Cambridge Massachusetts Building Expert Directory

Fixing the Problem – Not the Blame

November 30, 2016 — Curtis W. Martin – Peckar & Abramson, P.C. Bulletin
Who is responsible for defective design under Texas law? The contractor, under Lonergan? The owner, under Spearin? A recent Fifth Circuit decision suggests that in some cases this might be the wrong question when design responsibility is disputed. The appellate court recently remanded a case back to the district court to determine whether the contractor or owner breached an implied duty to cooperate in discovering defects in design and subsequently pricing the change required to correct the problem. Read the court decision
Read the full story...
Reprinted courtesy of Curtis W. Martin, Peckar & Abramson, P.C.
Mr. Martin may be contacted at cmartin@pecklaw.com

Court Clarifies Sequence in California’s SB800

December 20, 2012 — CDJ STAFF
As California’s Right-To-Repair law, SB800, nears its ninth birthday, it has remained “largely untested in the legal system” as noted by Megan MacNee of Wood, Smith, Henning & Berman LLP on the site RealEstateRama. She writes that some homeowners have requested documents prior to filing a claim, which she describes as an attempt to “game the system,” and “analogous to requiring a party to litigation to comply with discovery before a complaint is filed.” The court determined that homeowners may not request documents from the builder until they have actually filed a claim. The court noted that SB800 lacks any clear indication that homeowners may request documents before filing a claim (and also does not indicate that a builder would have to provide documents in these circumstances). The court concluded that the section that sets up the prelitigation procedures occurs before they section on documents discovery. “Because the document request is part of the prelitigation procedure, and the prelitigation procedure does not begin until the homeowner has served notice of a claim, it follows that there can be no prelitigation obligation to produce documents under section 912, subdivision (a) unless the homeowner has commenced the prelitigation procedure by serving notice of a claim.” Read the court decision
Read the full story...
Reprinted courtesy of

CDJ’s #2 Topic of the Year: Ewing Constr. Co., Inc. v. Amerisure Ins. Co., 2014 Tex. LEXIS 39 (Tex. Jan.17, 2014)

December 31, 2014 — Beverley BevenFlorez-CDJ STAFF
Ewing received quite a bit of attention around the blogosphere, and Tred R. Eyerly of Damon Key Leong Kupchak Hastert wrote a nicely succinct case summary on his blog, Insurance Law Hawaii: “In a much anticipated decision, the Texas Supreme Court ruled that a general contractor who agrees to perform its work in a good and workmanlike manner does not "assume liability" for damages arising out of its defective work so as to trigger the Contractual Liability Exclusion.” Read the court decision
Read the full story...
Reprinted courtesy of

Social Engineering Scams Are On the Rise – Do I Have Insurance Coverage for That?

June 01, 2020 — Jeffrey Dennis & Heather Whitehead - Newmeyer Dillion
Cyber attackers all know that the majority of organizations are currently working from home due to the ongoing COVID-19 (commonly referred to as the Coronavirus) pandemic. And, as would be expected, social engineering scams are on the rise. Nonetheless, there may be limitations in your cyber liability insurance policy for these types of claims. It is advisable to take the initiative to review such insurance policies in detail for coverage considerations prior to the occurrence of any cyber incident. And, of course, protect your business from attacks by engaging in precautious cyber safety efforts. What Is Social Engineering? Social engineering refers to various means to manipulate individuals in the online environment so that they divulge sensitive, personal information, such as banking information, which may include account numbers and passwords. This can also take the form of receiving a request to transfer funds to what the victim believes is another employee, trusted financial information or other party with whom the person has a business relationship with. Unfortunately, however, those funds ultimately are received by the engineer of the cyber attack. Reprinted courtesy of Jeffrey M. Dennis, Newmeyer Dillion and Heather Whitehead, Newmeyer Dillion Mr. Dennis may be contacted at jeff.dennis@ndlf.com Ms. Whitehead may be contacted at heather.whitehead@ndlf.com Read the court decision
Read the full story...
Reprinted courtesy of

