Supreme Court of Washington State Upholds SFAA Position on Spearin Doctrine
September 13, 2021 —
Peter Roth – The Surety & Fidelity Association of AmericaSeptember 9, 2021 (WASHINGTON, DC) –
The Surety & Fidelity Association of America (SFAA) commends the decision of The Supreme Court of The State of Washington to reverse the lower court ruling in the case of Lake Hills Investments, LLC vs. Rushforth Construction Co. As argued by SFAA, the Supreme Court found the contractor should not be responsible for damage caused by the defective design provided by the owner even where the contractor was responsible for certain defective work. In addition, the contractor is not completely barred from asserting this defense if the defects were caused by a combination of deficient performance by the contractor and deficient design, and proportional liability should be determined.
The SFAA, along with the National Electrical Contractors Association Puget Sound Chapter (NECA), Mechanical Contractors Association of Western Washington (MCAWW) and SMACNA-Western Washington (SMACNA), issued an Amici Curiae in support of Petitioner AP Rushforth Construction Co., Inc. d/b/a AP Rushforth, and Adolfson & Peterson, Inc.’s (collectively “AP”) Petition for Discretionary Review. In the brief they argued the Court should grant the Petition because the decision by the lower court is contrary to precedent of limiting a contractor’s liability when the owner’s defective plans and specifications caused the defective work, and upsets settled expectations of allocation of risk and liability between contractors, owners and architects (among others) on construction projects. This allocation of risk and the principle of limiting the contractor’s liability for defective work based on defective plans and specifications is long settled doctrine in Washington State and throughout the country, a doctrine based on the US Supreme Court’s landmark decision in U.S. vs. Spearin more than 100 years ago.
The Surety & Fidelity Association of America (SFAA) is a trade association of more than 425 insurance companies that write 98 percent of surety and fidelity bonds in the U.S. SFAA is licensed as a rating or advisory organization in all states and it has been designated by state insurance departments as a statistical agent for the reporting of fidelity and surety experience. www.surety.org
Read the court decisionRead the full story...Reprinted courtesy of
Peter Roth, SFAAMr. Roth may be contacted at
proth@surety.org
Safe Harbors- not just for Sailors anymore (or, why advance planning can prevent claims of defective plans & specs) (law note)
August 17, 2011 —
Melissa Brumback, Construction Law in North CarolinaHave you ever considered a “Safe Harbor Provision” for your Owner-Architect or Owner-Engineer contract? Maybe it is time that you do.
As you are (probably too well) aware, on every construction project there are changes. Some of these are due to the owner’s change of heart, value engineering concerns, contractor failures, and material substitutions. Some may be because of a design error, omission, or drawing conflict. It happens.
A “Safe Harbor Provision” is a provision that establishes an acceptable percentage of increased construction costs (that is, a percentage of the project’s contingency). The idea is that if the construction changes attributable to the designer is within this percentage, no claim will be made by the Owner for design defects.
Read the full story…
Reprinted courtesy of Melissa Brumback of Ragsdale Liggett PLLC. Ms. Brumback can be contacted at mbrumback@rl-law.com.
Read the court decisionRead the full story...Reprinted courtesy of
“To Indemnify, or Not to Indemnify, that is the Question: California Court of Appeal Addresses Active Negligence in Indemnity Provisions”
April 05, 2017 —
Steven M. Cvitanovic & Omar Parra – Haight Brown & Bonesteel LLPIn California, it is well-established that the extent of a party’s obligation under an indemnity agreement is an issue of contractual interpretation, and it is therefore the intent of the parties that should control. What is the parties’ intent, then, when a subcontractor (indemnitor) agrees to indemnify the general contractor (indemnitee) “except to the extent the claims arise out of the general contractor’s active negligence or willful misconduct”? Does this mean the general contractor is barred entirely from recovering any indemnity if its active negligence contributed to the injury? Not according to the First Appellate District of the California Court of Appeal, which recently held that an actively negligent general contractor may still recover indemnity for the portion of liability attributable to the fault of others. Oltmans Construction Co. v. Bayside Interiors, Inc., No. A147313, 2017 WL 1179391, at *1 (Cal. Ct. App. Mar. 30, 2017).
