San Francisco Bucks U.S. Trend With Homeownership Gains
September 24, 2014 —
Prashant Gopal – BloombergHomeownership climbed in a small number of U.S. metropolitan areas last year including San Francisco; Nashville, Tennessee; and Austin, Texas, where strong job growth helped them buck the national trend.
Of 100 metropolitan areas, 17 had an increase in the “true” ownership rate, which measures the number of owner-occupied households per 100 adult residents, according to an analysis by Trulia Inc. of Census Bureau data. Even in those areas, advances were small. San Francisco had the biggest gain in 2013, rising about 0.6 percentage points from a year earlier, the property-information company said today. The Gary, Indiana, region, made up mostly of suburbs, had a similar increase.
The homeownership rate has been falling in much of the U.S. as incomes stagnate and rising prices make housing less affordable and more difficult to finance for entry-level buyers. The regions where the rate is up include strong job markets such as San Francisco and Austin, and areas with stable prices such as Albany, New York, that were spared the brunt of the nationwide foreclosure crisis, Trulia said.
Read the court decisionRead the full story...Reprinted courtesy of
Prashant Gopal, BloombergMr. Gopal may be contacted at
pgopal2@bloomberg.net
10-story Mass Timber 'Rocking' Frame Sails Through Seismic Shake Tests
June 19, 2023 —
Nadine M. Post - Engineering News-RecordA 10-story mass timber “rocking” frame, designed to be resilient enough to withstand powerful earthquakes with little or no structural damage, proved its worth May 9 during seismic simulations at the largest high-performance outdoor shake table, located at the University of California San Diego.
Reprinted courtesy of
Nadine M. Post, Engineering News-Record
Ms. Post may be contacted at postn@enr.com
Read the full story... Read the court decisionRead the full story...Reprinted courtesy of
Grad Student Sues UC Santa Cruz over Mold in Residence
November 13, 2013 —
CDJ STAFFMatthew Richert, a graduate student at UC Santa Cruz, and his wife have filed a lawsuit against UC Santa Cruz, alleging the residence they rented from the university was contaminated with mold, causing problems for them and their children.
The family noticed the signs of mold on the walls, but did not initially connect it with their daughter’s health problems, until they mentioned it to their doctor. The doctor sent a letter to the university requesting that the family be transferred to another unit if the mold problem could not be remedied. Mr. Richert made five such requests.
Eventually the university moved the family to a hotel as they investigated the unit. The Richert’s unit remains unoccupied, and a Santa Cruz spokesperson noted that 60 of the units showed mold problems.
Read the court decisionRead the full story...Reprinted courtesy of
A Relatively Small Exception to Fraud and Contract Don’t Mix
April 01, 2015 —
Christopher G. Hill – Construction Law MusingsRemember all of my posts about how fraud and contract claims don’t usually play well in litigation? Well, as always with the law, there are exceptions. For instance, a well plead Virginia Consumer Protection Act claim will survive a dismissal challenge.
A recent opinion out of the Alexandria division of the U. S. District Court for the Eastern District of Virginia sets out another exception, namely so called fraudulent inducement. In XL Specialty Ins. Co. v. Truland et al, the Court considered the question of whether both a tort and contract claim can coexist in the same lawsuit when the tort claim is based upon the information provided to the plaintiff when that information proves false.
As the courts of Virginia have held for years, only certain information and statements made pre-contract can be the basis for a fraud claim in the face of a contractual duty to perform. One type of statement that is not properly the subject of a fraud in the inducement type claim is sales talk or opinion. Such sales talk (for example claiming that your company is the best for the job) is not the subject of a fraud claim because it is not meant to be relied upon and that such talk is an opinion about future performance, not a false statement of present fact or intent.
Read the court decisionRead the full story...Reprinted courtesy of
Christopher G. Hill, Law Office of Christopher G. Hill, PCMr. Hill may be contacted at
chrisghill@constructionlawva.com
Hawaii State Senate Requires CGL Carriers to Submit Premium Information To State Legislature
March 20, 2011 —
CDJ STAFFIn light of the decision in Hawaii’s Intermediate Court of Appeals in Group Builders, Inc.,v. Admiral Insurance Company, 231 P.3d 67(2010), Hawaii’s state senate is requesting that "every domestic and foreign insurance company that has ever issued commercial general liability policies in the State is requested to submit information to the Legislature on the total premiums received for their commercial general liability policies during the past ten years"
Read Full Text of Hawaii State Senate Resolution
Read the court decisionRead the full story...Reprinted courtesy of
Flag on the Play! Expired Contractor’s License!
October 02, 2015 —
Yas Omidi – California Construction Law BlogIt’s football season again. Which means, of course, that in addition to touch downs and field goals, you’ll also see hooting and hollering when the ref throws down a yellow flag signaling that a foul has been committed.
In Judicial Council of California v. Jacob Facilities, Inc., Case Nos. A140890, A141393 (August 20, 2015), The California Court of Appeals for the First District threw down its own yellow flag under the dreaded Business and Professions Code section 7031, finding that a contractor was required to disgorge all monies received on a project – to the tune of a whopping $18 million – when its parent company allowed the subsidiary’s contractor’s license to lapse when it rebranded a new company to perform the work of the old company but never formally assigned the contract. I think someone in marketing may be in big trouble.
