scott Satkin and Amtoj Randhawa are associates in the Cybersecurity group of Newmeyer & Dillion. Focused on helping clients navigate the legal dispute implications of cybersecurity, they advise businesses on implementing and adopting proactive measures to prevent and neutralize cybersecurity threats. For questions on how they can help, contact Scott at scott.satkin@ndlf.com and Amtoj at amtoj.randhawa@ndlf.com.
Read the court decisionRead the full story...Reprinted courtesy of
Fourth Circuit Clarifies What Qualifies As “Labor” Under The Miller Act
May 08, 2023 —
Jeffrey Hummel - The Construction SeytUnder the Miller Act, 40 U.S.C. §§ 3131 et seq., contractors hired to work on federal construction projects are required to furnish payment bonds in order to ensure payment to certain persons that provide labor for the project. The United States Court of Appeals for the Fourth Circuit recently issued a published decision clarifying the type of work that qualifies as “labor” under the Miller Act. Elliot Dickson v. Fidelity and Deposit Company (issued April 26, 2023).
In that case, the U.S. Department of Defense hired Forney Enterprises (Forney) as the prime contractor on a renovation project at the Pentagon. Forney retained Fidelity and Deposit Company of Maryland (Fidelity) to provide the required Miller Act payment bond. Forney then entered into a subcontract with Elliott Dickson (Dickson), a professional engineer, to work as a project manager on the contract. Dickson primarily supervised labor on the site, but also performed other tasks, including logistical and clerical duties, taking various field measurements, cleaning the worksite, moving tools and materials, and sometimes even watering the concrete himself. Dickson’s work required him to be onsite on a daily basis.
Read the court decisionRead the full story...Reprinted courtesy of
Jeffrey Hummel, SeyfarthMr. Hummel may be contacted at
jhummel@seyfarth.com
Will a Notice of Non-Responsibility Prevent Enforcement of a California Mechanics Lien?
August 06, 2019 —
William L. Porter - Porter Law GroupThe “Notice of Non-Responsibility” is one of the most misunderstood and ineffectively used of all the legal tools available to property owners in California construction law. As a result, in most cases the answer to the above question is “No”, the posting and recording of a Notice of Non-Responsibility will not prevent enforcement of a California Mechanics Lien.
The mechanics lien is a tool used by a claimant who has not been paid for performing work or supplying materials to a construction project. It provides the claimant the right to encumber the property where the work was performed and thereafter sell the property in order to obtain payment for the work or materials, even though the claimant had no contract directly with the property owner. When properly used, a Notice of Non-Responsibility will render a mechanics lien unenforceable against the property where the construction work was performed. By derailing the mechanics lien the owner protects his property from a mechanics lien foreclosure sale. Unfortunately, owners often misunderstand when they can and cannot effectively use a Notice of Non-Responsibility. As a result, the Notice of Non-Responsibility is usually ineffective in protecting the owner and his property.
The rules for the use of the Notice of Non-Responsibility are found in California Civil Code section 8444. Deceptively simple, the rules essentially state that an owner “that did not contract for the work of improvement”, within 10 days after the owner first “has knowledge of the work of improvement”, may fill out the necessary legal form for a Notice of Non-Responsibility and post that form at the worksite and record it with the local County Recorder in order to prevent enforcement of a later mechanics lien on the property.
Read the court decisionRead the full story...Reprinted courtesy of
William L. Porter, Porter Law GroupMr. Porter may be contacted at
bporter@porterlaw.com
With an Eye Already in the Sky, Crane Camera Goes Big Data
February 02, 2017 —
Jeff Rubenstone - Engineering News-RecordIt started simple enough: a wireless camera mounted on the hook block of a tower crane, allowing the operator in the cab to see the rigger on the ground and the area around the hook. But just a few years later, Netarus’ HoistCam is part of a method to generate point-cloud images of jobsites from the highest perch around.
Read the court decisionRead the full story...Reprinted courtesy of
Jeff Rubenstone, ENRMr. Rubenstone may be contacted at
rubenstonej@enr.com
Grenfell Fire Probe Faults Construction Industry Practices
November 28, 2022 —
Peter Reina - Engineering News-Record"Incompetence and poor practices in the construction industry" and among others led to the June 2017 fire at London's Grenfell residential high-rise building, causing 72 deaths, according to the lead counsel for the public inquiry that ended Nov. 10.
Reprinted courtesy of
Peter Reina, Engineering News-Record
Mr. Reina may be contacted at reina@btinternet.com
Read the full story... Read the court decisionRead the full story...Reprinted courtesy of