In Oltmans Construction, an employee of O’Donnell Plastering, Inc. (“O’Donnell”), a sub-subcontractor of Bayside Interiors, Inc. (“Bayside”), which was a subcontractor to Oltmans Construction Company (“Oltmans”), sustained injuries when he fell through a skylight opening in the roof of a building under construction. The employee filed suit against Bayside, Oltmans, and the building’s owner, arguing Oltmans negligently cut and left unsecured the skylight opening. Oltmans subsequently filed a Cross-Complaint against Bayside and O’Donnell, contending it was entitled to indemnification under the governing agreements.
Reprinted courtesy of
Steven M. Cvitanovic, Haight Brown & Bonesteel LLP and
Omar Parra, Haight Brown & Bonesteel LLP
Mr. Cvitanovic may be contacted at scvitanovic@hbblaw.com
Mr. Parra may be contacted at oparra@hbblaw.com
Read the court decisionRead the full story...Reprinted courtesy of
Substituting Materials and Failure to Comply with Contractual Requirements
November 19, 2021 —
David Adelstein - Florida Construction Legal UpdatesIt is important to remember that if you are going to substitute materials from those specified, you need to make sure there is proper approval in doing so–make sure to comply with the contractual requirements to substitute materials. Otherwise, you could be in a situation where you are contractually required to remove the installed substituted materials and replace with the correct specified materials. This is not the situation you want to find yourself in because this is oftentimes a costly endeavor. This was the situation in Appeal-of-Sauer, Inc., discussed below, on a federal project. The best thing that you can do is comply with the contractual requirements if you want to substitute materials. If you are in the situation where it is too late, i.e., you already installed incorrect materials, you want to demonstrate the substituted materials are functionally equivalent to the specified materials and/or come up with an engineering solution, as required, that could be less costly then ripping out the installed material and replacing with the correct material. Even doing so, however, is not a “get out of jail free card” and does not necessarily mean there is not a strong basis to require you to install the correct specified material.
In Appeal of- Sauer, Inc., ASBCA 61847, 2021 WL 4888192 (ASBCA September 29, 2021), a federal project’s engineering requirements required cast iron piping for the above ground sanitary system. However, the prime contractor installed PVC piping instead of cast iron piping. The prime contractor believed it had the appropriate approval through its submittal. The government, through its contracting officer, directed the prime contractor to remove installed PVC piping to replace with cast iron. The government did not believe PVC piping was the functional equivalent of cast iron piping for the above ground sanitary system due to its concern with the noise level of waste materials flowing through the piping. The prime contractor submitted a claim for its removal and replacement costs which was denied by the contracting officer. On appeal with the Armed Services Board of Contract Appeals, the Board agreed with the contracting officer explaining: “While we agree that a design change could be approved by the designer of record and brought to the attention of the government before being incorporated into the design documents, the [prime contractor’s] task order required that such a design change meet the minimum requirements of the solicitation and accepted proposal. The plumbing submittal [the prime contractor] issued here, showing the use of PVC instead of cast iron for the above ground waste piping, did not meet the minimum requirements of the solicitation.” Appeal of-Sauer, Inc., supra.
Read the court decisionRead the full story...Reprinted courtesy of
David Adelstein, Kirwin Norris, P.A.Mr. Adelstein may be contacted at
dma@kirwinnorris.com
Eliminating Waste in Construction – An Interview with Turner Burton
June 29, 2020 —
Aarni Heiskanen - AEC BusinessI had the pleasure of interviewing Turner Burton, President of Hoar Construction. We discussed waste in construction and how his company is on a mission to eliminate it.
Can you say a few words about yourself and your company?
