Columbus Ohio Building Expert Directory

Construction Problems May Delay Bay Bridge

May 10, 2013 — CDJ STAFF
Faulty bolts could lead to a delay in the opening of the Bay Bridge. Caltrans noticed problems with bolts and found that the bolts had cracked. Of the 98 bolts already tightened, 30 have failed. According to the San Francisco Chronicle, workers will be tightening all 288 bolts and then testing them. According to Tony Anziano, Caltrans’s toll bridge program manager, repairs could take one or two months. Mr. Anziano noted that the manufacturer might be responsible for part of the expense, but that the budget for the bridge also has funds set aside for unanticipated repairs. The bolts were supplied by Dyson, an Ohio company, but it was clear whether Dyson manufactured the bolts or simply marketed them. Read the court decision
Read the full story...
Reprinted courtesy of

Grupo Mexico Spill Sparks Public Scrutiny of $150 Million Mop-Up

September 17, 2014 — Nacha Cattan – Bloomberg
Mexico is sending federal officials to Sonora state to oversee Grupo Mexico SAB (GMEXICOB)’s $150 million cleanup of a copper mine spill that the government says contaminated the water supplies of at least 24,000 people. The special commission of environmental and agriculture ministry officials will monitor the company’s pledge to clean Mexico’s worst mining spill, which occurred Aug. 6 in the northern state that borders Arizona. Grupo Mexico said last week it would create a $150 million trust after its Buenavista del Cobre operation dumped 11 million gallons of copper sulfate solution into two Sonora rivers. Industrias Bachoco SAB de CV and Ford Motor Co. (F) operate plants in Hermosillo, south of the contaminated waterways. Read the court decision
Read the full story...
Reprinted courtesy of Nacha Cattan, Bloomberg
Ms. Cattan may be contacted at ncattan@bloomberg.net

Settlement Reached in Bridge Failure Lawsuit

December 11, 2013 — CDJ STAFF
Officials claimed the failure of a bridge in Afton Township, Illinois was because trucks owned by Welded Construction used the bridge despite exceeding the bridge’s weight limit of 36.5 tons. The firm argued that they should be responsible for the depreciated cost of the bridge, not its replacement cost. Welded Construction had been using the bridge to get to the site of an oil pipeline construction project for Enbridge Energy. Replacement of the bridge was initially estimated at $933,000, but that was in advance of any design work. Enbridge Energy settled the case at $900,000, which should cover most or all of the cost of repair or replacement. Some federal funds may also be available for repairing or constructing a new bridge. Read the court decision
Read the full story...
Reprinted courtesy of

ASHRAE Approves Groundbreaking Standard to Reduce the Risk of Disease Transmission in Indoor Spaces

July 10, 2023 — ASHRAE
ATLANTA, June 27, 2023 (GLOBE NEWSWIRE) -- ASHRAE announced the approval for publication of its highly anticipated standard to reduce the risk of airborne infectious aerosol transmission in buildings, bringing numerous benefits to occupants and promoting healthier environments. ASHRAE Standard 241, Control of Infectious Aerosols establishes minimum requirements to reduce the risk of disease transmission by exposure to infectious aerosols in new buildings, existing buildings, and major renovations. Infectious aerosols are tiny, exhaled particles that can carry pathogens that cause infections or disease. These particles are so small that they can remain in the air for long periods of time. Use of this standard could reduce exposure to the SARS-COVID-2 virus, which causes COVID-19, the flu virus and other pathogens. Standard 241 provides requirements for many aspects of air system design, installation, operation, and maintenance. Standard 241 available now for presale in the ASHRAE Bookstore. About ASHRAE Founded in 1894, ASHRAE is a global professional society committed to serve humanity by advancing the arts and sciences of heating ventilation, air conditioning, refrigeration, and their allied fields. For more information and to stay up-to-date on ASHRAE, visit ashrae.org and connect on Instagram, LinkedIn, Facebook, Twitter and YouTube. Read the court decision
Read the full story...
Reprinted courtesy of