Wisconsin Court Enforces Breach of Contract Exclusion in E&O Policy

July 21, 2018 — TLSS Insurance Law Blog
In its recent decision in Crum & Forster Specialty Ins. Co. v. GHD Inc.,2018 U.S. Dist. LEXIS 111827 (E.D. Wisc. July 5, 2018), the United States District Court for the Eastern District of Wisconsin had occasion to consider the application of a breach of contract exclusion in a professional liability policy. Crum’s insured, DVO, was sued in connection with its contract to construct a biogas converter mechanism. The underlying suit alleged a sole cause of action; namely, breach of contract based on DVO’s failure to have fulfilled its obligations to design the mechanism to specification. Read the court decision
Read the full story...
Reprinted courtesy of Traub Lieberman Straus & Shrewsberry LLP

Drafting a Contractual Arbitration Provision

February 11, 2019 — David Adelstein - Florida Construction Legal Updates
A recent Florida case discussing a contractual arbitration provision in a homebuilder’s contract discussed the difference between a narrow arbitration provision and a broad arbitration provision. See Vancore Construction, Inc. v. Osborn, 43 Fla.L.Weekly D2769b (Fla. 5th DCA 2018). Understanding the distinction between the two types of arbitration provisions is important, particularly if you are drafting and/or negotiating a contractual arbitration provision. A narrow contractual arbitration provision includes the verbiage “arises out of” the contract such that disputes arising out of the contract are subject to arbitration. Arbitration is required for those claims the have a direct relationship with the contract. Read the court decision
Read the full story...
Reprinted courtesy of David Adelstein, Kirwin Norris
Mr. Adelstein may be contacted at dma@kirwinnorris.com

Disruption: When Did It Start and Where Will It End?

June 25, 2019 — Brian Gallagher - Construction Executive
If change is the only constant—as was famously observed by a Greek philosopher circa 500 B.C.—then why single out some changes as “disruption”? Disruption is about more than just technology; it’s about more, even, than the rapid rollout and development of technology in the past couple of decades. The word disruption refers to processes or products that are fundamentally different from what is currently in use and that render unforeseen, large-scale changes. Early discussions of disruption (the term was coined by Harvard Business School professor Clayton M. Christensen in a 1995 Harvard Business Review article) compared incremental change in existing systems, which are usually supported by established corporations, to innovations that start out as something completely fresh, limited in their appeal and flawed in initial iterations. The construction industry was—and still is—late to adopt most technologies and late in experiencing overall disruption. It also lags behind other industries when it comes to efficiency and productivity. McKinsey reported that construction is one of the “least digitized industries in the world,” despite employing approximately 7% of the world’s working-age population and representing one of the world economy’s largest sectors. Disruption is likely to be fast approaching now, even for the construction industry. But its delay may confer the benefit of allowing construction companies to learn from other industries’ mistakes. Reprinted courtesy of Brian Gallagher, Construction Executive, a publication of Associated Builders and Contractors. All rights reserved. Read the court decision
Read the full story...
Reprinted courtesy of

Coverage Denied for Insured's Defective Product

October 15, 2014 — Tred R. Eyerly – Insurance Law Hawaii
The court found there was no coverage obligations for the insured's defective product. Titanium Indus., Inc. v. Federal. Ins. Co., 2014 WL 4428324 (N.J. Super. Ct. App. Div. Sept. 10, 2014). The insured, Titanium Industries, supplied titanium bar materials to Biomet Manufacturing Corporation. Biomet manufactured orthopedic implants and devises. The titanium was used to manufacture screws to incorporate into Biomet's products. Biomet notified the insured of a potential defect in some of the titanium material, described as "alloy segregation," i.e., the failure of alloys in a metal to completely melt, causing the alloy to separate and undermine the strength of the finished product. The insured and Biomet negotiated a settlement, which included lost profits and the cost of returning the titanium. Read the court decision
Read the full story...
Reprinted courtesy of Tred R. Eyerly, Insurance Law Hawaii
Mr. Eyerly may be contacted at te@hawaiilawyer.com

CAMBRIDGE MASSACHUSETTS BUILDING EXPERT DIRECTORY AND CAPABILITIES