I grew up around construction and this company, hearing about the business from both my grandfather and my father. I started working on job sites in high school forming concrete, continued working on projects throughout college, and since graduating from college, I’ve taken on different roles in the company to ensure I understand all aspects of the business.
Hoar Construction was founded 80 years ago, and throughout our history, we’ve been committed to learning from every project to improve our processes and deliver the best building experience possible for our clients and partners. But it’s the relentless pursuit of improvement that really sets us apart as builders – to always strive to be the best and do the right thing for our customers and partners. There’s something to be said for setting a goal that you’ll always be working toward. It fosters hard work, collaboration, and productive effort. If we’re always working to find a better way, then we will always be improving. That effort drives better results for our owners and everyone we work with. Essentially, we’re always working toward something. Always improving. Always in process.
Read the court decisionRead the full story...Reprinted courtesy of
Aarni Heiskanen, AEC BusinessMr. Heiskanen may be contacted at
aec-business@aepartners.fi
How Long is Your Construction Warranty?
February 26, 2015 —
Craig Martin – Construction Contractor AdvisorThe Nebraska Court of Appeals threw a wrench into the calculation of your warranty earlier this year in Adams v. Manchester Park, LLC and Southfork Homes, Inc. In that case, the court found that the statute of limitations for a warranty claim started running after the homebuilder’s warranty expired. So, the four year breach of warranty statute of limitations did not begin until after the one year homebuilder warranty expired.
In this case, the homeowner purchased a home from Southfork in September, 2007. The purchase agreement provided for a one-year New Home Limited Warranty which covered material defects in workmanship and materials. The homeowner noticed cracks in the drywall and problems with windows within 6 months of the purchase. The builder told the homeowner to keep track of all the problems and they would be fixed at the yearend walk through.
Read the court decisionRead the full story...Reprinted courtesy of
Craig Martin, Lamson, Dugan and Murray, LLPMr. Martin may be contacted at
cmartin@ldmlaw.com
Yellowstone Park Aims for Quick Reopening After Floods
July 03, 2022 —
The Associated Press (Matthew Brown & Amy Beth Hanson) - BloombergGardiner, Mont. (AP) -- Most of Yellowstone National Park should reopen within the next two weeks — much faster than originally expected after record floods pounded the region last week and knocked out major roads, federal officials said.
Yellowstone Superintendent Cam Sholly said the world-renowned park will be able to accommodate fewer visitors for the time being, and it will take more time to restore road connections with some southern Montana communities.
Park officials said Sunday they'll use $50 million in federal highway money to speed up road and bridge repairs. There’s still no timetable for repairs to routes between the park and areas of Montana where the recovery is expected to stretch for months.
Yellowstone will partially reopen at 8 a.m. Wednesday, more than a week after more than 10,000 visitors were forced out of the park when the Yellowstone and other rivers went over their banks after being swelled by melting snow and several inches of rainfall.
Read the court decisionRead the full story...Reprinted courtesy of
Bloomberg
5 Impressive Construction Projects in North Carolina
February 04, 2014 —
Melissa Dewey Brumback – Construction Law in North CarolinaWhat are your top construction building projects in North Carolina? Do you have a “short list”? Author Ralitsa Golemanova of JW Surety Bonds does, and she has the reasoning behind them. Ralista’s Top 5, which all “present a different facet of exceptional modern design and construction” are presented below. For her full commentary and some great pictures of the projects, check out her full article.
Her list, in no particular order, includes:
1. The North Carolina Museum of Art’s West Building Expansion
The 127,000 square-feet West Building Expansion of the North Carolina Museum of Arts won the 2011 American Institute of Architects (AIA) Honor Award for Architecture. The Building is largely made of aluminum panels. One of its specificities is that it does not have any windows. Instead, visibility is ensured through 360 skylights that allow delicate natural light to enter the inner galleries.
Read the court decisionRead the full story...Reprinted courtesy of
Melissa Dewey Brumback, Construction Law in North CarolinaMs. Brumback can be contacted at
mbrumback@rl-law.com