Limiting Services Can Lead to Increased Liability

December 16, 2019 — Christopher G. Hill - Construction Law Musings
For this week’s Guest Post Friday Musings, we welcome Nick Pacella. Nick is an architect licensed in New York, New Jersey and Connecticut. His practice has spanned several economic swings and he has been able to reposition the eggs in his basket to make the most of each recovery. He is currently focusing on adapting existing commercial buildings to take advantage of materials and processes that promote improved energy efficiency for both the owner and the tenants. For a more colorful rendition of projects you can visit his company’s website. I remember as a kid when the attendant at gas stations would not only clean your windows but also check the oil level of your vehicle as it was filling up with $0.25 per gallon gas. (I did say that I have seen several economic swings) These services have mostly disappeared, and to no great effect to your car since most cars go much longer between oil changes. Other than a slightly dirtier windshield it hasn’t affected your ability to drive and maintain your car. This is not so with professional services. Architects used to include many services that are now sourced to others. Project Management, Owner’s Representatives and Program Managers now populate the landscape. In many cases they came to be because architects either did not provide the service their client’s were looking for or they allowed themselves to be put into an adversarial relationship with their clients. They were likened to foxes watching the chicken coop, especially for project management and owners representative services. Client’s have had others buzzing in their ears “are architects really going to look out for my interests above theirs?’” Of course the clients never ask if the new wave will do any better at rallying behind their interests. Read the court decision
Read the full story...
Reprinted courtesy of The Law Office of Christopher G. Hill
Mr. Hill may be contacted at chrisghill@constructionlawva.com

DHS Awards Contracts for Border Wall Prototypes

September 20, 2017 — Engineering News-Record
The Dept. of Homeland Security has awarded eight contracts to companies to develop prototypes for the Trump administration’s proposed wall along sections of the nearly 2,000-mile U.S.-Mexico border. The contracts are divided evenly between concrete and nonconcrete options. DHS’s Customs and Border Protection agency didn’t specify what sort of materials would be used in the nonconcrete barriers. Read the court decision
Read the full story...
Reprinted courtesy of Engineering News-Record
ENR staff may be contacted at ENR.com@bnpmedia.com

Your “Independent Contractor” Clause Just Got a Little Less Relevant

January 12, 2015 — Garret Murai – California Construction Law Blog
Construction projects are complex, multi-partied, multi-disciplinary endeavors, in which subcontracting all or a portion of the work to be performed is not uncommon. When subcontracting work, parties usually make it clear in their contracts that the party performing work is acting as an “independent contractor.” Here’s a fairly typical provision from the AIA A201 General Conditions:

The parties agree that the contractual relationship on Contractor to Owner is one solely of an independent contractor in all respects and that the Contract Documents do not in any way create a partnership, joint venture or any other relationship between Owner and Contractor other than the contractual relationship as specified in this Agreement.

These provisions are intended to shield the contracting party from claims that it is responsible for workers’ compensation premiums, retirement contributions, health care insurance, or other benefits provided for the benefit of employees of the company performing the work. Fair enough. Read the court decision
Read the full story...
Reprinted courtesy of Garret Murai, Wendel Rosen Black & Dean LLP
Mr. Murai may be contacted at gmurai@wendel.com

Federal Interpleader Dealing with Competing Claims over Undisputed Payable to Subcontractor

September 28, 2017 — David Adelstein - Florida Construction Legal Updates
What do you do if you are holding undisputed money owed to a subcontractor? Well, you make an effort to pay it or tender it! Right? I am never a fan of a client holding undisputed sums without a legitimate contractual basis. There are circumstances, however, where the effort to pay an undisputed payable is not so easy. In fact, it is challenging, as in the below case example where the subcontractor filed for an Assignment for the Benefit of Creditors (referred to as an “ABC”). An ABC, in a nutshell, allows an insolvent entity to file an insolvency action in state court governed by state law and choose its assignee (versus a federal bankruptcy action governed by federal law where a trustee is appointed). One major difference is that there is no automatic stay in an ABC as there is in a federal bankruptcy action. Thus, the insolvent entity can still be sued, but, while that entity is in an ABC, there are many creditors that will not be able to enforce a judgment. (See Florida Statute Ch. 727). Read the court decision
Read the full story...
Reprinted courtesy of David Adelstein, Florida Construction Legal Updates
Mr. Adelstein may be contacted at dadelstein@gmail.com

COLUMBUS OHIO BUILDING EXPERT DIRECTORY AND CAPABILITIES