Read the court decisionRead the full story...Reprinted courtesy of
Yasmeen, Omidi, Wendel Rosen Black & Dean LLPMs. Omidi may be contacted at
yomidi@wendel.com
10 Safety Tips for General Contractors
October 09, 2018 —
Eric Weisbrot – JW Surety BondsThe construction industry continues to grow each year, paving the way for general contractors to make a profitable, sustainable living when the job is done right. However, to do so effectively, safety standards need to be met with consistency and focus on each worksite. General
contractors who are licensed and bonded must take proactive steps to avoid potentially fatal injuries among their subcontractors and employees, even though this may be easier said than done. To create and maintain a safe worksite each and every time, general contractors should consider how to implement the following best practices and safety tips on the job.
1 – Know the Risks
The most crucial step toward maintaining a safe construction site is to first be aware of the risks involved. Each year, thousands of
construction workers experience injuries on the job, and some ultimately lose their life because of safety missteps at work. As a general contractor, it is your responsibility to know that construction risks run rampant given the nature of the work. Being tuned into the potential for falls, slips, and other common safety-related incidents is a necessary part of operating a safe worksite for you and your employees.
2 – Require Protective Gear
An often overlooked safety precaution on construction sites is the use of up-to-date and well-maintained protective gear. For many subcontractors and employees, it is easy to skip this necessary step in safeguarding themselves from potential safety issues. However, general contractors can take steps to make protective gear a requirement on the job. This may include mandating hardhats and steel-toed shoes, gloves, and eyewear when appropriate. All visitors and workers on a construction site should follow protective gear instructions to avoid unnecessary safety risks.
3 – Educate on Ladder Safety
According to the Bureau of Labor Statistics, ladder injuries account for a significant number of construction worker incidents each year, making up more than 200,000 accidents on average. Ladders have continuously ranked high on OSHA’s list of violations at construction sites because the prevalence of injuries is so high. General contractors can help thwart ladder-related injuries among workers by promoting ladder safety training, including reminders about the right ladder to use for each task. Workers should also be well aware of the importance of inspection before use, and they should always follow the three points of contact rule when going up or down a ladder.
4 – Recognize Equipment Pitfalls
Many construction workers experience injuries relating to equipment used on the job. This could be tied to getting on or off equipment, or loading and unloading materials from machinery. In any case, general contractors can encourage simple tactics to improve equipment safety measures. Paying close attention to secure footing while getting on or off a machine, having more than one person assist with loading and unloading, and ensuring everyone feels comfortable asking for help with these tasks reduces safety risks.
5 – Document Potential Hazards
A general contractor’s main responsibility is to manage the construction site efficiently from start to finish. Part of this duty is recognizing the possible issues on a worksite that may lead to accidents or injuries if not addressed at the beginning of a project. It is necessary to take the time to identify safety risks such as unstable working surfaces, dangerous trenches, or weather-related concerns that may impact the safety of subcontractors, suppliers, or other site visitors. Potential hazards should be documented and shared with site workers, and they should be updated as the project progresses.
6 – Maintain Equipment and Tools
Poorly maintained equipment and tools also cause issues on construction sites. The Infrastructure Health and Safety Association suggests that general contractors
remind workers to inspect tools, machines, handheld equipment, and vehicles before each use to ensure they are properly maintained. Additionally, understanding the maintenance standards for certain tools or equipment and following those guidelines is crucial to reducing injury on the job.
7 – Minimize Crowds
Crowded work areas can be a serious safety issue for general contractors, subcontractors, and vendors and suppliers on site. It is common for crowds to gather during the use of heavy equipment or when a significant task is being completed. However, general contractors should discourage crowd-forming for spectating purposes. This can be done by limiting the number of people allowed to be in an area when certain activities are taking place, and enforcing these rules at every possible opportunity.
8 – Hire Licensed Subcontractors
General contractors may have full- or part-time employees as part of their business model, or there may be a heavy presence of subcontractors not directly tied to the main business. In either case, it is essential to have faith in the capabilities of workers, including their willingness and commitment to follow safety standards. General contractors can help ensure each worker is more likely to take safety seriously when they hire licensed contractors who follow through with
licensing requirements as mandated by the state or city.
9 – Focus on Training
Even after vetting subcontractors and employees based on their licensing status, general contractors also need to ensure training and education are a priority. Several online and in-person courses focus on construction safety training which workers should be encouraged to attend. Safety
education programs from OSHA and other reputable sources are crucial to decreasing accidents on the job.
10 – Be Present
Finally, general contractors can only have an impact on the safety of the job site when they are purposefully present. It is common for some GCs to stop by a project when they are needed or to check on progress periodically. However, new safety hazards, lacking worker training, and other risks are not easily fixed when the general contractor is not consistently on site. Reducing the potential for falls, slips, trips, and fatalities on the job requires communication with workers, and that takes place most effectively when general contractors are in person.
Eric Weisbrot is the Chief Marketing Officer of JW Surety Bonds. With years of experience in the surety industry under several different roles within the company, he is also a contributing author to the surety bond blog.
Read the court decisionRead the full story...Reprinted courtesy of
Formaldehyde-Free Products for Homes
March 05, 2015 —
Beverley BevenFlorez-CDJ STAFFBuilder Magazine reported that builders are “making indoor air quality a major concern,” including choosing healthier, formaldehyde-free products.
Builder explained the problems with certain chemicals: “Formaldehyde and other VOCs, most frequently found in wood products, finishes, and paints, have been chief among the pollutants targeted for potentially dangerous health effects, such as respiratory issues and irritation of the eyes, nose, throat, and skin.”
Read the court decisionRead the full story...Reprinted courtesy of
